• The scooter is for teenagers. It is not a toy. It is a means of transport and
not designed for extreme sports such as jumps, ramps, ollies, etc. Under no
circumstances must the product be used in a skatepark for “aggressive” use
(gures,etc.).
• Usewithcautiononclean,dryatsurfacesandifpossibleawayfromother
users. Respect the road safety regulations.
• Checklocallawsconcerningtheuseofscooters.Respectallthetrafcrulesand
road signs. Keep away from pedestrians or users on the public highway.
• Preferablyuseonat,cleansurfacesfreefromgravelorgrease.Avoidbumps
and drain gratings likely to cause an accident.
• Shoes must be worn and we strongly advise you to wear trousers and long-
sleeved shirts to avoid injury if you fall.
• Warning. Wear personal protection equipment including: wrist guards, gloves,
knee and elbow protectors and a helmet.
• Donotuseinthedarkwithoutusingobvioustrafclight.
• The electric scooter is not designed for acrobatics. Do not attempt to jump or
execute dangerous manoeuvres.
• Do not ride more than one person on the scooter.
• You are advised not to leave the electric scooter outside in damp or wet
conditions.
• Do not touch the hub motor located in the rear wheel when in use or immediately
after riding.
7 - MAINTENANCE
• Warning. As with any mechanical component, your product is subject to high
stresses and wear. The various materials and components may react differently
to wear or fatigue. If the expected service life for a component has exceeded,
it may break suddenly, therefore risking causing injuries to the user. Cracks,
scratches and discoloration in the areas subject to high stresses indicate that the
component has exceeded its service life and should be replaced.
• Caution: the rear wheel has a motorised part which can only be dismantled or
changedbyaqualiedtechnician.
• Do not change any motorised parts yourself or the warranty will be invalidated.
ContactyourdealerforaqualiedtechnicianorcontactGlobber,
contact@globber.com
• The lithium battery: To guarantee the battery lifetime, charge it when its level
is low. If it is not used for a long period of time, you are advised to charge it
onceamonth.Ifyouwishtocheckthebatteryorchangeit,contactaqualied
technician or a Globber representative.
The recommended storage temperature for the battery is between 5°C and
30°C.
• Do not use or place the electric scooter in an environment where the
temperature exceeds 40°C to avoid any lithium battery malfunction which may
leadtoitcatchingre.
• Never store the electric scooter in a car during hot weather to avoid any danger
of this.
• Bearings: avoid riding through water, oil or sand which would damage your
bearings. To maintain your bearings, check regularly that the front wheel turns
properly by turning the electric scooter upside down and pushing the wheel with
yourngers.Ifthefrontwheeldoesnotturn,removeitandcheckthecondition
of the bearings. First unscrew the wheel axle. Remove the axle and remove the
wheel. Carefully push the two bearings out of their seating. If they are chipped or
crushed, buy new ones. If there is no visible damage, oil them. To do so, remove
any traces of grease, mud or dust from the bearing using a paper towel or a
cloth then grease them either with a self-lubricating spray or by soaking them
in oil overnight (turn the bearings several times in the oil before leaving them to
soak).Retthebearingsandaxle,thenthefrontwheel.
• The wheels: the wheels wear out after a certain length of time or may even
develop holes if the scooter is used on rough surfaces too much. This is
particularly true of the rear wheel on which the brake is applied. Check them
regularly and have them changed for better safety.
• Productmodications:theoriginalproductmustbynomeansbemodied
except for the maintenance-related changes mentioned in these instructions.
• Nuts, axles and other self-locking fasteners: these should also be checked
regularly. They can become loose after a while in which case they should be
tightened. They can become worn and not tighten properly, in which case they
should be replaced.
8 - DISPOSAL OF END-OF-LIFE APPLIANCE
• The appliance must be disconnected from the mains supply when removing the
battery.
• The battery must be removed from the appliance before the appliance is
discarded.
• The battery must be disposed of safely by taking it to the most suitable collection
point.
7
ENGLISH
