17. Take the provided cab lift bolts, ½” x 4 ½” hex bolts and fasten to the mount nut located at
the top of the door behind the tab.
18. Use a lifting strap or chain, and connect the two lift bolts together. Prepare to lift the cab
up off of the shipping pallet with an over-head hoist or forklift.
19. Un-bolt the rear shipping bracket and the front shipping mount. Lift cab straight up.
Position the cab over the tractor and prepare to lower the cab down. The cab must come
straight down onto the tractor. Tighten or loosen the clamp as necessary that is keeping the
two post ROPS lower members together.
20. It is necessary to slide the rear shield of the cab onto the under-seat shield installed earlier
for proper sealing. The shield may need to bent back a little. The shield should seal at the very
back of the under seat shield.
21. Lower the cab straight down onto the front mount pad on the front bracket. Use the
provided 5/8” x 3” hex bolts, ¼” structural washer, and flange nut for the front isolator.
22. On the next photo, you can see which fastener is used for the rear mount location. Use the
provided 5/8” x 3” hex bolt, ¼” structural washer, and flange nut in the orientation as shown.
August 2021© Kubota B2301/2601 ROPS Cab Installation Manual
