SAFETY GUIDELINES
4
TDS-G200VLDB
8.
DO NOT FORCE THE TOOL
to perform an
operation for which it was not designed. It
will do a safer and higher quality job by only
performing operations for which the tool
was intended.
9. WEAR PROPER CLOTHING.
DO NOT
wear loose clothing, gloves,
neckties, or jewelry. These items can get
caught in the machine during operations and
pull the operator into the moving parts.
The user must wear a protective cover on
their hair, if the hair is long, to prevent it from
contacting any moving parts.
10.
CHILDPROOF THE WORKSHOP AREA
by removing switch keys, unplugging tools
from the electrical receptacles, and using
padlocks.
11.
ALWAYS UNPLUG THE TOOL FROM THE
ELECTRICAL RECEPTACLE
when making
adjustments, changing parts or performing
any maintenance.
12.
KEEP PROTECTIVE GUARDS IN PLACE
AND IN WORKING ORDER.
13. AVOID ACCIDENTAL STARTING.
Make
sure that the power switch is in the “OFF”
position before plugging in the power cord
to the electrical receptacle.
14.
REMOVE ALL MAINTENANCE TOOLS
from the immediate area prior to turning“ON”
the Bench Grinder.
15.
USE ONLY RECOMMENDED ACCESSORIES.
Use of incorrect or improper accessories
could cause serious injury to the operator and
cause damage to the tool. If in doubt, check
the instruction manual that comes with that
particular accessory.
16.
NEVER LEAVE A RUNNING TOOL
UNATTENDED
. Turn the power switch to the
“OFF” position. DO NOT leave the tool until
it has come to a complete stop.
17.
DO NOT STAND ON A TOOL.
Serious injury
could result if the tool tips over, or you
accidentally contact the tool.
18.
DO NOT
store anything above or near the
tool where anyone might try to stand on the
tool to reach it.
19.
MAINTAIN YOUR BALANCE. DO NOT
extend
yourself over the tool. Wear oil resistant rubber
soled shoes. Keep floor clear of debris, grease
and wax.
20.
MAINTAIN TOOLS WITH CARE.
Always keep
tools clean and in good working order. Keep
all blades and tool bits sharp, dress grinding
wheels and change other abrasive accessories
when worn.
21.
EACH AND EVERY TIME, CHECK FOR
DAMAGED PARTS PRIOR TO USING THE
TOOL.
Carefully check all guards to see that they
operate properly, are not damaged, and
perform their intended functions. Check for
alignment, binding or breaking of moving parts.
A guard or other part that is damaged should
be immediately repaired or replaced.
22.
DO NOT OPERATE TOOL WHILE TIRED, OR
UNDER THE INFLUENCE OF DRUGS,
MEDICATION OR ALCOHOL.
23.
SECURE ALL WORK.
Use clamps or jigs to secure the work piece.
This is safer than attempting to hold the work
piece with your hands.
24.
STAY ALERT, WATCH WHAT YOU ARE
DOING, AND USE COMMON SENSE WHEN
OPERATING A POWER TOOL.
A moment of inattention while operating
power tools may result in serious personal
injury.
25.
ALWAYS WEAR A DUST MASK TO PREVENT
INHALING DANGEROUS DUST OR AIRBORNE
PARTICLES,
including wood dust, crystalline
silica dust and asbestos dust. Direct particles
away from face and body.
Always operate tool in well ventilated area
and provide for proper dust removal. Use
dust collection system wherever possible.
Exposure to the dust may cause serious and
permanent respiratory or other injury,including
silicosis (a serious lung disease), cancer, and
death. Avoid breathing the dust, and avoid
prolonged contact with dust.
Allowing dust to get into your mouth or eyes,
