Thomann FX-1 WATER Manual de usuario

Owner‘s Manual

LIGHT EFFECT

FX-1 WATER

Congratulations on your purchase of this Effect Light.

To get the most from your equipment you must read all of this manual

before using it rst time.

Table of Contents

1. Safety Instruction .......................................................................... 3

Rigging the fixture........................................................................ 4

2. Technical Specification................................................................... 4

3. Description.................................................................................... 5

4. Operation ..................................................................................... 5

5. Lamp installation or replacement ................................................. 5

6. Beam angle................................................................................... 6

7. Troubleshooting............................................................................ 7

8. Fixture Cleaning............................................................................ 7

9. Disposal ........................................................................................ 7

1. Safety Instruction

You have to read the instruction carefully, which includes

important information about the installation, operation and

maintenance.

• Please keep this User Guide for future consultation. If you sell the unit

to another user, be sure that he also receives this instruction booklet

thus giving them the necessary information about the use and general

warnings regarding the unit.

• Unpack and check carefully there is no transportation damage before

using the unit.

• Before operating, ensure that the voltage and frequency of power supply

match the power requirements of the unit as stated in this manual.

• It’s important to ground the yellow/green conductor to earth in order to

avoid electric shock.

• The unit is for indoor use only. Use it only in a dry location. Exposing

the device to rain or moisture would cause the risk of electrical shock

or re. Maximum ambient temperature is 40°C. Don’t operate it in

locations where the temperature is higher than this.

• The unit must be installed in a location with adequate ventilation, at

least 50 cm from adjacent surfaces. Be sure that no ventilation slots are

blocked. The electrical work that is necessary for installation must done

by qualied personnel. Use safety cable when xing this unit.

• Check the surrounding area and make sure there are no ammable liquids,

water or metal objects that could enter the xture. If a foreign object or

substance enters the unit, immediately disconnect the mains power.

• Unit surface temperature may reach up to 85°C. Don’t touch the

housing bare-hand during its operation or shortly after. Turn off the

power and allow about 15 minutes for the unit to cool down before

replacing the bulb or serving.

• Disconnect the device from the mains power before any servicing or

maintenance.

• In the event of serious operating problem, stop using the unit

immediately. Never try to repair the unit by yourself. Repairs carried out

by unskilled people can lead to damage or malfunction. Please contact

the nearest authorized technical assistance centre. Always use the

same type spare parts.

• There are no user serviceable parts inside the xture. Do not open the

housing or attempt any repairs by yourself. If the xture shows any visible

damage or in the unlikely event, that your xture may require service,

please contact your nearest dealer. Always use genuine spare parts.

• Do not connect the device to any dimmer pack.

• Do not look directly at the LED light beam while the xture is on.

• Hot lamp explosion hazard. Do not open the unit within ve minutes

after switching off.

• Do not start the unit without bulb enclosure or when the housing is

damaged. The housing, the lenses, or the ultraviolet lter must be

replaced if they are visibly damaged.

Rigging the fixture

• The unit should be mounted via its screw holes on the bracket. Always

ensure that the unit is rmly xed to avoid vibration and slipping while

operating. Always ensure that the structure to which you are attaching

the unit is secure and is able to support a weight of 10 times of the

unit’s weight. Also always use a safety cable that can hold 12 times of

the weight of the unit when installing the xture.

• Installation needs to be carried out by qualied people only. The device

should be installed out of reach of people and outside areas where

persons may walk by or be seated.

2. Technical Specification

•Powersupply

Supply voltage: AC 230V 50HZ

Power consumption: 260 W

•Fuse

Fuse: 20mm glass 250V T5A

•Bulb

ELC 24V 250W

•Dimension

328 x 266 x 144 mm

•Weight

4.5 kg

3. Description

1. Optical lens with manual focus adjustment.

2. Hanging bracket with 2 knobs on both sides to fasten the unit and a

mounting hole to x a mounting hook.

3. Mains input with IEC socket and integrated fuse holder, connect the

supplied mains cable here.

4. Lamp compartment, to be opened with two screws.

5. Cooling fan.

4. Operation

• Plugging into the mains power, the xture starts running. The Water

Wave runs in automatic mode.

• The focus is adjustable and there’s an access door allowing easy

access to the illuminant.

5. Lamp installation or replacement

• Always switch off the mains supply and never handle the lamp or the

illuminant when it is hot.

• Do not touch the bulb with bare hands. If this does happen, clean

the lamp with denatured alcohol and wipe with a lint free cloth before

installing.

• Pull the socket off the lamp. Do not pull the wires.

6. Beam angle

The Projector is best to be placed 5 meters away from the wall. And from

this distance the light effect will cover an area of 4 m x 4 m.

