10.2022 DIGITAL LOCKS & KEYS 9
in assigned functionality
094361
28643
139567
811254
5379
6924
1 2a 2b
094361
28643
139567
811254
5379
6924
3
4
Collect all remaining and replacement user credentials (User Codes and User Keys).
Insert the Manager Key again. ree sets of two-tone beeps will be heard, and the
LED will turn o. All previously assigned user credentials will be removed.
Follow Assign User Credentials instructions to assign the remaining and
replacement user credentials to the locks.
remove user credentials
Make sure the lock is in assigned use functionality (a green LED will ash when is pressed). e locks must be
reprogrammed to remove user credentials from operating a lock.
Press . e LED will ash. While the LED is ashing, insert a
valid Manager Key. A two-tone beep will be heard.
03.2022 DIGITAL LOCK S & KE YS
8
in assigned functionality
1a
2a
2b
1b
1a
2
1b
Assign User Codes:
Assign User Keys:
Press . e LED will ash.
While the LED is ashing, insert a valid Manager Key.
A two-tone beep will be heard, and the LED w ill tu rn on.
Go to a lock al ready programmed to
operate with the user credentials and
Manager Keys. Press .
e LED will ash.
*e Progra mming Key will continue to f unction in Express Registration mode until it is used to operate a lock.
Insert t he Programming Key to
program each lock to operate with the
same user credentia ls and Manager
Keys. Two sets of two-tone beeps will be
heard, and the LED will a sh twice to
indicate successful programming.
While the LED is ashing, insert the
Program ming Ke y. A two-tone beep
will be he ard, and the LED will turn
o.
End Express Registration mode:*
Go to any programmed lock.
Press then insert the
Programming Key.
Press . e LED will ash.
While the LED is ashing, insert a valid Manager Key.
A two-tone beep will be heard, and the LED w ill tu rn on.
While the LED is on, press [new 4-7 digit code] . A two-tone beep will be
heard. Press [the same 4-7 dig it code] . Two sets of two-tone beeps will be
heard, and the LED will turn o.
While the LED is on, insert a User Key. Two sets of two-tone beeps will be heard,
and the LED will t urn o.
assign user credentials
express register user credentials and manager keys
Make sure that the lock is set for assigned use functionality (a green LED will ash when is pressed). Up to 20 user
credentials (User Codes and/or User Keys) may be assigned to each lock.
Make sure the lock is set for assigned use functionality (a green LED will ash when is pressed). e Programming Key
can quickly program multiple locks to operate with the same user credentials and Manager Keys.
