Texas Instruments TPS62840-1YBGEVM56 Manual de usuario

SLUUC17–May 2019

TPS62840-1YBGEVM56 User's Guide

User's Guide

SLUUC17–May 2019

TPS62840-1YBGEVM56 User's Guide

The TPS62840-1YBGEVM56 (BSR056-001) facilitates the evaluation of the TPS6284xYBG family of 750-

mA, step-down converters with 60-nA IQin tiny 1.47-mm by 0.97-mm WCSP packages with 0.4-mm pitch.

The EVM contains 2 separate circuits to create output voltages between 0.8 V and 3.3 V from higher input

voltages between 1.8 V and 6.5 V. All circuits have a maximum height of 1 mm. Due to its extremely low

IQ, the TPS6284x provides a long battery lifetime for systems which have very low current consumption

states such as wearables, Internet of Things- (IoT-) connected devices, and other portable end equipment.

Contents

1 Introduction ................................................................................................................... 2

2 Setup .......................................................................................................................... 4

3 TPS62840-1YBGEVM56 Test Results.................................................................................... 5

4 Board Layout ................................................................................................................. 6

5 Schematic and Bill of Materials (BOM).................................................................................. 12

List of Figures

1 Loop Response Measurement Modification.............................................................................. 3

2 TPS62840 Thermal Performance (VIN = 3.6 V, VOUT = 1.8 V, IOUT = 750 mA)........................................ 5

3 Loop Response (VIN = 3.6 V, VOUT = 1.8 V, IOUT = 750 mA)............................................................. 5

4 Top Assembly................................................................................................................ 6

5 Top Layer..................................................................................................................... 7

6 Internal Layer 1 .............................................................................................................. 8

7 Internal Layer 2 .............................................................................................................. 9

8 Bottom Layer................................................................................................................ 10

9 TPS62840-1YBGEVM56 Angled View .................................................................................. 11

10 TPS62840-1YBGEVM56 Overhead View............................................................................... 11

11 TPS62840 Schematic...................................................................................................... 12

12 TPS62841 Schematic...................................................................................................... 12

List of Tables

1 BSR056 Circuit Options..................................................................................................... 2

2 Performance Specification Summary ..................................................................................... 2

3 TPS62840 Bill of Materials................................................................................................ 13

4 TPS62841 Bill of Materials................................................................................................ 13

Trademarks

All trademarks are the property of their respective owners.

Introduction

www.ti.com

2SLUUC17–May 2019

Submit Documentation Feedback

TPS62840-1YBGEVM56 User's Guide

1 Introduction

The TPS6284x is a family of synchronous, step-down converters in a 1.47-mm × 0.97-mm wafer chip-

scale package (WCSP) with 0.4-mm pitch. The BSR056 EVM contains 2 completely independent circuits,

each for a different IC version. See Table 1 for a summary of the BSR056 EVMs.

The reference designator order is grouped together by sub-circuit. Reference designators beginning with

'1' (for example, R1x, J1x, C1x) are part of one sub-circuit. The second digit of each reference designator

is the same for the same component in different sub-circuits. R11 and R21, for example, refer to the same

resistor in each sub-circuit.

Table 1. BSR056 Circuit Options

EVM Version IC Installed Output Voltage Output Voltage Range Output Current

TPS62840-1YBGEVM56

(BSR056-001) TPS62840 (U11) 1.8 V 1.8 - 3.3 V (selectable) 750 mA

TPS62841 (U21) 1.2 V 0.8 - 1.55 V (selectable) 750 mA

1.1 Performance Specification

Table 2 provides a summary of the TPS62840-1YBGEVM56 performance specifications.

Table 2. Performance Specification Summary

SPECIFICATION MIN TYP MAX UNIT

Input voltage 1.8 3.6 6.5 V

Output voltage See Table 1 V

Output current 0 See Table 1 mA

1.2 Modifications

The printed-circuit board (PCB) for this EVM uses the adjustable output voltage versions of this integrated

circuit (IC). Additional input and output capacitors can also be added. Finally, the loop response of the IC

can be measured.

