TONE Factory | Manual EN
1. Remove the cover from the package and remove the pro-
tective foil from both sides.
2. Screw in both hinges to the back of the turntable.
3. Insert the damping pads on the front edge of the cover.
4. Carefully slide the cover into the hinges.
7. Technical Data
Turntable Specs
Nominal speeds: 33/45 r.p.m. (electronic change)
Speed variance: 33: ±0.75 % 45: ±0.65 %
Wow and utter: 33: ±0.22 % 45: ±0.17 %
Signal to noise: -68dB
Eective tonearm mass: 6g
Eective tonearm length: 8.6“ (218.5mm)
Tracking force: 17.5mN pre-adjusted
Overhang: 18mm
Power consumption: 3W/ 0.3W standby mode
Output: RCA Line, Bluetooth
Outboard power supply: 15V/0.8 A DC, 110 – 240V/50 –
60Hz, universal power supply
Dimensions (W x D x H): 360 x 360 x 54mm,
with dustcover 360 x 360 x 85mm
Weight: 2.8 kg / 3.5kg with dustcover
Bluetooth
Maximum transmit power per operated frequency band:
Class II, 2.5mW (4dBm) per 2.4GHz – 2.48 GHz
Technical specications built in MM phono pre-amplier
Gain: 37dB
Output voltage typically: 300mV/1kHz at 4mV/1kHz input
Input impedance: 47kohms/100pF
Noise oor: >68dB
RIAA-equalisation curve accuracy: 20Hz-20kHz / max. 0,5dB
Power consumption: 2W
8. Potential incorrect use & fault conditions
Tone turntables are manufactured to the highest standards
and undergo strict quality controls before leaving the facto-
ry. Faults that may possibly occur are not necessarily due to
material or production faults but can sometimes be caused
by incorrect use or unfortunate circumstances. Therefore the
following list of common fault symptoms is included.
The platter doesn‘t turn although the unit is switched on:
• The unit is not connected to the mains power supply.
• No mains at the socket.
• Drive belt is not tted or has slipped o.
No signal through one or other channel or both channels:
• Bluetooth speaker / Headphones not switched on / out of
battery.
• Amplier not switched on.
• Amplier or speakers defective or muted.
• No connection to the loudspeakers.
Distorted/inconsistent sound from one or both channels:
• Record player is connected to wrong input of amplier, or
MM/MC switch incorrectly set.
Hinge
Damping-Pad
Hinge
Screw
Tool
