45
GB
●The detector conrms a valid command with a icker of the
red LED for a half seconds.
●An invalid command or an incompatible IR-group-address
are indicated by the LED briey lighting up once.
●If the presence detector does not react
-this means that the remote control has not been adjusted
to the detector accurately enough
-or that the detector cannot be remotely operated using
this remote control.
-or that the battery is almost at
3.1 Switching the lighting
Briey press the
/
key switches the relevant channel on/off (lighting group).
Pressing the ON/OFF buttons switches both channels on/off simultaneously.
3.2 Dimming the lighting
Pressing and holding down the
/
keys dims the relevant channel (light-
ing group) brighter/darker. Press the
/
keys until the desired brightness is
achieved.
This interrupts automatic lighting control.
Note: Dimming is only possible with presence detectors that have a dimming
function.
