Technoline WS9132 Manual de usuario

WS9132 Manual

Environmental reception effects

The station obtains the accurate time with wireless technology. Same

as all wireless devices, the reception is maybe affected by the

following circumstances:

long transmitting distance

nearby mountains and valleys

near freeway, railway, airports, high voltage cable etc.

near construction site

among tall buildings

inside concrete buildings

near electrical appliances (computers, TV’s, etc) and metallic

structures

inside moving vehicles

Place the station at a location with optimal signal, i.e. close to a

window and away from metal surfaces or electrical appliances.

Precautions

This main unit is intended to be used only indoors.

Do not subject the unit to excessive force or shock.

Do not expose the unit to extreme temperatures, direct sunlight,

dust or humidity.

Do not immerse in water.

Avoid contact with any corrosive materials.

Do not dispose this unit in a fire as it may explode.

Do not open the inner back case or tamper with any components

of this unit.

Batteries safety warnings

Use only alkaline batteries, not rechargeable batteries.

Install batteries correctly by matching the polarities (+/-).

Always replace a complete set of batteries.

Never mix used and new batteries.

Remove exhausted batteries immediately.

Remove batteries when not in use.

Do not recharge and do not dispose of batteries in fire as the

batteries may explode.

WS9132 Manual

Ensure batteries are stored away from metal objects as contact

may cause a short circuit.

Avoid exposing batteries to extreme temperature or humidity or

direct sunlight.

Keep all batteries out of reach from children. They are a choking

hazard.

Use the product only for its intended purpose!

Consideration of duty according to the battery law

Old batteries do not belong to domestic waste because

they could cause damages of health and environment.

You can return used batteries free of charge to your

dealer and collection points. As end-user you are committed by

law to bring back needed batteries to distributors and other

collecting points!

Consideration of duty according to the law of electrical devices

This symbol means that you must dispose of electrical

devices separated from the General household waste

when it reaches the end of its useful life. Take your unit

to your local waste collection point or recycling centre.

This applies to all countries of the European Union, and to other

European countries with a separate waste collection system.

WS9132 Manual

Features:

DCF Radio controlled time function

12/24 hour format

Daily Alarm Function

Snooze function (OFF or 1~60min)

Low battery indicator

Maximum /minimum value record of temperature and humidity

Temperature in °C or °F

Outdoor thermometer ice alert

Humidity measurable range: 20%RH ~ 95%RH

Temperature:

—Indoor temperature measurement ranges: -9.9°C (14.2°F) ~

50°C (122°F)

—Outdoor temperature measurement ranges: -25°C (-13°F) ~

50°C (122°F)

Remote Sensor:

—Wall Mount or Table Stand

—3 Channels selectable

—433.92MHz RF transmitting frequency

—30 meter transmission range in an open area

Weather forecasting function

Power Supply:

Weather Station:

Battery: 2 x LR03 AAA

Remote Sensor:

Battery: 2 x LR06 AA

WS9132 Manual

Weather Station Appearance

WS9132 Manual

Part A –Weather station

A1: Time

A2: Indoor temperature and humidity

A3: Ice alert icon

A4: Radio Controlled Icon

A5: DST icon

A6: Weather forecast pattern

A7: Outdoor temperature

A8: Operation buttons

A9: Stand cover

A10: Battery door

Part B –Remote sensor

B1: Transmit indicate LED

B2: Battery door

B3: Channel switch

B4: Reset button

Initial operation:

Open the Weather Station battery compartment cover

Insert 2 x AAA batteries observing polarity [ “+” and “ –“ marks]

When you insert the batteries, all icons on the LCD display will light

up for 3 seconds, you will hear a beep tone and the station detects

indoor temperature & humidity.

The Weather Station will now start to make a connection to the

outdoor remote sensor. This operation takes about 3 minutes and

is displayed by a flashing reception RF antenna symbol in the

“OUTDOOR” display area on the receiver.

Open Wireless Outdoor Sensor battery compartment cover, Insert 2

x AA batteries observing polarity [ “+” and “–“ marks].

WS9132 Manual

After receiver has created a connection to the outdoor remote

sensor, After 3 minutes it will enter the Radio control time receive

mode.

