Toro 260 series Manual

The Toro Company – 1998

FORM NO. 3321–862

SET UP

INSTRUCTIONS

LAWN & GARDEN TRACTOR

260 Series

Loose Parts

Note: Use the chart below to identify parts for assembly.

DESCRIPTION QTY. USE

Bolt 1/4–20 x 3/4”

Washer

Locknut 1/4–20

2Attach battery cables.

Key 1 Use in ignition switch.

Operator’s Manual 1 Read manual before operating tractor.

Check Tire Pressure

Check front and rear tire pressure. See Operator’s

Manual for specification.

Pressure: 20 psi (138 kPa) front and rear.

Activate the Battery

Bulk electrolyte with 1.260 specific gravity must be

purchased from a local battery supply outlet.

1. Remove the battery from the tractor: refer to

Operator’s Manual, Removing the Battery.

IMPORTANT: Be careful not to damage the

long vent tube when removing the battery

box.

POTENTIAL HAZARD

•Battery electrolyte contains sulfuric acid

which is a deadly poison and it causes

severe burns.

WHAT CAN HAPPEN

•If you carelessly drink electrolyte you could

die or if it gets onto your skin you will be

burned.

HOW TO AVOID THE HAZARD

•Do not drink electrolyte and avoid contact

with skin, eyes or clothing. Wear safety

glasses to shield your eyes and rubber

gloves to protect your hands.

•Fill the battery where clean water is always

available for flushing the skin.

•Follow all instructions and comply with all

safety messages on the electrolyte container.

Set Up Instructions

2. Remove filler caps from the battery. Slowly pour

electrolyte into each cell until the electrolyte

level is up to the lower part of the tube (Fig. 1).

1262

Figure 1

1. Filler caps

2. Electrolyte 3. Lower part of the tube

3. Leave the covers off and connect a 3 to 4 amp

battery charger to the battery posts (Fig. 2).

Charge the battery at a rate of 4 amperes or less

for 4 hours (12 volts).

1254

Figure 2

1. Positive post

2. Negative post 3. Charger red (+) wire

4. Charger black (–) wire

POTENTIAL HAZARD

•Charging battery produces gasses.

WHAT CAN HAPPEN

•Battery gasses can explode.

HOW TO AVOID THE HAZARD

•Keep cigarettes, sparks and flames away

from battery.

4. When the battery is fully charged, disconnect the

charger from the electrical outlet then from the

negative and positive battery posts (Fig. 2).

5. Slowly pour electrolyte into each cell until the

level is once again up to the “UPPER” line on

the battery case (Fig. 1) and install covers.

6. Install the battery in the tractor and connect

cables with (2) 1/4 x 3/4” bolts, (2) washers and

(2) 1/4–20 locknuts: refer to the Operator’s

Manual, Installing the Battery.

Set Up Instructions

Fill Crankcase with Oil

IMPORTANT: The tractor is shipped from

the factory without oil in the engine crankcase

Refer to the Operator’s Manual, Engine Oil

Specifications for oil type, viscosity, and crankcase

capacity. Only add about 80% of the specified amount

of oil. Then check the oil level and add only enough

oil to raise the level to the “FULL” mark on the

dipstick.

Note: When checking oil, slide the dipstick

fully into the filler tube, do not thread

onto fill tube.

Lubricate the Tractor

Refer to the Operator’s Manual, Greasing and

Lubrication.

If equipped with Power Lift, check reservoir level. If

necessary, fill to bottom of filler opening with Dexron

Type II

Check Safety System

Refer to the Operator’s Manual, Checking Safety

System.

Electric Clutch Break-In

The electric clutch requires initial break-in to seat the

mating surfaces. Engage/disengage the clutch 10-20

cycles with the mower installed. Rotating the blades

provides load for break-in.

Adjust Electric Clutch

The electric clutch has three (3) adjustment nuts that

all must be adjusted the same (Fig. 3).

1. Insert a 0.010 inch (.25 mm) feeler gauge into

the slot (Fig. 3).

2. Turn the nut until light resistance is felt on the

gauge.

3. Repeat for all three adjusting nuts.

m–3159

Figure 3

1. Slot

2. 0.010” (25 mm) Feeler

gauge

3. Adjusting nut

Test Drive the Tractor

Make sure all electrical and mechanical systems are

operating properly.

Otros manuales para 260 series

Otros manuales de Tractor de Toro

Toro

Toro 55200 Manual de operación

Toro

Toro Wheel Horse 520xi Manual de usuario

Toro

Toro Groundsmaster 7200 Series Manual de usuario

Toro

Toro Groundsmaster 300 Series Manual

Toro

Toro Reelmaster 5610 Manual de usuario

Toro

Toro 04591 Manual de usuario

Toro

Toro D Series Manual de usuario

Toro

Toro 03781 Manual de usuario

Toro

Toro Reelmaster 2000-D Manual de usuario

Toro

Toro Outcross 9060 Series Manual de usuario

Toro

Toro 8886 Manual de usuario

Toro

Toro 260 series Manual de usuario

Toro

Toro 68037G Manual de usuario

Toro

Toro 8886 Manual de usuario

Toro

Toro 79114 Manual de usuario

Toro

Toro Reelmaster 7000-D Manual de usuario

Toro

Toro Greensmaster eFlex 2120 Series Manual de usuario

Toro

Toro Reelmaster 5010- H Manual de usuario

Toro

Toro 25450 Manual de usuario

Toro

Toro Wheel Horse 73560 Manual de usuario

Toro

Toro 25430 Manual de usuario

Toro

Toro 25450W Manual de usuario

Toro

Toro WorkmanR e2050 Manual de usuario

Toro

Toro 25430A Manual de usuario

Manuales populares de Tractor de otras marcas

Ariens

Ariens 936051 Manual de usuario

MacDon

MacDon M150 Manual de usuario

Belarus

Belarus 3522.5 Manual de usuario

CARRARO

CARRARO Vigneto Manual de usuario

Cub Cadet

Cub Cadet 3208 Manual de usuario

GREMO

GREMO 1250F Manual de instrucciones

HATTAT

HATTAT A90 Manual de usuario

Kubota

Kubota WSM STV32 Manual de instrucciones

Kubota

Kubota M108DC Manual de usuario

Case

Case 385 Diesel Guía de instalación

AL-KO

AL-KO Heritage RS 14/82 Manual de usuario

Webb

Webb WE1742SD Manual de usuario

MacDon

MacDon 9250 Manual de usuario

MASSEY FERGUSON

MASSEY FERGUSON 5400 Series Manual de usuario

Kubota

Kubota T1880 Manual de usuario

Case

Case JX 90 Manual de usuario

Iseki

Iseki TXG23 Manual de usuario

New Holland

New Holland T4.80V Manual de usuario