Disassembly/Reassembly
Warning
NEVER apply direct heat to the float. The float may explode due to increased internal pressure,
causing accidents leading to serious injury or damage to property and equipment.
Caution
Use hoisting equipment for heavy objects (weighing approximately 20 kg (44 lb) or more).
Failure to do so may result in back strain or other injury if the object should fall.
When disassembling or removing the product, wait until the internal pressure equals
atmospheric pressure and the surface of the product has cooled to room temperature.
Disassembling or removing the product when it is hot or under pressure may lead to discharge of
fluids, causing burns, other injuries or damage.
Use the following procedures to remove components. Use the same procedures in reverse to
reassemble. (Installation, maintenance, repairs, disassembly, adjustment and valve opening/
closing should be done only by trained maintenance personnel.)
Removing/Reattaching the Trap Cover
Part Name & No. During Disassembly During Reassembly
Trap Cover Nut 22 Remove with a socket wrench Consult the table of tightening torques
and tighten to the proper torque
Trap Cover 3 Remove the trap cover by pulling it
down, being careful not to scratch the
seating surface
Make sure there are no pieces of the
old gasket left on the sealing surfaces
of the separator body and trap cover,
align the guide pin on the separator
body with the guide pin hole on the
trap cover and reattach
Trap Cover
Gasket 10 Remove the gasket and clean sealing
surfaces Replace with a new gasket
Removing/Reinserting Parts inside the Trap Cover
Part Name & No. During Disassembly During Reassembly
Baffle Nut 24
(for 65 to 100
mm)
Remove with a socket wrench Consult the table of tightening torques
and tighten to the proper torque
Baffle 25
(for 65 to 100
mm)
Lift off of bolts Align with bolts and set on the float
cover
Screen 13
(for 65 to 100
mm)
Remove, being careful not to bend Place on top of the float cover, being
careful not to bend
Float Cover Bolt
15
(Spring Washer
16)
Remove with a socket wrench Consult the table of tightening torques
and tighten to the proper torque
Float Cover 6 Remove by lifting up and off Place it into position
Float 5 Remove, being careful not to scratch
the polished surface Insert, being careful not to scratch the
polished surface
Trap Valve Seat 8 Remove with a socket wrench Consult the table of tightening torques
and tighten to the proper torque
10
