THE SHOWER LAB VIEW 07 Manual de usuario
Illustration - View 07
H1 Handle
Right Hand
Open Out
VIEW 07
07/2019 V 2.2
IMPORTANT
•This shower screen / enclosure must be installed by suitably qualified individuals. We
recommend a minimum of two people for safe assembly of certain sections of this screen.
•Ensure all appropriate safety equipment, especially protective footwear, safety glasses
and gloves are used.
•When drilling holes in ceramic tiles, use masking tape to prevent the drill from slipping:
DO NOT use hammer action as this will crack the tiles. Use a high quality drill bit to ensure
a clean, precise hole.
Tighten hinges and brackets to the recommended 15.6N.
•
•
Please leave these instructions with the customer following installation.
PRIOR TO INSTALLATION
•Before disposing of the packaging and prior to commencing assembly, please check all
the components to ensure that they have been supplied correctly and are undamaged.
Subsequent claims for missing or damaged pieces will not be accepted once the
packaging has been disposed of and installation commenced.
•In the event of any queries please contact your supplier quoting the relevant model
information.
•The Tray / Tiled floor on which this screen is to be installed must be level on all sides.
•It may be necessary to use alternate fixings to those supplied, depending on the properties
of the walls to be fixed to.
•Use the protective corners supplied at all times until the glass is moved to its final position.
•Ensure that the glass is installed correctly, taking care to avoid installing the glass upside
down. On certain panels an easy clean coating is applied to one side only, this is clearly
marked with a sticker on the non-coated side. The coated surface is to be fitted inwards
towards the inside (wet side) of the screen.
•Ensure that all surfaces to be sealed are clean and dry prior to applying the silicone
sealant. Use a high grade fungal resistant sealant.
•Allow a minimum of 48 hours after application of the silicone sealant prior to using the
screen.
TOOLS & MATERIALS REQUIRED
Junior Hacksaw
Straight Edge (Steel
Rule)
Fine Tooth File
Set or Roofing
Square
Masking Tape
Modelling Knife
Spirit Level
Pencil
Silicone Gun
Power Drill
Ø6mm Masonry Drill Bit
2x Suction Glass Lifters
High Quality Silicone Sealant
Tape Measure
Pozi-drive
Screwdrivers, PZ1&2
Safety Glasses and
Gloves
CARE AND MAINTENANCE
(please ensure that these instructions are left with the installed unit)
•We recommend routine cleaning of your screen / enclosure with hot water using a soft
cloth, then drying with a dry soft cloth or chamois leather.
Ritec Aftercare for Shower Glass is recomended for best results.
•All glass has been treated with EASY CLEAN glass finish and care must be taken to avoid
any abrasive cleaning products that may damage the special surface protection.
•DO NOT use acidic based de-scaler products or products containing bleaches or solvents.
Digital Torque Wrench
VIEW 07
07/2019 V 2.2
Return panel
x1
Supplied Parts
Inline Panel
x1
Door
x1
90° Corner insert
x1
Glass support
x2
Square Alignment Jig
x1
Each bracket includes
2x Screws and Wall Plugs
90° Glass to wall bracket
x2
Glass to wall hinge
x2
(Each hinge includes
3x Screws and wall plugs)
90° Glass to glass bracket
x2
Door Handle
(Option dependant)
x1
VIEW 07
07/2019 V 2.2
Supplied Parts
Glass to glass bubble “h” seal
x1
Underframe
x2
Underframe top
x1
Wall channel
x1
Bottom door seal
x1
3mm Spacer1mm Spacer
Glass to wall seal
x2
VIEW 07
07/2019 V 2.2
Please use this page to nd which stay bar your enclosure has been supplied with.
SB1 - With Glass clamp
SB7 - With Glass clamp
and T connector
VIEW 07
07/2019 V 2.2
These instructions are for a corner enclosure (Door hinged o wall). This view shows a right
handed set up with SB7 stay bar connecting the return and inline panel together, xed to the
wall.
Please use the below diagram to reference the list of parts.
I
HUnderframe Bottom
Underframe Top
L
K
JWall Channel
Glass to Glass Bubble “h” Seal
Glass to Wall Seal
MBottom Door Seal
NStay Bar (SB7 shown)
A
B
C
D
F
E
G
Return Panel
Inline Panel
Door (H1 Handle option shown)
Glass to Wall Bracket
90° Glass to Glass Bracket
Handle (Option Dependant)
Glass to Wall Hinge
A
E
EF
F
D
D
J
M
H
I
L
G
H
B
NC
K
VIEW 07
07/2019 V 2.2
2
01/20
3-8mm
Outside of shower Inside of shower
(Wet Side)
Shower Tray
X
Mitred End
VIEW 07
07/2019 V 2.2
Insert the square alignment jig to
locate the wall channel. Using a spirit
level, ensure the wall channel is
Mark the pre-drilled holes.
squarely insert the return panel into
the wall channel and lower onto the
spacers. Take great care NOT to knock
the corners as this can cause the panel
56
7 8
Remove the channel.
Using a 6mm high quality drill bit for a
clean and precise hole, drill the marked
the channel.
WARNING
The glass is heavy and may
damage the oor or underframe if
handled incorrectly. It is advisable
to use a suitable non-slip
protective mat or piece of carpet.
Never rest the glass across the
underframe as this may cause
damage.
Professional Tip
If drilling ceramic tiles, place
masking tape on the tiles before
marking and drill through the
tape to prevent the drill bit from
skidding.
DO NOT use Hammer Action as
this will break the tiles.
Place spacers into the underframe
evenly, as shown below. Begin with the
4mm spacers.
NOTE: There must always be a
minimum set of 1mm spacers used
under the glass panel.
02/20
4mm
4mm
VIEW 07
07/2019 V 2.2
Using a spirit level, align the return
9
03/20
No Gap
4mm
4mm
VIEW 07
07/2019 V 2.2
13 14
15 16
Place the door supports evenly over
the frame.
With one person inside the enclosure,
supports as indicated.
the inline panel.
04/20
should be located inside the enclosure.
OUTWARD Opening
INWARD Opening
Outside enclosure
Outside enclosure
Inward opening Outward opening
VIEW 07
07/2019 V 2.2
Otros manuales para VIEW 07
1
Tabla de contenidos
Otros manuales de Cabina de ducha de THE SHOWER LAB
THE SHOWER LAB
THE SHOWER LAB View 45 Manual de usuario
THE SHOWER LAB
THE SHOWER LAB VIEW 25 Manual de usuario
THE SHOWER LAB
THE SHOWER LAB VIEW 25 Manual de usuario
THE SHOWER LAB
THE SHOWER LAB VIEW 19F Manual de usuario
THE SHOWER LAB
THE SHOWER LAB VIEW 09 Manual de usuario
THE SHOWER LAB
THE SHOWER LAB VIEW 04 Manual de usuario
