Technoline WS 6730 Manual de usuario
WS 6730 Instruction manual
Main UnitAppearance
Part A- LCD
A1: Radio Controlled Icon A2: Date
A3: Weather Forecast A4: Past Hour (Pressure History)
A5: Barometric Pressure Bar Graph. A6: Indoor Temperature and Humidity
A7: Outdoor Temperature and Humidity
A8: Radio Controlled Time Display A9 : Day of Week
A10: Barometric Pressure Trend A11: . Barometric Pressure Reading
A12: Selected Outdoor Channel
Part B- Buttons
B1: “MODE/SET” button B2: “SNOOZE/LIGHT “ button
B3: “AL ON/OFF” button. B4: “CHANNEL “ button
B5: “ALERT” button B6: “HISTORY” button
B7: “+(12/24)” button B8:” IN MEN” button
B9: “▲” button B10: ”▼In C/F ” button
B11: ” - C/F / ” button B12: “OUT MEN” button
B13: “RESET” button
Part C- Structure
C1: Wall Mount Hole C2: Battery Compartment
C3: Stand.
Thermo & Hygro Sensor Unit’s Appearance.
D2: Outdoor Temperature D1: Transmission Indication LED
D3: Wall Mount Hole D4: °C/°F” button
D5: Channel Selecting Switch D6: “TX” button
D7: Battery Compartment D8: Stand
Set Up:
yInsert batteries.
yUse a pin to press the RESET (B13) button
Weather Forecast Function:
zAfter Batteries inserted, or holding “HISTORY” button (B6) for 3 seconds, Pressure Reading’s digits
flashes(A3). Enter the height,in meter, of the Main Unit above sea level by pressing “▲“ (B9) or
“▼“ (B10) buttons. Press “HISTORY” button (B6) to confirm the setting. After entered the height, the
Pressure Reading shows the Barometric Pressure at the sea level. The weather forecast may not
be accurate if the height entered is not correct.
zThe current weather status should be entered again if the altitude of the Main Unit is changed.
( Barometric pressure is lower at higher altitude location. Therefore, altitude change will affect the
weather forecast)
zTotally 5 different weather condition in the weather forecast.
“ ” means Sunny .
“ ” means Slightly Cloudy.
“” means Cloudy.
“” means Rainy
“” means Cloudburst.
zIf there is any inconsistency of weather forecast between Local Weather Station and this unit, the
Local Weather Station's forecast should prevail. We will not held responsible for any trouble that
may come up due to wrong forecasting from this unit.
zThe trend pointer (LCD A10) indicates the trend of the barometric pressure.
“” indicates the barometric pressure trend is increasing.
“” indicates the barometric pressure trend is steady.
“” indicates the barometric pressure trend is decreasing.
Barometric Pressure Meter
Press “HISTORY” button (B6)
zHold “ ▲” button (B9) for three seconds to select the unit for Barometric Pressure reading in inHg or
mb / hPa.
zPress “ HISTORY” button (B6) to view the past 12 hour Barometric Pressure history.
The hour is indicated on the LCD.
0 HR = Current Barometric Pressure Reading
-1HR = Barometric Pressure Reading in 1 hour ago
-2HR = Barometric Pressure Reading in 2 hour ago ……..etc
Outdoor Thermo Sensor Unit Registration Procedure:
zThe main unit automatically starts receiving transmission from Outdoor Thermo and humidity
Sensor after Battery inserted. Outdoor digits (A7) blinks.
zInsert the batteries in the Thermo Sensor Unit. The sensor unit automatically transmit temperature
to the main unit. ( Battery compartment (D7) of thermo sensor is located behind the back cover,
unscrews to open.)
zFor having more than one external transmitter (Maximum3), select the Channel, CH1, CH2 or CH3
to ensure each sensor is transmitting at difference channel before inserting batteries. The channel
selecting switch (D5) is at the back of the thermo sensor unit.
zPress “ TX “ button (D6) on the thermo sensor unit to transmit temperature to the main unit
manually. The main unit gives a “beep” sound if it received the temperature.
