Thermo Orion 900A Manual de usuario
Analyze •Detect •Measure •Control™
Orion 900A Printer
INSTRUCTION MANUAL
on
line
feed
Orion 900A
printer
Orion 900A
AQUAfast, Cahn, EZ Flash, Ionalyzer, ionplus, KNIpHE, No Cal, ORION, perpHect, PerpHecT, PerpHecTion, pHISA, pHix, pHuture, Pure Water, Sage, Sensing the Future,
SensorLink, ROSS Ultra, Sure-Flow, TEA Analyzer, Titrator PLUS, TURBO2 and Wine Master are registered trademarks of Thermo Electron Corporation.
1-888-pHAX-ION, A+, All in One, Aplus, AQUAsnap, AssuredAccuracy, AUTO-BAR, AUTO-CAL, AUTO DISPENSER, Auto-ID, AUTO-LOG, AUTO-READ, AUTO-STIR, Auto-Test,
BOD AutoEZ, Cable-Free, CERTI-CAL, CISA, DataCOLLECT, DataPLUS, digital LogR, DirectCal, DuraProbe, Environmental Product Authority, Extra Easy/Extra Value, FAST QC,
Flash Titration, Flash Titrator, GAP, GLPcal, GLPcheck, GLPdoc, ISEasy, KAP, LabConnect, LogR, Low Maintenance Triode, Minimum Stir Requirement, MSR, NISS, One-Touch,
One-Touch Calibration, One-Touch Measurement, Optimum Results, Pentrode, pHuture MMS, pHuture Pentrode, pHuture Quatrode, pHuture Triode, Quatrode, QuiKcheK,
rf link, ROSS, ROSS Resolution, SAOB, Smart CheK, Stacked, Stat Face, The Enhanced Lab, ThermaSense, Triode, TRIUMpH, Unbreakable pH, Universal Access are
trademarks of Thermo.
Guaranteed Success and The Technical Edge are service marks of Thermo.
PerpHecT meters are protected by U.S. patent 6,168,707.
PerpHecT ROSS are protected by U.S. patent 6,168,707.
ORION Series A meters and 900A printer are protected by U.S. patents 5,108,578, 5,198,093, and German patents D334,208 and D346,753.
Sure-Flow electrodes are protected by European Patent 278,979 and Canadian Patent 1,286,720.
ionplus electrodes and Optimum Results solutions are protected by US Patent 5,830,338.
ROSS Ultra electrodes have patents pending.
ORION ORP Standard is protected by US Patent 6,350,367.
ORION Series A conductivity meters are protected by US Patent 5,872,454.
© Copyright 2003, Thermo Electron Corporation. All rights reserved. Question everything, and Analyze. Detect. Measure. Control are trademarks of Thermo Electron
Corporation.
The specifications, descriptions, drawings, ordering information and part numbers within this document are subject to change without notice.
This publication supersedes all previous publications on this subject.
Orion 900A Printer Instruction Manual
TABLE OF CONTENTS
Chapter I. Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1
Chapter II. Set-up . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2
A. For use with Orion 145, 150, 420A, 520A, 620, 720A, 850 or 920A . .2
B. For use with Orion 115, 125, 250A, 290A or 810 . . . . . . . . . . . . . . .3
Chapter III. Paper Insertion . . . . . . . . . . . . . . . . . . . . . . . . . . . . .4
Chapter IV. Battery . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
A. Recharging . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5
B. Replacing . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6
Chapter V. Accessories and Ordering Information . . . . . . . . . .7
Chapter VI. Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .8
Chapter VII. Repair and Service . . . . . . . . . . . . . . . . . . . . . . . . .12
Chapter VII. Specifications for Orion 900A Printer . . . . . . . . . .13
Orion 900A Printer Instruction Manual
Introduction 1
Chapter I
Introduction
The Orion 900A is a battery operated printer designed for field or
laboratory use with Orion 115, 125, 145, 150, 250A, 290A, 420A, 520A,
620, 720A, 810, 850, 920A. The Printer plugs directly into the meter
making a compact design, which is easy to carry in the field and reduces
the cables and bench space required in the lab.
