Page V
1. GENERAL INDEX Page
1.GENERAL INDEX V
2.GENERAL INFORMATION AND REQUIREMENTS 1
2.1MANUFACTURER 1
2.2TYPE AND FIELD OF USE 1
2.3PARTS GUIDE 2
2.3.1UPPER PANEL 2
2.3.2REAR PANEL 3
2.3.3STANDARD ACCESSORIES 3
2.4INTERNAL MEMORY 4
2.5POWER SUPPLY 4
2.6APPLIED REGULATION 4
3.USING THE RECORDER 5
3.1POSITIONING AND CONNECTING TO THE MACHINE 5
3.2SWITCH-ON 5
3.3ACCESS TO THE MAIN MENU 6
3.4SETTING THE WORK PARAMETERS 6
3.4.1SETTING THE ROPE DIAMETER 6
3.4.2SETTING THE SAMPLING 7
3.4.3SETTING THE LIMIT VALUE 7
3.4.4SETTING THE TYPE OF PRINT 7
3.4.5SETTING THE UNITS OF MEASUREMENT 7
3.4.6SETTING THE LANGUAGE 8
3.5SETTING THE CLOCK 8
3.5.1SETTING THE DAY 8
3.5.2SETTING THE DATE 8
3.5.3SETTING THE MONTH 8
3.5.4SETTING THE YEAR 9
3.5.5SETTING THE HOURS 9
3.5.6SETTING THE MINUTES 9
3.5.7SETTING THE SECONDS 9
3.6SETTING THE DISPLAY CONTRAST 9
3.7BEGINNING AND END OF THE MONITORING PROCESS 10
3.8FULL MEMORY 12
3.9MANAGING SAVED AND PRINTED CABLE LAYING OPERATIONS 12
3.9.1DISPLAY CABLE LAYING OPERATIONS 13
3.9.2PRINT CABLE LAYING OPERATIONS 13
3.9.3SAVING AN INDIVIDUAL CABLE LAYING PROCESS 14
3.9.4SAVING ALL THE CABLE LAYING OPERATIONS 15
3.9.5DELETING AN INDIVIDUAL CABLE LAYING PROCESS 16
3.9.6DELETING ALL THE CABLE LAYING OPERATIONS 16
3.10REPLACING THE PAPER ROLL. 17
ATTENTION! 18
4.SETTING CONSTANTS AND CALIBRATIONS 19
4.1STEPS TO SET CONSTANTS AND CALIBRATIONS 19
4.1.1SETTING THE COMPANY NAME 19
4.1.2SETTING THE DIGITAL PARAMETERS 19
4.1.3SETTING THE ANALOGUE PARAMETERS 21
4.1.4SETTING THE FUNCTIONAL PARAMETERS 23
4.1.5SETTING THE CALIBRATIONS 24
4.1.6SETTING THE SERIAL NUMBER 27
4.1.7SETTING THE COUNTER 27
4.2CONFIGURATION MANAGEMENT PROCEDURE 28
4.2.1RESTORE FROM A PEN DRIVE 28
4.2.2WRITE TO A PEN DRIVE 28
4.2.3PRINT CONFIGURATION 29
4.2.4LOADING A NEW LANGUAGE 31
4.2.5RESTORING THE DEFAULT CONFIGURATION 31
5.MANAGING ERRORS 32
5.1ERROR 1 – CHECK GENERAL PARAMETERS 32
5.2ERROR 2 – EPROM ERROR 32
