TECO TK Series Manual de instrucciones
TK
GUIDELINE
OVERHEATING
PROBE
REPLACEMENT
MODELS :
TK3000 – TK6000 – TK 9000
www.tecoonline.com | www.tecous.com
EQUIPMEMT
Tongs
www.tecoonline.com | www.tecous.com
7 black clamps
Screw-drivers
Probe
with red connector
(spare part)
STEP n.
1
Disconnect the chiller form power supply.
Using the screw-driver, remove the screws indicated in the
picture here below (n°16 screws).
www.tecoonline.com | www.tecous.com
STEP n.
2
www.tecoonline.com | www.tecous.com
Disconnect ground wire from the cover
Remove the cover
STEP n.
3
www.tecoonline.com | www.tecous.com
Disconnect the RED probe connector from
main board.
Cut the black clamps inside the chiller that
embrace the probe’s wire.
STEP n.
www.tecoonline.com | www.tecous.com
Proceed to cut all black clamps that
embrace the probe’s wire.
Extract the wire from circular passage.
STEP n.
5
www.tecoonline.com | www.tecous.com
-Cut the last black clamp
that embrace the
probe’s wire and copper
pipe near condenser
-Extract the probe and
replace it
STEP n.
6
www.tecoonline.com | www.tecous.com
-Insert probe cable in circular passage
-Connect new probe connector to main board
-Take new seven black plastic clamps and
pinch the probe’s cable with the other cables
as it was at the beginning.
-Place the chiller cover in its position and then
place the sixteen screws to close the chiller.
ATTENTION: remember to connect
ground wire to the cover before closing the
chiller.
CONNECT
Otros manuales para TK Series
4
Este manual sirve para los siguientes modelos
3
Otros manuales de Enfriador de TECO
TECO
TECO TR 10 Manual de usuario
TECO
TECO TK Series Manual de instrucciones
TECO
TECO Tank TK 150 Manual de instrucciones
TECO
TECO CP5 Manual de servicio
TECO
TECO TK Series Manual de instrucciones
TECO
TECO TK 5K Manual de usuario
TECO
TECO TK Series Manual de instrucciones
TECO
TECO TK3000 Manual de usuario
TECO
TECO Tank TK 150 Manual de usuario
TECO
TECO ra 200 Manual de usuario