Note: Use the Orion 900A printer with Orion meters only.
Orion 900A Printer Instruction Manual
Set-up
2
Chapter II
Set-up
SET UP FOR USE WITH Orion 145, 150, 420A, 520A, 620, 720A,
850 OR 920A
See Figure 1.
1. Line up RS-232C port on the printer with the RS-232C port on the
meter. Push together until connection is secured.
2. Tighten the screw using a coin. Do not over tighten.
3. See the applicable meter instruction manual for print options and
details on using the meter and printer together.
printer
900A
model
on
line
feed
Figure 1
Orion 900A Printer Instruction Manual
Set-up 3
SETUP FOR USE WITH Orion 115, 125, 250A, 290A OR 810
See Figure 2.
1. Remove the cap from RS232-C port on left side of printer and place
the cap into the RS232-C port on the right hand side.
2. Slide screw out from left-hand position and insert on opposite side.
3. Line up RS232-C port on meter with RS232-C port on the printer.
Push together until connection is secure.
4. Tighten the screw using a coin. Do not over tighten.
5. See the meter instruction manual for print options and details on the
meter and printer together.
printer
900A
model
on
line
feed
Figure 2
Chapter III
Paper Insertion
See Figure 3.
1. Flip open the top portion of the front printer case.
2. Tear off approximately the first 8 inches of printer paper from the roll.
3. Hold the roll in one hand with the paper coming off the bottom of the
roll. Insert the end of the paper into the print mechanism. Insert under
the plastic section and above the lower metal piece.
4. Turn the printer on by sliding the switch to the right, then press line
feed button. The paper should move through the print mechanism and
out of the top. If not, check to make sure the paper is inserted
properly.
5. Hold the paper forward while flipping the top cover closed so it
remains on the outside of the printer case.
Note: Do not apply tape over printout. This will cause fading. Tape around the
edges or staple.
printer
900A
model
on
line
feed
Orion 900A Printer Instruction Manual
Paper Insertion
4
Figure 3
Orion 900A Printer Instruction Manual
The Battery 5
Chapter IV
The Battery
RECHARGING THE BATTERY
The Orion 900A contains a rechargeable battery. The printer can operate
while plugged into line power and recharging. Recharge the battery
overnight so it is ready for use the next day as follows:
1. Plug the line converter into the jack on the right side of the printer.
For printers used with bench top meters turn meter over and plug into
jack from below. You may leave the printer plugged into line power
indefinitely.
2. Plug the line converter into an appropriate wall outlet and turn
the printer off. Leave in this state for 12 hours to fully recharge
the battery.
Note: Plugging in the meter will not recharge the printer battery. The printer
must be plugged into line power directly.
Orion 900A Printer Instruction Manual
The Battery
6
REPLACING THE BATTERY PACK
See Figure 4.
1. Remove battery cover on rear panel by sliding cover down.
2. Remove battery pack by pulling gently. Disconnect the wire leads by
pulling straight out from the internal connection.
3. Insert connector on new battery pack into the internal portion of the
printer until it is secure. This is a polarized connector and can only be
inserted one way. Position the battery pack into compartment and
replace cover.
4. Plug in the printer and charge the battery for twelve hours.
Note: Battery must be disposed or recycled properly.
Figure 4
Orion 900A Printer Instruction Manual
Accessories and Ordering Information 7
Chapter V
Accessories and Ordering Information
Orion Description
0900A0 Orion 900A Printer, 110V, battery pack
(installed at Orion), line cord with U.S.
connector, one roll of paper, and
instruction manual
0900A1 Orion 900A Printer, 220V, battery pack
(installed at Orion), line cord with U.S.
connector, one roll of paper, and instruction
manual
0900A4 Printer paper, box of 10
0900A6 Rechargeable battery pack for 900A printer
020125 Line converter, 110V
020130 Line converter, 220V
Tabla de contenidos
