Tennant 613087 Manual de usuario

KIT NO. 613087

36V TRANSAXLE REPLACEMENT KIT

Page 1 of 2

613088 Rev. 00 (02–02) Tennant Company Commercial Products Printed in U.S.A

INSTALLATION INSTRUCTIONS:

(Installation Time: 2 hours)

TOOLS REQUIRED: 7/16”, 9/16”, 11/16” Socket Wrench,

Small Flat Head Screwdriver and Snip Pliers.

1. Remove batteries from machine, 9/16”

wrench required.

FOR SAFETY: When servicing machine, wear

safety glasses and protective gloves when

handling batteries or battery cables. Avoid con-

tact with battery acid.

2. With adequate assistance, carefully turn

the machine upside down to access the

drive transaxle motor (Figure 1).

Fig. 1

3. Remove the wheels from the old transaxle,

7/16” socket wrench required (Figure 2).

Fig. 2

KIT CONTENTS

P/N. Description Qty.

612845 TRANSAXLE, 36V MOTOR, 116 RPM 1

612908 ADAPTER, WIRE TRANSAXLE 1

140501 NUT, 1/4–20 8

602881 BRACKET, TRANSAXLE MOUNT 1

130040 WIRE TIE 6.0 x .12 2

4. Carefully cut the wire-tie that secures the

motor’s wire harness, then unplug the wire

harness connector. Use a small flat head

screwdriver to disengage the connector

plug (Figure 3).

Fig. 3

5. Remove the transaxle mounting brackets

and motor guard bracket,11/16” wrench re-

quired. Then remove the old transaxle from

the machine (Figure 4).

Fig. 4

Home

Page 2 of 2

KIT NO. 613087

36V TRANSAXLE REPLACEMENT KIT

INSTALLATION INSTRUCTIONS –Continued

613088 Rev. 00 (02–02) Tennant Company Commercial Products Printed in U.S.A

6. Install the new transaxle on the machine.

Use the existing mounting hardware

including the supplied axle mounting

bracket, if needed. Use soapy water to

slide brackets over rubber mounts if

necessary. Make sure to reinstall the shim

on the side shown below (Figure 5).

NOTE: If your machine

was equipped with a motor

guard bracket, dispose of

bracket. It is not required

with new transaxle.

NOT REQUIRED

Use Shim

Fig. 5

7. Reinstall the old wheels on the new trans-

axle. Use existing washers with the new

nuts supplied with the kit.

8. Connect the transaxle wiring to the

machine using the transaxle wire adapter

supplied with the kit (Figure 6).

Fig. 6

9. Secure the transaxle wire adapter with

wire–ties supplied (Figure 7).

Fig. 7

10. Carefully turn the machine to the upright

position and reinstall the batteries (Figure 8).

Connect Last

–

CHARGER PLUG

MACHINE

FRONT

BLK

RED 31

RED

Fig. 8

FOR SAFETY: When servicing machine, wear

safety glasses and protective gloves when

handling batteries or battery cables. Avoid con-

tact with battery acid.

11. Test the machine for proper operation.

Turn the speed control knob to the slowest

setting and rotate the control grips com-

pletely forward. The machine should begin

to move slowly at a maintained speed. With

the grips still rotated completely forward,

gradually turn the speed control knob to the

maximum speed. The machine should be-

gin to accelerate to the maximum speed.

Home

Otros manuales de Máquina de piso de Tennant

Tennant

Tennant 1530 Manual del producto

Tennant

Tennant 8010 Manual de capacitación

Tennant

Tennant 355 Manual de usuario

Tennant

Tennant ATLV 4300 Manual de capacitación

Tennant

Tennant 8410 Manual de usuario

Tennant

Tennant 5100 Manual del producto

Tennant

Tennant 5400 Manual del producto

Tennant

Tennant 3610 Manual del producto

Tennant

Tennant 186 Manual de usuario

Tennant

Tennant sentinel Manual de usuario

Tennant

Tennant 1240 Manual del producto

Tennant

Tennant 550 Manual de usuario

Tennant

Tennant 92 GR Manual de usuario

Tennant

Tennant 1520 607649 Manual del producto

Tennant

Tennant i-team i-mop xxl Manual de usuario

Tennant

Tennant 1230 Manual del producto

Tennant

Tennant 5280 Manual de usuario

Tennant

Tennant S30 Manual de usuario

Tennant

Tennant T1 Manual de usuario

Tennant

Tennant SpeedGleam 5 Instrucciones de funcionamiento e instalación

Tennant

Tennant 186E Manual de usuario

Tennant

Tennant 608808 Manual del producto

Tennant

Tennant BR-1200-NDC Manual de usuario

Tennant

Tennant 7400 Manual de usuario

Manuales populares de Máquina de piso de otras marcas

Nilfisk-Advance

Nilfisk-Advance Advance SC370 17B Manual de usuario

Numatic

Numatic ET 4045 Manual de usuario

HAWK ENTERPRISES

HAWK ENTERPRISES HP1513-180BRUTE Manual de usuario

Mytee

Mytee 8070 Mytee-Lite Manual de usuario

Kärcher

Kärcher B 140 R Manual de usuario

Triple S

Triple S Ace 26T1 Manual de usuario

Nilfisk-Advance

Nilfisk-Advance SW 750 Manual de usuario

Tornado

Tornado Marathon 2000 98190 Manual

Windsor

Windsor ADMIRAL Admiral 8 Manual de usuario

Numatic

Numatic TTB 1117/100 Manual de usuario

Nobles

Nobles Frontier Manual del producto

lavina

lavina 21-X Manual de usuario

KENT

KENT Edge 28B Manual de usuario

Windsor

Windsor BDP 51/2000C Manual de usuario

CleanFreak

CleanFreak DURA-18HD Manual de usuario

Nilfisk-Advance

Nilfisk-Advance Warrior 34RST Guía del administrador

BETCO

BETCO PB24 Manual de usuario

IPC

IPC CT51-71 BT Manual de usuario