- 2 -
1.5.1 Personal Safety
• Always connect the product to a grounded circuit to avoid the risk of electrocution.
• Make sure that children, unauthorized people and animals do not obtain access to the machine.
1.5.2 Mounting and Rigging
• The product is for indoor use! To prevent risk of fire or shock, do not expose the product to rain or
moisture.
• CAUTION: When transferring product from extreme temperature environments, (e.g. cold truck to warm
humid ballroom) condensation may form on the internal electronics of the product. To avoid causing a
failure, allow product to fully acclimate to the surrounding environment before connecting it to power.
• Do not mount the product on a flammable surface (linoleum, carpet, wood, paper, carton, plastic, etc.).
• Do not use in a confined space. Always install the product in a location with adequate ventilation, at least
20 in (50 cm) from adjacent surfaces.
• Be sure that no ventilation slots on the product’s housing are blocked.
• when hanging, please use the safety cables to fix four safety loop on the top cover and two handles on
side cover.
1.5.3 Power and Wiring
• Always make sure that the voltage of the outlet to which you are connecting the product is within the
range stated on the decal or rear panel of the product.。
• Make sure the power cord is not crimped or damaged.
• Do not connect the machine to the dimming controller or rheostat.
• Never disconnect the product from power cord by pulling or tugging on the cord.
• To eliminate unnecessary wear and improve its lifespan, during periods of non-use completely
disconnect the product from power via breaker or by unplugging it.
1.5.4 Installation Instructions
• Do not operate this product if you see damage to the housing or cables. Have the damaged parts
replaced by an authorized technician at once.
• Make sure there are no flammable materials close to this product while it is operating.
• Do not cover or plug the output nozzle during operation.
• Do not cover the ventilation slots when operating to avoid internal overheating.
• Wipe up spitted fluid immediately. Moisture – also fluid – can destroy the electric.
• Never carry the product by the power cord or any moving part. Always use the handles.
• Empty the storage bin before transporting the product.
• The maximum ambient temperature (Ta) is 104 °F (40 °C). Do not operate the product at higher
temperatures.
• Drain the tank before transporting the product. Bubble fluid or the fog fluid tanks shall be used for the
relevant fluid only.
• Always disconnect the product from the power source before cleaning.
