10
The Suplex 4 is a fully proportional 4 function 35Mhz
transmitter and requires 8 off AA size dry cells or
high capacity Nimh batteries to be inserted before
operation. Remove the rear cover and install
batteries as directed by the moulded in polarity (+ &
-) markings.
Battery state is indicated by a light and buzzer.
Fresh batteries or a full charge gives 12 V and a
continuous power on light.
At 8.8V the indicator flashes every 1 second
combined with an audible warning buzzer at 1
second intervals. At this stage the model should be
landed to allow replacement of batteries.
Continued use to 8.3V low voltage gives a 0.5
second flashing light and 1 second buzzer. The
model should be landed immediately to replace
batteries before all control is lost.
Switch 1 (A) provides a dual rate function to rudder,
elevator and aileron.
100% servo movement is available in the Rev (up)
position, ‘Hi Rates’.
Servo movement is electronically reduced in the Nor
(down) position, ‘Low Rates’.
Switch 2 (B) provides an electronic mix function of
aileron to elevator, channels 1 and 2 that is ideal for
delta or flying wing aircraft.
The mix is active with the switch in the Mix 1/2 (up)
position.
Set the transmitter with the switch in the A-Nor
(down) position to inhibit the mix.
Switches 3 to 6 (C, D, E & F) are electronic servo
reversing switches, these should be adjusted to give
the correct control surface deflections relative to
stick movements.
SECTION 3: TRANSMITTER
A small panel of six small slide switches is set on
the front panel of the transmitter. These are labeled 1
to 6 (A to F).
