Second, the key function introduction:
Short press + or - key to change speed state,press + key is used to
increase the maximum speed of the vehicle,press - key is used to r
educe the maximum speed of the vehicle,the default speed third gear,
the 1 slowest, 3 fastest。
Parameter numerical modification:
Access parameter is set to meet, transferred to want to adjust the
parameters, through the + key and - key to increase or reduce the
value of parameter, confirm the change after long press the + key
and - key to exit the parameter settings, shut down, restart that modify
the parameters to complete。
4、The turn adjusting motor speed, from top to bottom toggle, motor
speed increase;Loosen the turn speed to zero。
5、If the display have a light function,long press – key to open the light。
4 . Speed display area
Unit MPH, KM/H
Speed signal from the Holzer signal in the motor, the controller send
instrument,
(A single Holzer cycle time,单位: 1MS)
The instrument according to the wheel diameter and signal data(Holzer
also need to set the number of motor magnetic steel),Calculate the
actual speed
5. Parameter setting and definition
P01: The backlight brightness, 1 levels of the dark, the 3 level is the
brightest;
P02: Distance unit, 0:KM; 1:MILE;
P03: Voltage grade: 24V, 36V, 48V, default 36V;
P04: Sleep time:0, Don't sleep; Other figures for the sleep time,
Range: 1-60;Unit minutes;
P06: Wheel diameter:Unit,inch; Precision:0.1;
P07: Speed magnetic steel number: Range:1-100;
P09: Zero start, non-zero start up settings,0:Zero start;1:non-zero start;
P12: Starting torque: Range:0-5,0 The weakest, 5 The strongest;
P14: Controller for limiting value setting default 12A Range:1-20A;(Need
controller software support)
P15: Maximum speed set to slow gear vehicle, fast file does not work;
ODO: ODO reset (Long press – or + button for 5-6 seconds reset)
1、Shut down state, short press key to boot,short press the key,
interface switching between ODO, TRIP, RM, TM, ERRO;
2、The boot state,long press key to shut down;
3、Long press + and - key to enter the mode setting,
in the setting of interface, short press key to switch parameter;
Note: the part of the parameter is set, the shutdown restart to take effect.
PS: Because the company product upgrade products may display content
of the part you get will differ with the instructions, but will not affect your
normal use。
www.tne-scooter.com www.tne-group.net