7. Troubleshooting

Problem Probablecause(s) Suggestedremedy

No light No power to the xture Check power connections

Blown fuse If power is applied but does not light,

please disconnect the unit from the

mains & check / replace the fuse if

necessary.

Burned out lamp Install new lamp.

Fixture too hot Allow to cool down. Improve air ow

around the unit.

No action Electrical malfunction Refer to service technician.

8. Fixture Cleaning

The cleaning of the internal and external lenses and/or mirrors must

be carried out periodically to optimise light output. Cleaning frequency

depends on the environment in which the xture operates: a damp, smoky

or particularly dirty surrounding can increase the accumulation of dirt on

the xture’s optics.

• Clean with soft cloth using normal glass cleaning uid.

• Always dry the parts carefully.

• Clean the external optics at least every 20 days. Clean the internal

optics at least every 30/60 days.

9. Disposal

Donotdisposeofthedeviceattheendofhisoperatinglife

inyournormaldomesticwaste.Thisdeviceissubjecttothe

EuropeanGuidelines2002/96/EC.

• Have the product disposed of by a professional disposal company of by

your communal disposal facility.

• Observe the currently applicable regulations. In case of doubt contact

your disposal facility.

• Dispose of packaging materials in an environmentally

responsible manner.

Musikhaus Thomann

Treppendorf 30 • 96138 Burgebrach

Germany • www.thomann.de

Tabla de contenidos

Otros manuales de Equipo de DJ de thomann

thomann

thomann STAIRVILLE PAR56 Active 300W DMX Manual de usuario

thomann

thomann STAIRVILLE CLB2.4 Manual de usuario

thomann

thomann Stairville BS-280 R10 BeamSpot Manual de usuario

thomann

thomann STAIRVILLE Stage Quad LED Bundle RGBW Manual de usuario

thomann

thomann STAIRVILLE Hz-600 PRO Manual de usuario

thomann

thomann Strirville Tour Stage Manual de usuario

thomann

thomann Stairville Outdoor Stage PAR 12x3W Tri Manual de usuario

thomann

thomann Stairville DJ-X 16 Manual de usuario

thomann

thomann Stairville Pixel Panel 440 RGB MKII Manual de usuario

thomann

thomann Stairville BEL1 Manual de usuario

thomann

thomann Stairville CLB5 6P RGB WW Compact LED Bar Manual de usuario

thomann

thomann VARYTEC PAR56 LED black Manual de usuario

thomann

thomann LED EXPO 310 - 6900 K Manual de usuario

thomann

thomann VARYTEC Retro Blinder 200 LED Manual de usuario

thomann

thomann Stairville Z100M Par 64 LED 3000K 100W Manual de usuario

thomann

thomann fun generation LED Pot Strobe 100 Manual de usuario

thomann

thomann STAIRVILLE Stage Quad LED Bundle RGBW Manual de usuario

thomann

thomann STAIRVILLE PAR64 MKII RGBA Manual de usuario

thomann

thomann ignition Romeo 650/1000 Fresnel/PC Manual de usuario

thomann

thomann STAIRVILLE Strip Blinder LED RGB WW Manual de usuario

thomann

thomann Stairville All FX Bar Manual de usuario

thomann

thomann Blinder 4-Lite Manual de usuario

thomann

thomann Stairville Stage-PAR CX-3 RGBW 18x8W Manual de usuario

thomann

thomann Stairville PAR 56 Manual de usuario

Manuales populares de Equipo de DJ de otras marcas

ALPHA LITE

ALPHA LITE ALPHA 1500 Manual del propietario

Chauvet

Chauvet OVATION E-930VW Manual de usuario

Zumtobel

Zumtobel APHRODITE Home Manual de usuario

Snow Masters

Snow Masters Zig Oscillator Manual de usuario

EuroLite

EuroLite 50530554 Manual de usuario

Beamz

Beamz BUV243 Manual de usuario

Eagletone

Eagletone 6 Eyes Flower Manual de usuario

EuroLite

EuroLite FLD-1508 Manual de usuario

Technical Pro

Technical Pro LG8xSEA Manual de usuario

JB Systems

JB Systems Lounge Laser DMX Manual de usuario

Lightmaxx

Lightmaxx Vega Halo 90 Manual de usuario

Elation

Elation FUZE WASH Z350 Manual de usuario

Maverick

Maverick MK3 WASH Manual de usuario

Infinity

Infinity TF-260C7 Fresnel Manual de usuario

Chauvet

Chauvet EVE E-50Z Manual de usuario

Eliminator Lighting

Eliminator Lighting E 138 Manual de usuario

EuroLite

EuroLite Mini Multicolor LED Flashing Light SC Manual de usuario

KAM

KAM DMX Laser80 FScan Manual de usuario

thomann FX-1 WATER Manual de usuario

Manuales populares de Equipo de DJ de otras marcas