Attach the grooming brush to the soleplate. You can remove the dust on clothes, sofas, curtains, blankets or
other home textiles with this attachment.
How to attach: Lock the head of the grooming brush to the head of soleplate, and then push the back of the
grooming brush so it locks to the soleplate. When the switch is locked it is attached properly.
How to remove: The unit must be completely cool before removing any accessories. Hold the handle with one
hand, and use your other hand to hold the grooming brush. Slide the switch down, then lift the back of the
grooming brush and remove.
Lint brush attachment:
Attach the Lint brush to the soleplate. This attachment removes fluff on the clothes, sofas, curtains, blankets or
other home textiles.
How to attach: Lock the head of the lint brush to the head of soleplate, and then push the back of the lint brush
so it locks to the soleplate. When the switch is locked it is attached properly.
How to remove: Firstly, hold the handle with your one hand, and use your other hand to hold the Lint brush,
secondly slide the switch down, and then raise the back of the Lint brush. When the head of the Lint brush
depart from the soleplate is done.
INSTRUCTIONS
1. Attach the appropriate accessory for the garment you wish to iron/steam.
2. Fill the appliance with water.
3. Set the required temperature (refer to care label on garment).
4. Plug in to a power outlet and ensure that the power ‘On’ indicator light is illuminated.
5. Wait approximately one minute for the appliance to heat up. Press the steam release button. This button
can be pressed continuously, if required.
6. Before applying steam to a garment, first test the appliance on an old piece of similar material.
7. Move the steam brush and iron combination over the whole garment while pressing the steam-release
button. The iron may be moved both horizontally and vertically. For best results just touch the garment
lightly with the iron.
8. If the appliance runs out of water before you have finished ironing, allow it to cool completely before
refilling. Never use this appliance without water!
9. While using the appliance, you will notice that the power ‘On’ indicator light switches on and off. This is
normal and occurs when the appliance is adjusting the temperature.
10. Unplug the Garment Steamer and iron combination when you have finished using it. WARNING: Always
pull out the plug from the power out. Never pull on the power cable to switch off the appliance. Make
sure that the power ‘On’ indicator light is ‘Off’.
For best ironing results:
•Some garments should be ironed inside out.
•Trousers can be ironed more easily when held from the bottom.
•When ironing, touch the fabric lightly with the iron and move it in different directions to remove wrinkles.
It is important that the iron touches the garment.
•The iron will not remove stains from a garment.
•The Garment steamer can be used with almost any kind of fabric, including: silk, cotton, polyester and
wool. Please read the garment’s care label to check that it can be steam ironed. Certain materials such
as leather, suede and velvet cannot be steam ironed.
•To ensure the garment can be steam ironed, test the iron on a small part of the interior of the garment. If
no damage occurs, the entire garment can be ironed.
