8
Intermediate Stops
Setting Intermediate Stops
An intermediate stop allows a window shading to be preset so
that it will stop at the same “intermediate” position each time it is
opened or closed.
1. Open and close the window shading fully, then move it to the
desired intermediate position.
2. Press and hold the ALL button
for 6 seconds. The Indicator
Light on the front of the remote
starts flashing green.
3. Point the remote at the sensor
eye and press the OPEN
button to set the intermediate
stop. The window shading
moves slightly (or “jogs”) to
indicate that the intermediate
stop has beenadded.
4. Press the ALL button to save the stop. The Indicator Light
stops flashing.
NOTE: One intermediate stop can be set for each window
shading. If you set a new intermediate stop, it replaces the
previous stop.
NOTE: Reset the window shading to clear an intermediate
stop. See “Resetting a Window Shading” on page 15.
Why Set an Intermediate Stop?
Intermediate stops can be used to align opening height to mullions
or other architectural features of the window. They also can be
used to align the opening height of different window shadings in
the same room. In addition, intermediate stops can be used to
achieve a specific degree of vane tilt every time the vanes are
operated.
1
24
3
2
