The Diagnostic Box TDB001 Manual de usuario
TDB001!PAGE 1
VERSION 1.0!01/01/2013
TDB001 REMOTE CONTROL TESTER
OPERATING MANUAL
CONTENTS
CONTENTS
INTRODUCTION
PAGE 2
GENERAL OPERATION
PAGE 3
SPECIFICATION
PAGE 4
CONTACT INFORMATION
PAGE 5
DECLARATION OF CONFORMITY
PAGE 6
CONTENTS
TDB001!PAGE 2
VERSION 1.0!01/01/2013
INTRODUCTION
TDB001!PAGE 3
VERSION 1.0!01/01/2013
The TDB001 Remote Control Tester has been designed to offer a quick and accurate way to test
radio frequency (RF) remote controls and also infra red (IR) remote controls.
The TDB001 offers a simple check that the remote is sending a signal, but more important that
the frequency it is sending is correct. This is important for imported vehicles and systems, as
there are a number of different frequencies used across the world.
Other features include a rear magnet so the unit can be fixed inside a van for easy storage, or if
your working on a vehicle it can be fixed somewhere safe and will not slip off.
The TDB001 uses 3 AA batteries, normal or rechargeable, making it very cost effective, and will
run for a minimum of 20 hours with good batteries.
It also features a low battery indicator, to show when the batteries need recharging or replacing
and a 3.5 numerical backlit display, making the unit easy to use in all lighting conditions.
◉User friendly and portable
◉Powered by 3 x AA Batteries
◉Can be used on ALL Makes of vehicles, boats, trucks and motorbikes
◉Test Radio Frequency Remote controls (RF)
◉Test Infra Red Remote Controls (IR)
◉Low cost
◉Time saving
◉Simple to use
TDB001!PAGE 4
VERSION 1.0!01/01/2013
Infra Red (IR) receiver window
LCD Display
Power Button
RF Antenna
Magnetic Panel
Battery Compartment
TDB001!PAGE 5
VERSION 1.0!01/01/2013
GENERAL OPERATION
INSERTING THE BATTERIES
Remove the rear cover, as shown.
Insert the batteries, ensuring correct polarity.
Replace the rear cover.
SWITCHING THE UNIT ON
Press the button on the front panel once to turn unit on.
The tester will power up, displaying version
information and self check info.
BATTERY LOW INDICATION
If the batteries are low, then an indication will be displayed as follows (bAt Lo), please
recharge or replace the batteries to ensure correct and accurate readings.
TESTING INFRA RED (IR) REMOTE CONTROLS
Switch the unit ON, and wait for the self check to finish so that a 0 is displayed. Point the Infra
Red Remote control towards the top of the unit as shown. If there is a signal being sent the
tester will display ‘Infra’.
TDB001!PAGE 6
VERSION 1.0!01/01/2013
TESTING RADIO FREQUENCY (RF) REMOTE CONTROLS
Switch the unit ON and wait for the self check to finish so that a 0 is displayed. Place the remote control near
the front of the unit, as close to the logo and ON button as possible and press the remote control button. The
frequency will be displayed. Repeat the procedure a few times to ensure an accurate reading is made.
IMPORTANT NOTE : If you receive erratic or incorrect frequency readings, ensure the device is away
from Mobile Phones, Wireless internet, Bluetooth devices etc. These devices work on similar
frequencies to some of the remote controls and therefore it is important that they are not in close
proximity while the test is performed.
There are a number of frequencies used across the world, and depending on the country and region will
depend on the frequency used.
Below is a table of frequencies used, and the expected readings that you may receive using the TDB001 in
terms of accuracy. Some of these are not used on current models, but have been used in the past on older
models.
FREQUENCY
TERRITORY/COUNTRY
TEST RANGE
224 MHz
FAR EAST & AUSTRALASIA
220 - 230 MHz
303 MHz
USA, CANADA & S.AMERICA
295 - 310 MHz
315 MHz
USA, CANADA, JAPAN & S.AMERICA
310 - 320 MHz
415 MHz
EUROPE
410 - 420 MHz
433 MHz
EUROPE & ASIA
425 - 440 MHz
968 MHz
WORLDWIDE
950 - 980 MHz
TDB001!PAGE 7
VERSION 1.0!01/01/2013
BATTERIES
3 X AA RECHARGEABLE OR NORMAL
WEIGHT
130 Grams
SIZE
84 mm (W) x 140 mm (H) x 29 mm (D)
CURRENT CONSUMPTION
40 mA
LCD
3.5 Numerical Backlit LCD Display
ACCURACY
+- 5%
FREQUENCY RANGE
100 Mhz to 1000 Mhz
AUTO POWER OFF
30 Seconds
SPECIFICATION
TDB001!PAGE 8
VERSION 1.0!01/01/2013
CONTACT INFORMATION
The Diagnostic Box
24 Helmers Way
Chillington
Kingsbridge
Devon
TQ7 2EZ
United Kingdom
Tel : +44 1548 580348
Fax : +44 1548 580348
Web : www.thediagnosticbox.com
Skype : diagnosticbox
TDB001!PAGE 9
VERSION 1.0!01/01/2013
DECLARATION of CONFORMITY
TDB001!PAGE 10
VERSION 1.0!01/01/2013
DECLARATIONOFCONFORMITY
Manufacturer’s Name: The Diagnostic Box
Manufacturer’s Address: 24 Helmers Way
Chillington
Kingsbridge
Devon
TQ72EZ
United Kingdom
Product Name: Remote Control Tester
Product Model: TDB001
Conforms to: Specifications
EN 55022:1998, A1: 2000 + A2: 2003
EN 55024:1998, A1: 2001 + A2: 2003
Following the Provisions of EMC Directive: 89/336/EEC
TDB001 December 2012
Product conforms to class A emission standards
Signed : ________________________
Signed on behalf of The Diagnostic Box
Tabla de contenidos
Otros manuales de Equipo de prueba de The Diagnostic Box
The Diagnostic Box
The Diagnostic Box TDB014 Manual de usuario
The Diagnostic Box
The Diagnostic Box TDB1000 Manual de usuario
The Diagnostic Box
The Diagnostic Box TDB760 Manual de usuario
The Diagnostic Box
The Diagnostic Box TDB003 Manual de usuario
The Diagnostic Box
The Diagnostic Box TDB500 Manual de usuario
Manuales populares de Equipo de prueba de otras marcas
SMART
SMART KANAAD SBT XTREME 3G Series Manual de usuario
Agilent Technologies
Agilent Technologies BERT Serial Manual de usuario
Agilent Technologies
Agilent Technologies N3280A Manual de usuario
Vernier
Vernier Go Direct Voltage Manual de usuario
Lifeloc
Lifeloc R.A.D.A.R. Manual de usuario
Fluke
Fluke T5-600 Instrucciones de funcionamiento e instalación
