TM SURETHERM 30X Manual de usuario
UNBOXING
SET UP
Hoist the heater out of the box.
Turn main switch from 0 to 1.
You’ll hear a short beep and
the display turns on.
Insert the
plug into a
shockproof
wall socket.
Alternatively connect wiring as follows:
CONNECT TO THE POWER MAINS
TURN ON THE HEATER2
1
Phase
Phase
Ground
Black (USA)
Black (USA)
Brown
Black or Grey
Green/Yellow
QUICKSTART
THE WORKPIECE
POSITIONING THE WORKPIECE
CHOOSING THE RIGHT YOKE
USING THE TEMPERATURE PROBE3
Place the workpiece in a horizontal or vertical
position.
Use largest yoke available or stack two yokes to
center the workpiece around the yoke.
Plug in with
the red dot
facing upwards.
When using a single probe,
place the probe on the
workpiece near the bore.
2
1
QUICKSTART
