Toaster Labs Pulse Manual de usuario
Pulse™ and Pulse Pods™ are Trademarks
of Toaster Labs, Inc.
Patent Pending
Made in the USA
Toaster Labs, Inc.
2212 Queen Anne Avenue Noh
Suite 269
Seale, WA 98109
Telephone: 206.402.3220
Website: lovemypulse.com
©2015 Toaster Labs, Inc. All rights reserved.
Pod Chamber Control
Open / Eject Buon
Drop Dish
Power Po
Brightness Slider
Moodlight Control
Activation Beam
1. Pulse Set-up
Remove the Pulse, the Pulse Pods and place on a firm, level suace.
Plug your Pulse Warming Unit into a nearby electrical outlet.
2. Inseing a Pulse Pod
Select a Pulse Pod and remove the cap. Press the Open/Eject Buon
to open the Pod Chamber Door. Inse Pulse Pod with prongs facing up.
Press down on the Pod Chamber Door to close.
4. Dispensing Lubricant
Slide your fingers through the invisible activation beam and hold for 2 seconds.
The Pulse Warmer will deliver a pre-measured poion of warmed lubricant.
Lubricant stays warm while white light is steady.
Press the Power Control to begin warming the Pulse Pod. The pulsing white
light indicates the Pod is warming. Warming time is approximately 3-4 minutes.
The white light is steady when Pod is ready.
3. Heating the Pulse Pods
Power Control
6. Removing the Pulse Pod
Make sure the Power Control light is off. Press the Open/Eject Buon.
Remove the Pulse Pod. Replace Pod cap or discard if empty.
1 See Locking and Unlocking. 2 See Troubleshooting on the Product Manual Brochure.
White
(constant)
Lubricant is
warmed and
ready
White
(pulsing)
Lubricant is
warming
Amber
(flashes)
Only 1 poion
of lubricant
remains
Blue
(pulsing)
Unit is locked
and will not warm
or dispense
lubricant1
Red
(constant)
The Pod is empty
Red
(pulsing)
Pulse Warmer
error2
5. Power Control Cues
The Pulse Warming unit has been designed for ease-of-use with
various LED lighting cues to communicate to you about ceain functions.
8. Locking and Unlocking
The Pulse Warming Unit can be locked for safety.
To lock, press and hold down the Power Control Buon until a blue light flashes.
To unlock, press and hold down the Power Control Buon until the blue light disappears.*
*Your Pulse will automatically turn-off one hour aer last use.
7. Mood Light
Mood light has 6 colors to match your mood. Tap the Mood Light Control
to turn on light. Press and hold to find the Mood Light you want. Glide your fingers
up or down spine to adjust brightness. Tap the Mood Light Control to turn off.
Brightness Slider
Moodlight Control
Tabla de contenidos
