DEVICE LIST (SETUP APP)
Once your devices have been added to the list, you can check the most
important status information of each unit at a glance. You will be able to monitor
the level meter, recording file format, recording time, frame rate, timecode,
battery status, Bluetooth range, device icon and name.
If a TRACK E is out of Bluetooth range for more than 10 seconds, the status and
timecode of it will be maintained. If the app hasn't received any updates for more
than 10 minutes, the message will be Last seen x minutes ago.
Depending on the physical distance of a Tentacle device to your mobile device,
the status information in the list will be highlighted. The closer the TRACK E
gets to your mobile device the more saturated the color will be.
Remove a TRACK E from the device list
You can remove a Tentacle. TRACK E from the list by swiping to the left (iOS) or
long pressing (more than 2 sec.) on the Tentacle (Android).
DEVICE WARNINGS
Devices have to be synchronized:
This warning message is displayed, when
inaccuracies of more than half a frame occur between all devices in Green Mode.
Sometimes this warning can pop up for a few seconds, when starting the app
from background. In most cases the app just needs some time to check the
information of each Tentacle device. However, if the warning message persists
for more than 10 seconds you should consider re-syncing your Tentacles.
SLEEP MODE
In sleep mode, your TRACK E is saving battery and can be remotely woken up.
Send all your TRACK E to sleep by swiping up the bottom sheet and pressing the
SLEEP button. Wake up the devices by pressing the WAKE button. You can wake
them individually by pressing on the TRACK E in the device list. You have to re-
sync your devices after wakeup. Also note that connecting a sleeping TRACK E
to USB power it o
.
Please note:
Sleep mode is supported by Firmware version 2.2.0 or newer.
