Hanging the Fan
REMEMBER to turn off the power.
Follow the steps below to hang your fan
properly.
NOTE: This fan is recommended for
the standard ceiling mounting using the
downrod and ball assembly. When
using standard downrod installation, the
distance from the ceiling to the bottom of
the fan blades will be approximately 19
inches.
STANDARD CEILING MOUNTING
The maximum angle allowable is 45
degrees. Note: For mounting angles
between 20-45 degrees, please replace
the canopy bottom cover installed on
the bottom of the canopy opening with
the extra 45-degree canopy bottom
cover included.
1. Remove the canopy ring from the
canopy by turning the ring to the right
until it unlocks. (Figure 5)
2. Remove the mounting plate from the
canopy by loosening the four screws on
the top of the canopy. Remove the two
non-slotted screws and loosen the slotted
screws. This will enable you to remove
the mounting plate (Figure 6).
3. Remove and retain the three screws
on the upper decorative arms. Reinstall
and secure the three screws from the top
of arm support ring into the decorative
arms (Figure A).
4. Repeat steps 3 for the remaining
decorative arms.
Figure 5
Figure 6
Figure A
5. Remove the hanger pin and locking
pin from downrod assembly.
6. Route the wires exiting the top of
the fan motor through the decorative
motor collar cover, decorative arms
assembly, then the canopy ring. Make
sure the slot openings are on top. Route
the wires through the canopy and then
through the ball/downrod assembly
(Figure 7).
7. Loosen, but do not remove, the set
screws on the collar on the top of the
motor housing.
8. Align the holes at the bottom of the
downrod with holes in the collar on top
of the motor housing (Figure 7).
Carefully insert the hanger pin through
the holes in the collar and downrod. Be
careful not to jam the pin against the
wiring inside the downrod. Insert the
locking pin through the hole near the end
of the hanger pin until it snaps into its
locked position as noted in the circle inset
of Figure 7.
9. Re-tighten the set screws on the
collar on the top of the motor housing.
10. Remove and retain the three screws
attaching the upper motor housing.
Reinstall the three screws from the
bottom of decorative arms to the upper
motor housing(Figure 7). 4.