1.2.1 Adjusting the Output Voltage

The output voltage is adjusted though the choice of Rx1 and Rx3 resistors. Since Rx1 and Rx3 are in

parallel, only Rx1 or Rx3 should be installed at the same time. Rx1 is an 0201 size to represent a typical

final solution. However, such a small size is difficult to manually replace. Therefore, Rx3 is provided in an

0603 size to easily change the output voltage. Simply remove Rx1 and install Rx3 in the desired value.

1.2.2 Input and Output Capacitors

Cx4 is provided for an additional input capacitor. This capacitor is not required for proper operation but

can be used to reduce the input voltage ripple.

Cx5, Cx6, and Cx7 are provided for additional output capacitors. These capacitors are not required for

proper operation but can be used to reduce the output voltage ripple and to improve the load transient

response. The total output capacitance must remain within the recommended range in the data sheet for

proper operation.

Cut trace

as shown

www.ti.com

Introduction

SLUUC17–May 2019

TPS62840-1YBGEVM56 User's Guide

1.2.3 Loop Response Measurement

The loop response of the EVM can be measured with two simple changes to the circuitry. First, cut the

trace between the VOS pin and the output capacitor on the top layer. This change is shown in Figure 1.

Second, install a 10-Ωresistor across the resistor pads on the back of the PCB at Rx2. The pads are

spaced to allow installation of an 0603-sized resistor. With these changes, an ac signal (10-mV, peak-to-

peak amplitude recommended) can be injected into the control loop across the added resistor. Details of

measuring the control loop of DCS-Control devices are found in How to Measure the Control Loop of

DCS-Control™ Devices. The results of this test are shown in Figure 3.

Figure 1. Loop Response Measurement Modification

Setup

www.ti.com

4SLUUC17–May 2019

Submit Documentation Feedback

TPS62840-1YBGEVM56 User's Guide

2 Setup

This section describes how to properly use the TPS62840-1YBGEVM56.

2.1 Input/Output Connector Descriptions

Jx1, Pin 1 and 2 – VIN Positive input connection from the input supply for the EVM.

Jx1, Pin 3 and 4 – S+/S- Input voltage sense connections. Measure the input voltage at this point.

Jx1, Pin 5 and 6 – GND Input return connection from the input supply for the EVM.

Jx2, Pin 1 and 2 – VOUT Output voltage connection.

Jx2, Pin 3 and 4 – S+/S- Output voltage sense connections. Measure the output voltage at this point.

Jx2, Pin 5 and 6 – GND Output return connection.

JPx1 – EN EN pin input jumper. Place the supplied jumper across ON and EN to turn

on the IC. Place the jumper across OFF and EN to turn off the IC.

2.2 Setup

To operate the EVM, set jumper JPx1 to the desired position per Section 2.1. Connect the input supply to

Jx1 and connect the load to Jx2.

Frequency (Hz)

Gain (dB)

Phase (deg)

100 200 5001000 10000 100000 1000000

-60 -180

-50 -150

-40 -120

-30 -90

-20 -60

-10 -30

0 0

10 30

20 60

30 90

40 120

50 150

60 180

D001

www.ti.com

TPS62840-1YBGEVM56 Test Results

SLUUC17–May 2019

TPS62840-1YBGEVM56 User's Guide

3 TPS62840-1YBGEVM56 Test Results

The TPS62840-1YBGEVM56 was used to take all the data in the 1.8V-6.5V, 750mA, 60nA IQStep-Down

Converter data sheet. See the device data sheet for the performance of this EVM. The only difference is

the inductor used. This EVM was designed for the smallest solution size and uses a 0805-size inductor.

The data sheet inductor achieves higher efficiency but is a 0806 size and taller.

Figure 2 shows the thermal performance of the EVM.

Figure 2. TPS62840 Thermal Performance (VIN = 3.6 V, VOUT = 1.8 V, IOUT = 750 mA)

Figure 3. Loop Response (VIN = 3.6 V, VOUT = 1.8 V, IOUT = 750 mA)

Board Layout

www.ti.com

6SLUUC17–May 2019

Submit Documentation Feedback

TPS62840-1YBGEVM56 User's Guide

4 Board Layout

This section provides the TPS62840-1YBGEVM56 board layout and illustrations in Figure 4 through

Figure 8. The Gerbers are available on the EVM product page: TPS62840-1YBGEVM56.

