5.2 Transportation, installation and assembly
Be careful of the collision when moving the machine:
Handling work can only be conducted by qualified professionals.
When moving, the machine should be placed on a wooden base and moved by
forklift.
To locate, install and connect electricity according to the installation diagram provided by
the manufacturer.
Please take care of the furniture close to the machine door because a small amount of
steam or water droplets may overflow from the machine door
The machine installed should be calibrated in the horizontal and vertical directions by level
tester.
Please use corrosion-resistant chemical, when adding machine parts. (Such as silica gel)
5.3 Operation condition
The machine label indicates the specification of the products, please confirm that the
power standards confirm to the requirements of the machine.
The conditions the client must provide;
* Frost-free storage environment and installation area
* Conform to the national drinking water pipes standard
* Conform to the national wastewater discharge standard
* Conform to the national power connection standard
5.3.1 Storage and installation area
If the machine is stored or installed in the temperature below zero, after washing, make
sure that the washing water is completely released or the frozen water in the machine will
seriously damage the internal parts such as pumps, solenoid valves , heaters an so on.
5.4 Necessary electronic connection conditions
Electrical connections can only be done by the professional and the machine
nameplate posted on the right down side in the front panel.
The equipment must be equipotent bonded at the interface.
Electrical schematic placed in the main washing basket of the washing tank and
safekeeping the schematic diagram to facilitate maintenance.
When connecting the machine power, please abide by the electrical workflow.
The machine should connect the electricity according to the right power source
specification, the wire connection example is interpreted according to (380V 50HZ
three-phase ac) the three phase connection, other voltage specifications should be
connected in accordance with the electrical schematic.
The machine need to choose different adapter in different region (for example, in Taiwan is
60HZ).
Leakage protection circuit breaker should be installed in the outside. Circuit breaker
specifications: single-phase 60Atwo stage with leakage protection.
The machine has five power connecting terminals （L1, L2, L3 ,N, PE）,L phase wire ,N
Naught wire ,PE grounding line.
When connecting the power, please keep grounding line above 5cm longer to ensuring
current-carrying wire disconnect the power when under tension.
Please ensuring PE grounding line is yellow and green, N Naught wire is blue, L1 the main
power line black. (note: because the manufacturer is different, the color of the line is
different, when the connection is important to open the electrical box to distinguish between
the rear can be connected to take earth leakage protection circuit breaker; equipment
damage due to wiring, factory will not be warranty.)
The power supply cord should be 4 mm², oil-resistant and flexible sheathed cord not lighter
than ordinary neoprene sheathed.
