4
SAFETY INFORMATION
This document describes important safety instructions which must be
followed during installation, maintenance and application of the DCC –
Electric Vehicle Energy Management System (EVEMS).
Warning
Read all instructions prior using this
product.
Always disconnect the DCC – EVEMS
power supply before any works.
Use only the DCC – EVEMS by following
the technical specifications indicated in
this installation manual.
Do not install the DCC – EVEMS nearby
inflammable materials, explosives or
fuels, chemical products and vapors.
Never spray the DCC – EVEMS with wa-
ter or any other liquids.
Stop using the DCC – EVEMS imme-
diately if defective, cracked, broken or
damaged.
Never try to modify, repair or dismantle
the DCC – EVEMS. Please contact the
manufacturer for any malfunction.
Never insert a sharp object inside the
DCC – EVEMS at the risk of causing da-
mages to the components.
Any improper use of the DCC – EVEMS
could result in serious injuries which
may cause death.
For a vertical installation on a wall, refer
to the information’s on the enclosure for
the choice of mounting position.
Precautions
Any improper use of the DCC – EVEMS
can cause damages and premature wear
of the components, which voids the war-
ranty.
Never use the DCC – EVEMS above or
below the temperature range of -22°F
to 113°F (-30°C to 45°C).
Only store the DCC – EVEMS above or
below the temperature range of -4°F to
158°F (-20°C to 70°C).
The installation of the DCC – EVEMS
must be done in accordance with the
latest electrical code requirements.
Notes
It is recommended to schedule the
charging of the vehicle during hours of
low electrical consumption to minimize
interruptions to the electric charging
station.
Always check that the DCC – EVEMS is
adequately fixed to the wall or ceiling or
in a location to avoid any damages.
Even if this product is advertised for EV
chargers, it can be installed with other
types of load.
It is the installer’s responsibility to make
sure that the electric power source
is adequate for the use of the DCC –
EVEMS.
Do not use any cleaning solvents to clean
the DCC – EVEMS.
Limited warranty
1THERMOLEC LTÉE. warrants the inte-
grated controls against any defects for
a period of one year from the shipping
date. The warranty is limited to the
equipment and components supplier
by THERMOLEC LTÉE.
2In case of incorrect installation, inap-
propriate use or repairs done by unau-
thorized personnel by THERMOLEC
LTÉE., the warranty will be automati-
cally void.
3 THERMOLEC LTÉE. undertakes to repair
or replace, at site or at the manufactu-
ring location, at his option, the defec-
tive material only after an evaluation
made by its representative.
4 THERMOLEC LTÉE.will not be held
liable for damages or delays and will
not be required to pay transport cost
of the EVEMS said to be defective.
5THERMOLEC LTÉE.shall not be liable
for any indirect damages or delays
caused by faulty workmanship or
materials.
No indemnity will be paid for repairs,
replacements or modifications wit-
hout a prior written consent supplied
by THERMOLEC LTÉE.
6Any control device or accessory sup-
plied with the DCC – EVEMS to be
installed or connected remotely from
the EVEMS will be guaranteed by the
manufacturer only under the special
conditions mentioned in paragraph 5.
7The components supplied for repairs
are guaranteed for the remaining of
the warranty on the original product or
90 days. The longest period will pre-
vail.
8All repairs made at the THERMOLEC
LTÉE. plant are guaranteed for 30 days
from the date of repairs.
