3）To stop recording, momentarily press the “Record/Stop” button again, The red light will flash
rapidly and go off, your video is stopped and saved automatically. After saving, the green indicator
light will remain on for 6 seconds. If you want to continue shooting video, momentarily press the
“Record/Stop” button once more.
Note:
a. Please make sure that a Trans-flash (Micro SD) card has been inserted into the side slot, if not,
the green light will repeatedly flash and the camera will power off automatically after 6 seconds.
b. The maximum capacity of Trans-flash SD card is 8GB.
c. Saving a file takes a few seconds after you stop recording, please wait until the red light goes
out before initiating a new video.
d. For best color and clarity insure there is ample even lighting and maintain a distance of at
least 2 inches – (5 cm). This will insure that the video will be in focus and have natural colors.
e. IMPORTANT: Leave the power button switched on to maintain the correct day and time.
(See Setting Time below.)
3. Shooting Still Images – Photo Mode
Insure that the “ON/OFF” button is set to “ON”, and move the ‘Video/Photo” button to the
“Photo” position. Momentarily pres the “Record/Stop ” button to wake up the camera. The green
light comes on to signal it is ready and flashes the red light once. Momentarily press the
“Record/Stop” button again to shoot the photo. The red light will flash a few times and shut off.
Please wait until the red light stops flashing before pressing again. Photo images are saved as a jpg
file in a resolution of 128 *1 24
.
4．
．．
．Setting the Date and Time
Included on the SD card or available online at http://tmenet.com/support/downloads are the
support files for setting up the date and time in the internal clock/calendar of your camera. You
will need to perform the following steps to set the time:
1. Locate the text file text called TAG.TXT and copy it to the root directory of the SD card.
2. Open the file TAG.TXT with notepad or any simple text editor, modify the date and time in
the file while retaining the exact format shown below:
[date] need space with newline/carriage return
2010/03/05 need space with newline/carriage return in format yyyy/mm/dd
12：
：：
：00：
：：
：00 enter hours, minutes, seconds with newline/carriage return hh: mm; ss
Close the file by exiting and put the SD card in the camera or if card was already in the
camera and editing was done via USB, simply unplug the USB cable and power on the
camera. This action will force it to check and analyze the TAG.TXT file and then set system
time to the time you entered in the file. The text file TAG.TXT will be deleted automatically.
