4 5
1. GENERAL INFORMATION
1.1 Introduction
This manual describes the functions of the „Oyster® TV“ and how to operate it.
1.2 Scope of supply
Scope of supply: „Oyster® TV“ with remote control, cable for connection to on-board system.
1.3 Intended use
Intended use: This product is designed to be used as TV set or monitor in recreational vehicles such as motorho-
mes or camper trailers. The vehicle manufacturer‘s specifications must be observed when mounting the product
to the wall. Only mounting elements complying with the VESA standard maybe used.
Setting up the device on its base is only permissible while the vehicle is parked and secured against rolling away.
Power to the system must be supplied by a standard vehicle electric system with a rated voltage of 12/24 V DC.
Do not use a switching-mode power supply if the system is to be installed in a camper trailer.
Using the equipment for any other than its intended purpose is not permissible.
1.4 Safety precautions
Your satellite system is approved by the manufacturer for connection to standard commercially available re-
chargeable lead batteries with a rated voltage of 12/24 V DC and a rated capacity of at least 50 Ah.
The manufacturer accepts no liability for direct or indirect damage or for consequential damage to the system
itself, to battery systems, motor vehicles or other equipment or goods resulting from the connection of unsuita-
ble battery systems or installation/wiring errors.
2. CONTROL ELEMENTS
2.1 Remote control
Button Function
POWER: In standby mode, this button will switch the
“Oyster®TV” with integrated receiver into operating mode.
0 – 9 NUMBER BUTTONS: Press one of the number but-
tons (0 – 9) to directly select a channel or enter a number
via the menu.
EPG / ELECTRONIC PROGRAMME GUIDE Press this button
to show the current and upcoming programmes for each
channel. A 7-day preview is available as well.
EXIT: Press this button to exit the menu without saving
any changes.
MUTE: Press this button to mute all audio outputs of the
receiver. Press the button again to restore audio playback.
Without function
TIME
SHIFT Time-shifted TV playback via USB memory
RECALL: Press this button to return to the previous
channel.
For Personal Video Recorder function – via USB
For Personal Video Recorder function – via USB
For Personal Video Recorder function – via USB
For Personal Video Recorder function – via USB
SOURCE Selection of input signal / source
Recording directory
OK
OK / ENTER: Press this button to save your selection or
menu settings.
Press this button to open the channel list
EXIT
SWAP
