thomann the box Control 10 Sub Manual de usuario
the box Control 10 Sub
Active subwoofer
Operating manual
234671, 1, en_GB
© 2011
Musikhaus Thomann e.K.
Treppendorf 30
96138 Burgebrach
Germany
Telephone: +49 (0)9546) 9223-66
email: [email protected]
Internet: www.thomann.de
28.09.2011the box Control 10 Sub Active subwoofer2
Table of contents
1 General notes...................................................................... 4
2 Safety notes......................................................................... 5
3 Installation and operation.................................................. 7
4 Connectors and controls................................................... 8
5 Technical data................................................................... 10
6 Protecting the environment............................................. 11
Table of contents
28.09.2011 the box Control 10 Sub Active subwoofer 3
1 General notes
This user manual contains important information on the safe opera-
tion of the device. Read and follow all safety notes and all instruc-
tions. Save this manual for future reference. Make sure that it is
available to all persons using this device. If you sell the device to
another user, be sure that they also receive this manual.
Our products are subject to a process of continuous development.
We therefore reserve the right to make changes without notice.
General notes
28.09.2011the box Control 10 Sub Active subwoofer4
2 Safety notes
Use the device only as described in this user manual. Any other
use or use under other operating conditions is considered to be
improper and may result in personal injury or property damage. No
liability will be assumed for damages resulting from improper user.
This device may be used only by persons with sufficient physical,
sensorial, and intellectual abilities and having corresponding
knowledge and experience. Other persons may use this device
only if they are supervised or instructed by a person who is respon-
sible for their safety. Children must be supervised to ensure that
they do not play with the device.
DANGER!
Electric shock caused by high voltages inside
Within the device there are areas where high voltages
may be present. Never remove any covers.
There are no user-serviceable parts inside.
DANGER!
Electric shock caused by short-circuit
Always use proper ready-made insulated mains
cabling (power cord) with a protective contact plug. Do
not modify the mains cable or the plug. Failure to do so
could result in electric shock/death or fire. If in doubt,
seek advice from a registered electrician.
CAUTION!
Possible hearing damage!
With loudspeakers or headphones connected, the unit
can produce volume levels that may cause temporary
or permanent hearing impairment.
Do not operate the unit permanently at a high volume
level. Decrease the volume level immediately if ringing
in the ears or hearing impairment occurs.
Intended use
Safety
Safety notes
28.09.2011 the box Control 10 Sub Active subwoofer 5
NOTICE!
Power supply
Before connecting the device, ensure that the input
voltage (AC outlet) matches the voltage rating of the
device and that the AC outlet is protected by a residual
current circuit breaker. Failure to do so could result in
damage to the device and possibly the user.
Unplug the device before electrical storms occur and
when it is unused for long periods of time to reduce the
risk of electric shock or fire.
NOTICE!
Risk of fire
Do not block areas of ventilation. Do not install the
device near any direct heat source. Keep the device
away from naked flames.
NOTICE!
Operating conditions
This device has been designed for indoor use only. To
prevent damage, never expose the device to any liquid
or moisture. Avoid direct sunlight, heavy dirt, and
strong vibrations.
NOTICE!
Power supply
Before connecting the device, ensure that the input
voltage (AC outlet) matches the voltage rating of the
device and that the AC outlet is protected by a residual
current circuit breaker. Failure to do so could result in
damage to the device and possibly the user.
Unplug the device before electrical storms occur and
when it is unused for long periods of time to reduce the
risk of electric shock or fire.
Safety notes
28.09.2011the box Control 10 Sub Active subwoofer6
3 Installation and operation
Unpack and check carefully there is no transportation damage
before using the unit.
We recommend establishing all connections as long as the unit is
switched off. Use the shortest possible high-quality cables for all
connections.
WARNING!
Risk of injury caused by falling objects
Make sure that the installation complies with the stand-
ards and rules that apply in your country. Always
secure the device with a secondary safety attachment,
such as a safety cable or a safety chain.
Balanced combo XLR/¼-inch connectors are used for the signal
inputs. The figure and the table show the XLR pin assignment.
1 Ground
2 Signal (+)
3 Signal (–)
The figure and the table show the pin assignment of the ¼-inch
(6.35-mm) monaural jack plug.
1 Signal
2 Ground
XLR connectors for signal inputs
and outputs
Jack plug for signal inputs
Installation and operation
28.09.2011 the box Control 10 Sub Active subwoofer 7
4 Connectors and controls
1 Power on/off switch. Switches the device on and off.
2“POWER” LED. Shows that the device is turned on
3“SUB LEVEL” control. Adjusts the volume of the subwoofer.
4“SUB PHASE” switch. Shifts the phase of the subwoofer signal by 180°. This helps to prevent
unwanted destructive acoustic interference in combination with other loudspeakers.
5“MAIN LEVEL” control. Adjusts the master volume (built-in subwoofer and connected external
loudspeakers).
6 Thread for flying bracket
7 Ground connection
Front panel
Connectors and controls
28.09.2011the box Control 10 Sub Active subwoofer8
8 Ground connection
9 Plug for mains cable with fuse holder
10, 11 Terminal connections and 4-mm banana jacks for a pair of external, passive loudspeakers
12 Combo XLR/¼-inch connectors for signal inputs
Rear panel
Connectors and controls
28.09.2011 the box Control 10 Sub Active subwoofer 9
5 Technical data
Inputs Balanced combo XLR/¼-inch connectors
Outputs Screw terminals, 4-mm banana jacks
Power output (THD+N=10 %) 2 × 120 W at 4 Ω
Crossover frequency 150 Hz
Signal-to-noise ratio ≥ 80 dB
Mains power supply 220 VAC … 240 VAC, 50/60 Hz
Power consumption 600 W
Fuse 3.15 A / 250 V, slow, 5 mm × 20 mm
Dimensions (W × D × H) 505 mm × 423 mm × 345 mm (19.88 in. × 16.65 in.× 13.58 in.)
Weight 21 kg (46.29 lbs)
Technical data
28.09.2011the box Control 10 Sub Active subwoofer10
Otros manuales para the box Control 10 Sub
1
Tabla de contenidos
Otros manuales de Subwoofer de thomann
thomann
thomann Pyrit 112 Sub A Manual de usuario
thomann
thomann ACHAT 112 SUBA Manual de usuario
thomann
thomann Achat 115 Sub A Manual de usuario
thomann
thomann Miniray Sub Manual de usuario
thomann
thomann the box pro TP 118/800 A Manual de usuario
thomann
thomann the box pro Achat 212 H Manual de usuario
thomann
thomann the box CL 112 Sub MKII Manual de usuario
thomann
thomann TP218/1600 A Manual de usuario
thomann
thomann Achat 118 A Manual de usuario
thomann
thomann SB 115A Manual de usuario
thomann
thomann the box pro TP 118/800 Manual de usuario
thomann
thomann SB 112 the box PRO Manual de usuario
thomann
thomann Achat 108 Sub the box pro Manual de usuario
thomann
thomann the box pro A 121 LA Manual de usuario
thomann
thomann Syrincs S4WA Manual de usuario
thomann
thomann Pyrit 212 Sub A Manual de usuario
thomann
thomann Achat 108 Sub A Manual de usuario
thomann
thomann T The Box Pro ACHAT 115 SUB Manual de usuario
thomann
thomann Fun generation PL 15 Sub A Manual de usuario
thomann
thomann ACHAT 112 SUBA Manual de usuario
