9
After switching on and connecting to the breez-
er, the remote control continues to operate in
Display mode. The breezer’s main functions can
be controlled in this mode: switching between
Work and Standby modes (POWER button),
changing the air intake mode5 (FLOW button),
changing the fan speed (FAN UP and FAN DOWN
buttons) and air heating temperature (TEMP
UP and TEMP DOWN buttons) if the heater is
installed and switched on.
The TEMP UP and TEMP DOWN buttons can be
held down to adjust the air heating temperature
quickly.
In Display mode, the remote control always starts
at the home screen. It displays the outlet air
temperature, the timer and heater state, the fan
speed and the air intake mode.
The air intake mode symbol is not available on the
Breezer Lite as it has only one air intake mode.
The MagicAir base station link and automatic base station control icons are only available
for the Tion Breezer 3S.
Press the DISP button to see additional information about the device’s state.
Two additional screens are available for the Tion Breezer Lite: a screen with a short de-
vice model name and a screen with the device’s firmware version .
Four additional screens are available for the Tion Breezer 3S and Tion Breezer 4S: a
screen with the device inlet temperature6, a screen with the time set on the device, a
screen with a short device name / and a screen with the device’s firmware
version .
If you do not press any buttons on the remote control for 10 seconds while in Display
mode, the remote control will switch to the home screen (with the outlet air temperature).
If you do not press any buttons on the remote control for 30 seconds, it will turn off to
save battery power.
Settings Menu
Home Screen and Display Mode
5 The Tion Breezer Lite has only one intake mode – inflow.
6Section 4 of the screen will change the flow icon from outgoing to incoming. The incoming and outgoing
temperature does not change for devices without heaters.
EN