Reception of the DCF signal:

The clock will automatically search the DCF (radio controlled time)

signal after 3 minutes of any restart or changing of new fresh

batteries. The radio mast icon starts to flash.

At 1:00 /2:00 / 3:00 am, the clock automatically carries out the

synchronization procedure with the DCF signal to correct any

deviations to the exact time. If the synchronization attempt is

unsuccessful (the radio mast icon disappears from the display), the

system will automatically attempt another synchronization at the

next full one hour. This procedure is repeated automatically up to

total 5 times.

To start manual DCF signal reception, press and hold the “ ”

button for 3 seconds. If no signals received within 7 minutes, then the

DCF signal search stops (the radio mast icon disappears) and start

again at the next full one hour.

During RC reception，to stop searching radio signal, press the “”

button once.

Please note:

A flashing radio mast icon indicates that the DCF signal reception

has started

A continuously displayed radio mast icon indicates that the DCF

signal was received successfully

We recommend a minimum distance of 2.5 meters to all sources of

WS9132 Manual

interference, such as televisions or computer monitors

Radio reception is weaker in rooms with concrete walls (e.g.: in

cellars) and in offices. In such extreme circumstances, place the

system close to the window.

During the DCF reception mode, only the “ ” button has a

function, other buttons are not functional, If you want to carry out

other functions of operation, please press “ ” button to exit the

DCF receiving mode.

Manual settings:

Press and hold the “ ”, 12/24HR start to flash. Now use “+” and

“-” buttons to set the set 12 or 24 hour mode.

Press the “ ”button to confirm your setting. The time zone start

to flash. Now use “+” and “-” buttons set a time zone (-12 to +12).

For example for UK, the time zone is -01, for Germany it is 00.

Press the “ ”button to confirm your setting, the Hour display

starts to flash. Now use “+” and “-”buttons to set the hour.

Press the “ ”button to confirm your setting, the Minute display

starts to flash. Now use “+” and “-”buttons to set the minute.

Press the “ ”button to confirm your setting, the temperature

unit starts to flash. Now use “+” and “-” buttons to choose

between °C or °F temperature unit.

Press the “ ”button to confirm your setting, the barometric

pressure unit starts to flash, Now use “+” and “-”buttons to set the

barometric pressure unit in mB/hPa or inHg.

Press the “ ”button to confirm your setting, the barometric

pressure data starts to flash. Now use “+” and “-”buttons to set the

WS9132 Manual

barometric pressure data according to the local relative air

pressure.

If not changed, the value corresponds to the absolute air pressure.

Press the “ ”button to confirm your setting, the weather

forecast pattern starts to flash. Now use “+” and “-”buttons to set

the weather forecast pattern according to the current weather..

Press the “ ”button to confirm your setting and to end the

setting procedures, the display will return to the normal mode.

Please note:

If there is no valid operation within 20 seconds, the station will

automatically return to normal time mode from the set mode.

Setting the alarm:

Press “ ” button once, LCD displays the “ ” icon, the alarm

function is ON. Then press “ ” button once, the “ ” icon will

disappears from the display, the alarm function is OFF.

Press once “ ” button, LCD display alarm time, then press and

hold “ ” button for 3 seconds until the hour of alarm time starts

to flash. Use the “+” and “-” buttons to set the hour.

Press “ ”button to confirm your setting. The minute of the alarm

time starts to flash. Use the “+” and “-” buttons to set the minute.

Press “ ”button to confirm your setting. The snooze time starts

to flash. Use the “+” and “-”buttons to set the snooze time. The

snooze time can be set from OFF to 60 minutes.

Press “ ”button to confirm your setting and to end the setting

procedure.

WS9132 Manual

Please note:

If there is no valid operation within 20 seconds, the station will

automatically return to normal time mode from the alarm time set

mode.

The alarm will sound for 2 minutes if you do not deactivate it by

pressing any button. In this case the alarm will be repeated

automatically after 24 hours.

Rising alarm sound (crescendo, duration: 2 minutes) changes the

volume 4 times whilst the alarm signal is heard.

Switching off the alarm signal

Press any button except the “SNOOZE/LIGHT” button to stop the

alarm signal. It is not necessary to reactivate the alarm. It switches

itself automatically to the alarm time which has already been set.