Figure 4. Top Assembly

www.ti.com

Board Layout

SLUUC17–May 2019

TPS62840-1YBGEVM56 User's Guide

Figure 5. Top Layer

Board Layout

www.ti.com

8SLUUC17–May 2019

Submit Documentation Feedback

TPS62840-1YBGEVM56 User's Guide

Figure 6. Internal Layer 1

www.ti.com

Board Layout

SLUUC17–May 2019

TPS62840-1YBGEVM56 User's Guide

Figure 7. Internal Layer 2

Board Layout

www.ti.com

10 SLUUC17–May 2019

Submit Documentation Feedback

TPS62840-1YBGEVM56 User's Guide

Figure 8. Bottom Layer

Tabla de contenidos

Otros manuales de Convertidor de medios de Texas Instruments

Texas Instruments

Texas Instruments ADS5410 EVM Manual de usuario

Texas Instruments

Texas Instruments PCM2704 Manual de usuario

Texas Instruments

Texas Instruments HPA070 Manual de usuario

Texas Instruments

Texas Instruments TPS40003 Manual de usuario

Texas Instruments

Texas Instruments DAC 3202 Series Manual de usuario

Texas Instruments

Texas Instruments TPS6104 Series Manual de usuario

Texas Instruments

Texas Instruments DM365 Manual de usuario

Texas Instruments

Texas Instruments UCC28517 Manual de usuario

Texas Instruments

Texas Instruments UCC2977EVM Manual de usuario

Texas Instruments

Texas Instruments TPS6204xEVM Manual de usuario

Texas Instruments

Texas Instruments TPS549B22EVM-847 Manual de usuario

Texas Instruments

Texas Instruments DAC1006 Manual de usuario

Texas Instruments

Texas Instruments THS1031 Manual de usuario

Texas Instruments

Texas Instruments EUROTEXT CF70200 Manual de usuario

Texas Instruments

Texas Instruments TMS320DM36X Manual de usuario

Texas Instruments

Texas Instruments TPS40090EVM-002 Instrucciones de instalación y funcionamiento

Texas Instruments

Texas Instruments TPS61041 Manual de usuario

Texas Instruments

Texas Instruments LP87524B-Q1 Manual del producto

Texas Instruments

Texas Instruments MSC1210 Manual de usuario

Texas Instruments

Texas Instruments DAC63202W Manual de usuario

Texas Instruments

Texas Instruments LM5181-Q1 Manual de usuario

Texas Instruments

Texas Instruments TL5001EVM-097 Manual de usuario

Texas Instruments

Texas Instruments TPS543C20EVM-054 Manual de usuario

Texas Instruments

Texas Instruments ADS79 EVM-PDK Series Manual de usuario

Manuales populares de Convertidor de medios de otras marcas

SoundTraxx

SoundTraxx Blunami BLU-2200 Manual de usuario

SPROLINK

SPROLINK VA1 Manual de usuario

Acclaim Lighting

Acclaim Lighting DDC-1-AC Manual de usuario

Nikon

Nikon AF-S TC-20E III Manual de usuario

Axis

Axis AXIS Q7406 Manual de usuario

Omega

Omega TAC80B-J Manual de usuario

Zoom

Zoom Thunderbolt TAC-2R Manual de usuario

OST

OST iConverter 10/100M Manual de usuario

Vertiv

Vertiv Netsure Manual de usuario

birddog

birddog MINI Manual de usuario

Roland

Roland GI-10 Manual de usuario

Wallenstein

Wallenstein WX310 Manual de usuario

Pace

Pace MSS 200-1 Manual de usuario

Solar Converters

Solar Converters EQ 12/24-50 Manual de usuario

CYP

CYP EL-7400V Manual de usuario

TIE

TIE MIDI 1i1o Manual de usuario

DCS

DCS Vivaldi Upsampler Manual de usuario

Westermo

Westermo MCW-211 SERIES Manual de usuario