Equalizer
User can set the radio with different EQs, such as Normal, Classic, Jazz, Pop, Rock, Flat,
Movie and News.
Backlight
There are 3 brightness levels you can choose: High, Medium & Low.
1. Timeout: This option is used to set the period of time that you wish your display’s backlight
to remain lit when your radio is just playing without any operation is made.
The available options are: On /10sec /20sec /30sec /45sec /60sec /90sec /120 sec /180 sec.
Select “On” will force your radio’s backlight to remain on constantly. If you select a specific
time interval, after the selected time period has lapsed the display will dim down.
2. Level: This option will determine how bright the display’s backlight is lit while the radio is in
operation of the functions. Whenever the radio is powered up from Standby, the backlight will
adjust to the brightest level.
Backlight in Standby mode
The backlight will dim to the lowest level automatically in Standby. If you want to set the
dimmer level in Standby, you have to choose “On” under the “Timeout” menu first. In Standby,
press the <Dimmer> button on remote repeatedly to choose the level you desire.
Time/Date
There are 3 settings:
1. Set Time/Date: This allows the user to manually set the current Time and Date.
2. Set Format: This option will change the format of your clock to either 12 hour or 24 hour
format.
3. Auto Update: This function will set the radio’s time and date automatically with data sent
along with the broadcast of either the FM or DAB radio station. You can choose “No Update”
then the radio will not receive the time data.
Note:
The FM auto Time/Date update may not work in your area, so the DAB auto update option
is recommended.
Alarm
There are two alarms can be set in the radio, please refer to the above Alarm section.
Sleep
It allows you to set the sleep timer. The radio will turn in Standby itself when the time is due.
You can choose 15 minutes, 30 minutes, 45 minutes, 60 minutes, 90 minutes and 2 Hours.
If you wish to cancel the sleep timer function, select “Off” on the menu.
You can press <Sleep> button on remote control to set the sleep timer as well.
Factory reset
You can reset the radio to the factory default any time. Once a reset has been done, all
previous settings and preset will be erased and the radio will resume to the menu for mode
selection.
Information
Press to see the firmware version.
Language
There are two languages available for the menu, English and Norwegian.
Main Menu of FM mode
While the radio is in FM mode, press and hold the <INFO/MENU> button on the radio or press
the <Menu> key on remote control to enter the main menu. Most of the menus are the same as
DAB mode, with the additional options as follow:
Scan setting
You can choose to scan “Strong station only”.
Audio setting
You can set “Mono only”.
Main Menu of Bluetooth & Aux-In mode
When the radio is in Bluetooth or Aux-In mode, press and hold the <INFO/MENU> button or
pressing the <Menu> key on remote control to enter main menu. All of the menus have the
same function as the setting in DAB mode.
Q & A
If you are experiencing problems with your DAB radio there are some quick and easy checks
that you can do, which may help to solve the problem.
No DAB reception
-Please carry out “Factory Reset” on the radio and extend the antenna.
-Move the radio close to the window.
Radio reception is poor
- Please check that the aerial is extended for the maximum signal strength and improved
reception.
- Check that you do not have other electrical equipment too close to your radio, causing
interference.
No sound
- Adjust the volume using the Tune/Select knob.
- Please check that the mains power lead is connected at the back of the radio and the mains
power wall socket is switched on.
8
