Using the inside button to set persistent state:
o Press and hold the inside button for 3 seconds to change the persistent state.
-Persistent locked- the doorlock will unlock when the button is pressed on the outside, and
activated via Bluetooth or RFID, and then auto-lock after 3 seconds. The Doorlock can be
opened from the inside, but will not unlock the Doorlock.
-Persistent unlocked- the doorlock will unlock when the button is pressed on the outside, and
activated via Bluetooth or RFID, and will not auto-lock. When the door is opened from the
inside, the Doorlock will be unlocked.
Programming the doorlock to a new NFC Tag:
o Press front button once, Blue LED will flash. (Note: If Red LED blinks, the batteries are
below 40% and the doorlock should be replaced soon.)
o Scan tag by bringing it close to the optimal read area. (Note: User must use the tag that
came with the doorlock or other previously learned tag.)
o LED will turn solid blue and the Doorlock will open.
o Within 3 seconds of the LED turning solid blue, press button again to enter programming
mode. (Note: a new tag must be learned within 3 seconds or the Doorlock will power off.)
o Scan new tag. (On optimal read area)
o Blue LED will blink quickly and Doorlock will power off.
o New tag has been programmed and saved into the Doorlock.
Opening the doorlock with a previously paired Bluetooth handheld device:
o Open application on the handheld Device.
o Press the outside button on the doorlock to turn on Bluetooth.
o Wait for Bluetooth on the Doorlock to connect.
o Press the unlock button on the application.
o Gearbox will disengage lock.
o Turn the front knob to disengage the latch.
Opening the doorlock with a previously paired Bluetooth handheld device (with “Auto
unlock” enabled):
o Open application on the handheld Device.
o Press the button on the doorlock to turn on Bluetooth.
o Wait for Bluetooth on the Doorlock to connect.