Snooze function

When the alarm is ringing, press the “SNZ” button the alarm mode

to get to snooze mode. The alarm signal sounds again after already

been set. If OFF was selected in the SNOOZE time setting, the

alarm will not repeat.

RF Transmission Procedure:

The weather station automatically starts receiving transmission

from outdoor thermo sensor after batteries inserted.

The remote sensor will automatically transmit temperature signal to

the Weather Station after batteries inserted.

WS9132 Manual

If the Weather Station failed to receive transmission from outdoor

sensor (“- -.-”display on the LCD), press and hold the “CH”button

for 3 seconds to receive transmission manually. RF icon “ ”

flashes on the LCDof the Weather Station to receive the remote

sensor.

If the weather station is used with 2 or 3 transmitters, press “+/CH”

button shortly to display CH2, CH3 or cyclic display.

P re ss "+ /C H "

P re ss "+ /C H " P re ss "+ /C H " P re ss "+ /C H "

A u to m a tic A u to m a tic

A u to m a tic

5S 5S

Maximum/minimum temperature/humidity

Press “MEM” button once, the LCD will display maximum value of

temperature/ humidity. If the “MEM” button is pressed again the

minimum value is displayed.

While displaying MAX or MIN values, there is “MAX” or “MIN” on the

LCD.

Press and hold “MEM” button for 3 seconds. The

temperature/humidity maximum/minimum value will reset to the

current values

Please note:

Otros manuales para WS9132

Tabla de contenidos

Otros manuales de Estación meteorológica de Technoline

Technoline

Technoline WA3090 Manual de usuario

Technoline

Technoline WS 9040 Manual de usuario

Technoline

Technoline WS9130 Manual de usuario

Technoline

Technoline WS 9172 Manual de usuario

Technoline

Technoline WS6850 Manual de usuario

Technoline

Technoline WS 6600 Manual de usuario

Technoline

Technoline WS9620 Manual de usuario

Technoline

Technoline WS9252 Instrucciones de instalación

Technoline

Technoline WS 6710 Manual de usuario

Technoline

Technoline WS9251 Instrucciones de instalación

Technoline

Technoline WS-9136 Manual de usuario

Technoline

Technoline WS 6448 Manual de usuario

Technoline

Technoline WS 6720 Manual de usuario

Technoline

Technoline WS6620 Manual de usuario

Technoline

Technoline WS 6449 Manual de usuario

Technoline

Technoline WS 9065 Manual de usuario

Technoline

Technoline WT 171 Manual de usuario

Technoline

Technoline WS9470 Manual de usuario

Technoline

Technoline WS 9170 Manual de usuario

Technoline

Technoline WS9050 Manual de usuario

Technoline

Technoline WS 9422 Manual de usuario

Technoline

Technoline WS 9765 Manual de usuario

Technoline

Technoline Meteotronic WM 5412 Manual de usuario

Technoline

Technoline WS6447 Manual de usuario

Manuales populares de Estación meteorológica de otras marcas

Auriol

Auriol AHFL 433 A1 Manual de usuario

NexSens

NexSens G2-HYDROMET Manual de usuario

Hyundai

Hyundai WS 2202 Manual de usuario

IROX

IROX HBVR761 UV-X Manual de usuario

La Crosse Technology

La Crosse Technology C86371 Manual de usuario

ADE

ADE WS 1711 Manual de usuario

Auriol

Auriol z29592 Manual de usuario

Auriol

Auriol 296289 Manual de usuario

Hyundai

Hyundai WS 2266 Manual de usuario

La Crosse Technology

La Crosse Technology WS-2210 Manual de usuario

La Crosse Technology

La Crosse Technology WS-811561 Manual de usuario

Ventus

Ventus W177 Manual de usuario

National Geographic

National Geographic VA Colour RC Manual de usuario

Renkforce

Renkforce 1208067 Manual de usuario

Levenhuk

Levenhuk Discovery Report WA40 Manual de usuario

Instant Transmission

Instant Transmission MA 10410 Manual de usuario

Lutron Electronics

Lutron Electronics PHB-318 Manual de usuario

WAREMA

WAREMA EWFS Weather station eco Manual de usuario