Telikou TF-204 Manual de usuario
TELIKOU
Intercom System
TF-204 Two Channel Four Wire Interface
Instruction Manual
© 2006 TELIKOU Systems
All Rights Reserved
While TELIKOU makes every attempt to maintain the accuracy of the information contained in its
product manuals, that information is subject to change without notice
TELIKOU TF-204 Four-Wire Interface
I. Instruction
Thank you for choosing TELIKOU intercom product. Before use, we recommend you
read through this manual to better understand the function of TF-204. If you have any
question that does not addressed on this manual, please contact your dealer or call us.
We are standing by to assist you.
The TF-204 4-wire interface enables up to two 4-wire devices to interface with the
TELIKOU intercom system. It matches standard 600 ohm transmit/receive lines ( at
normal levels) to TELIKOU line level. The panel setting for TF-204 is simple.
II. Basic operations
Front Panel
zSidetone Adj.
1. Sidetone Monitor Plug
6.35mm, 1/4inch headset plug
2. SidetoneAdjust
Unsatisfied sidetone could cause feedback between input and output. In either of these
cases, you should minimize the amount of sidetone.
Sidetone Adjustment Procedure:
A) Set Link switch (LINK A+B) to OFF position.
B) Turn the Output Level control turns to the half way by clockwise.
C) Turn the Input Level control on Channel A by clockwise slowly. Find a comfort
hum listening level .
D) Adjust the sidetone adjusting control. There should be a point where the voice is
the lowest or disappeared.
1
TELIKOU TF-204 Four-Wire Interface
Repeat this procedure for Channel B.
zOutput Level
3. Output Level Indicator
Green light indicates output level normal.
Red light indicates output level high.
4. Output Level ParticularAdjustment
Adjust the Output level which transmits from terminal block connector pin 3 and 4.
The position of the Output level control should provide a strong average green light
on the LED indicator. This occurrence indicates a 0dB line level on 600ohm line. Red
light indicates exceeded output level. Occasional transitions to a red light are
acceptable.
5. Output Level RawAdjustment
Output selections switch:
1 Dyn.Mic:
Simulation dynamic microphone;
Resistance: 100 ohm;
Level: -70dB - -30dB (1 KHz)
2 Line:
Simulation line output;
Resistance: 600 ohm;
Level: -25db - +12dB (1 KHz)
zInput Level
6. Input Level Adjustment
Adjust the Input Level on the interface to fit different input signal level.
zLink
7. Link A+B
Channel A and Channel B can connect to a group of 4-wir device individual.
When this switch is set to the Off position. Channel A and Channel B are individual,
and they can not communicate to each other.
2
TELIKOU TF-204 Four-Wire Interface
When this switch is set to the ON position. Channel A and Channel B are connected to
each other.
Rear Panel
8. 4-wire In/Out
To connect a 4-wire device to the interface, for each module, attach one set of 4-wire
output lines to one set of terminal block connectors on the TF-204 rear panel. On the
terminal block, pins 1 and 2 are for input (IN) and pins 3 and 4 are for output (OUT).
NOTICE: In the external 4-wire link, any artificial sidetone leakage from the
TRANSMIT to the RECEIVE signal must be eliminated as much as possible.
9. Intercom Line connector
3-pin XLR female socket
The pinout of the intercom connectors is as follows:
Pin 1 --- Common (Shield)
Pin 2 --- Power (+24 VDC)
Pin 3 --- Audio
III. Installation
TF-204 adopts 19-inches 1U cabinet, and this workstation can be mounted on rack or
placed on desktop. If it is placed on desktop, it is required to adhere 4 rubber foot
pads provided with machine to four corners at the bottom of cabinet with double-face
adhesive tape.
IV Troubleshooting
Problem: System feedback (Acoustical)
Cause 1: Listen level control at this station or a remote station is set too high
Solution 1: Adjust
Cause 2: Sidetone null control at this station or a remote station is not adjusted
correctly
3
TELIKOU TF-204 Four-Wire Interface
Solution 2: Adjust. Refer to the procedure in the Front Panel section of this manual.
Set the MS-800 termination switch to the ON position.
Cause 3: A headset cord is too long or jointing quality .
Solution 3: Check headset cord
Problem: Hum or buzz in system
Cause 1: Inductive pickup caused by close proximity of this main station or connected
remote stations to power lines or transformers.
Solution 1: Relocate the offending unit.
Cause 2: Intercom line cable is not wired properly; the shield of microphone cable is
not connected to Pin-1 of 3-XLR
Solution 2: Check intercom line cable. Make sure all the cables’ Pin-1 of 3-XLR
connects correct.
Cause 3: 10 Ohm chassis ground resistor is open.
Solution 3: Bridge a 10 Ohm resistor between system ground (G) and earth ground
() of any power supply.
If this condition occurs, it is because the system ground came into contact with
something that was "HOT" with respect to the power supply earth ground.
Carefully check the system ground and AC distribution in the area.
V Technical Specification
Bandwidth:
40Hz – 8000Hz
Input:
Balanced;
Resistance : 10K ohm Bridge
4
TELIKOU TF-204 Four-Wire Interface
Output:
Isolated
Environmental
0°-70°C（32°-158°）
Dimensions
19” (W) x 1.75” (H) x 4.96” (D), 483mm x 44.5mm x 126mm
Weight
1.5kg
5
Tabla de contenidos
Otros manuales de Sistema de intercomunicación de Telikou
Telikou
Telikou FT-800 Manual de usuario
Telikou
Telikou MDS-400 Manual de usuario
Telikou
Telikou MS-500 Manual de usuario
Telikou
Telikou FT-800 Manual de usuario
Telikou
Telikou DT-100 Manual de usuario
Telikou
Telikou MS-200 Manual de usuario
Telikou
Telikou TM-200 Manual de usuario
Telikou
Telikou TM-800 Manual de usuario
Telikou
Telikou BK-1200 Manual de usuario
Telikou
Telikou TF-204 Manual de usuario
Telikou
Telikou SKYLINE SK-100 Manual de usuario
Telikou
Telikou BK-104 Manual de usuario
Telikou
Telikou IP-1X Manual de usuario
Telikou
Telikou BK-501 Manual de usuario
Telikou
Telikou WS-200 Manual de usuario
Telikou
Telikou FM-804 Manual de usuario
Telikou
Telikou BK-804 Manual de usuario
Telikou
Telikou MS-800 Manual de usuario
Telikou
Telikou BK-601 Manual de usuario
Telikou
Telikou TM-800 Manual de usuario
