２
●Use only parts designated by Tohnichi for repair of the torque driver.
Ask the place of purchase or our campany for assistance when you repair,
and use only Tohnichi parts.
Precautions for use
３
●Conrm that the driver is set according to the correct unit of mesure
before using. (kgf･cm, kgf･m, N･m, etc. )
●Don't use torque driver in fresh water or sea water.
The inside machanism will go bad and cause an accident or injury. If you
drop in water or sea water, ger it cheched out or repaired.
●Use the correct bit that ts the screw, you are using.
Select the bit from the table for bits.
●Perform regular inspections for function and accuracy.
Periodical inspections are essential to insure the torque driver is in optimal
condition thus preventing injury.
●Remove any dirt such as dust, mud, oil and water, ets. after each use
and before storing torque drivers.
●When storing the torque drivers for a long time, keep in a dry place.
If improperly stored, the accuracy and durability will decrease rapidly.
●Note the following point when you attach or detach a bit or a socket.
Hold the shaft as shown, when you attach or detach a bit or a socket.
SHAFT GRIP
※If you hold the grip when you attach or detach a bit or a socket, FTD
might be broken.
■
TOHNICHI TORQUE DRIVERS FTD SERIES
