3.5mm plugs going from the OP Z s
input or output to a mic input on a
sound card with phantom power
active. this could destroy the ports on
the OP-Z. be sure to charge the unit
using only 5v usb power, such as that
from the usb ports of a computer, or
by using a dedicated usb charger.
make sure you always have the OP-Z
placed so it is level and sure to remain
stable. use your OP-Z where the
ambient temperature is between 10°
and 35° C (50° and 95° F) and the
relative humidity is between 0 and
95%RH. never install or use the unit in
any of the following locations:
humid environments or baths and
washrooms.
•
safety-critical applications.•nuclear facilities and weapons
systems.
•
aerospace applications or
environments for
automotive
installations.
•
caution
risk of explosion if the battery is
replaced by an incorrect type.
store small parts out of the reach of
children and infants. if accidentally
swallowed, contact a doctor
immediately.
executed modifications. in particular,
you are the sole responsible for
damage caused by a charging method
other than 5V usb power. the general
warranty policy does not cover esd
(static discharge) damaged products
due to improper handling.
the warranty does not cover shipping
charges.
make sure to read the terms &
conditions here.
a class b digital device, pursuant to
part 15 of the fcc rules. these limits are
designed to provide reasonable
protection against harmful interference
in a residential installation. this
equipment generates, uses and can
radiate radio frequency energy and, if
not installed and used in accordance
with the instructions, may cause
harmful interference to radio
communications. however, there is no
guarantee that interference will not
occur in a particular installation.
if this equipment does cause harmful
interference to radio or television
reception, which can be determined by
turning the equipment off and on, the
user is encouraged to try to correct
the interference by one or more of the
following measures:
reorient or relocate the receiving
antenna.
•
increase the separation between the
equipment and receiver.
•
connect the equipment into an outlet
on a circuit different from that to
which the receiver is connected.
•
consult the dealer or an experienced
radio/TV technician for help.
•
this equipment complies with fcc
radiation exposure limits set forth for
an uncontrolled environment. this
transmitter must not be co-located or
operating in conjunction with any
other antenna or transmitter.
FCC
ID
:
Z23012A
1. this device may not cause
interference.
2. this device must accept any
interference, including interference that
may cause undesired operation of the
device.
l
ʼ
émetteur exempt de licence contenu
dans le présent appareil est conforme
aux cnr d
ʼ
Innovation, sciences et
développement économique canada
applicables aux appareils radio
exempts de licence. l
ʼ
exploitation est
autorisée aux deux conditions
suivantes :
1. l
ʼ
appareil ne doit pas produire de
brouillage;
2. l
ʼ
appareil doit accepter tout
brouillage radioélectrique subi, même
si le brouillage est susceptible d
ʼ
en
compromettre le fonctionnement.
this equipment complies with ic rss-
102 radiation exposure limits set forth
for an uncontrolled environment. this
transmitter must not be co-located or
operating in conjunction with any
other antenna or transmitter.
cet équipement est conforme aux
limites d'exposition aux radiations ic
cnr-102 établies pour un
environnement non contrôlé. cet
émetteur ne doit pas être situé ou
fonctionner conjointement avec une
autre antenne ou un autre émetteur.
CAN
ICES
-
3
(
B
)/
NMB
-
3
(
B
)
IC
: 99
15A
-
012A
