Short manual torbo S080 to torbo M120 Page 6
5. Setting
Pic. 32
Pic. 33
32. set blasting media at handwheel „S“
set extra water at handwheel „Z“, to increase
the water-proportion in the blasting mixture (for
soft cleaning – extra equipment)
(see chapter „3. Information for Practice in the
manual“)
33. wear necessary and leagal working clothes.
Pic. 34
34. start the machine and set the blasting pressure
at the handle bar.
(see chapter „3. Information for Practice in the
manual“)
ATTENTION: read first the chapter „6. start
blasting” and „7. stop blasting“.
INFO: setting of the blasting pressure is only
possible during blasting.
the pressure is shown at the gauge next to the
handle bar.
6. Start blasting
Pic. 35
Pic. 36
35. fix the magnet of the remote control always
securely at the wrist.
36. have a secured hold at blasting lance (blasting
nozzle with blasting hose and remote control)
and put magnet on the position at the remote
control.
to start: press the push-button
ATTENTION: the higher the blasting pressure
is, the higher is the back pressure at the
nozzle!
7. Stop blasting
7.1. Short stop
Pic. 37
Pic. 38
37. to stop: remove magnet from remote control.
38. ATTENTION: If necessary, the machine can
also be swiched off by pushing the
EMERGENCY-OFF switch!