Display Outdoor Temperature :
zPress “ CHANNEL” button (B4) to view the 3 Channels. The sequence is shown as follow:
Press Press Press
“CHANNEL” button “CHANNEL” button “CHANNEL” button
Display the three channels alternatively
zHold “ CHANNEL” (B4) button for 3 seconds to cancel unused channel. It will automatically register
a new channel again if a new channel is received.
If there is no temperature displayed in existing channel ( “ - - . –“ is displayed on the LCD ), hold
“CHANNEL” button (B4) for 3 seconds to cancel that channel and receive the channel again
(“Beep” sound can be heard.) Then, press “ TX “ button (D6) on the thermo sensor unit to transmit
signal to the main unit manually
zThe trend pointer displayed indicates the trend of the outdoor temperature.
“” indicates the outdoor temperature is increasing.
“” indicates the outdoor temperature is steady.
“” indicates the outdoor temperature is decreasing.
zPress “ °C /°F” button (D4), on the Thermo Sensor unit, to select Temperature to be displayed in
Celsius mode or Fahrenheit mode.
Maximum/Minimum Temperature/Humidity recording function:
zPress “IN MEN” button (B8) to show the maximum or minimum of indoor temperature/humidity.
Press “OUT MEN” button (B12) to show the maximum or minimum of outdoor temperature/humidity.
“” is shown on the LCD if maximum temperature/humidity is shown.
“ ” is shown on the LCD if minimum temperature/humidity is shown.
yHold “IN MEN” button (B8) or “OUT MEN” button (B12) for 3 seconds to clear the recorded
maximum and minimum reading.
Temperature Alert function:
zHold “ ALERT” button (B5) for 3 seconds to enter Temperature Alert setting, Temperature’s digits
flash.
zPress “ +” (B7) or “-” (B11) button to select Indoor or Outdoor CH1, CH2 and CH3 temperature alert.
Press “ALERT” button (B10) to confirm the setting.
zPress “ +” (B7) or “-” (B11) button to set the upper ” ” and lower “ ” limit of the temperature.
Press “ALERT” button (B5) to confirm the setting.
zPress “ ALERT” button (B5) to set the Temperature Alert function on or off ( “ ” appears on the
LCD if this function is on).
Radio Controlled Clock:
zAfter registered new channels or press “CHANNEL” button (B4) to stop scanning, the clock will then
scan the DCF time signal ( “ ” flashes on the LCD ). Buttons will not function while scanning
for DCF or Thermo sensor’s signal unless they are well received or stopped manually.
zThe clock automatically scans the time signal at 3.00 a.m. everyday to maintain accurate timing.
For failed reception, scanning stops ( “ ” on the LCD disappear ) and repeats again at 4.00
a.m. 5.00a.m. and 6.00a.m.
zThe clock manually scans the time signal by holding “ - ” button (B11) for 3 seconds. For failed
reception, scanning stops. ( “ ” on the LCD disappear ).
zHold “-” button (B11) for 3 seconds to stop scanning when receiving DCF signal.
“” flashes indicate now is receiving DCF signal
“” turns on indicate signal received successfully
zDST is shown on the LCD is it is in Daylight Time Saving Mode
Manual Time Setting:
zHold “ MODE/SET” button (B1) for 3 seconds to enter Clock/Calendar setting Mode .
zPress “+” (B7) or “-” (B11) buttons to adjust the setting and press “MODE” (B1) button to confirm
each setting.
zThe setting sequence is shown as follow: Hour, Minutes, Second, Year, Month/Day sequence,
Month, Day, Time Zone, Day-of-week language.
z8 languages can be selected in Day-of-week, they are: German, English, Russian, Denmark, Dutch,
Italian Spanish and French,. The languages and their selected abbreviations for each day of the week
are shown in the following table.
Language
Sunday
Monday Tuesday Wednesday Thursday Friday Saturday
German, GE SO MO DI MI DO FR SA
English, EN SU MO TU WE TH FR SA
Russian, RU BC NH BT CP HT NT CY
Denmark, DA SO MA TI ON TO FR LO
Dutch, NE ZO MA DI WO DO VR ZA
Italian, IT DO LU MA ME GI VE SA
Spanish, ES DO LU MA MI JU VI SA
French, FR DI LU MA ME JE VE SA
zThe Time zone is used for the countries where can receive the DCF time signal but the time zone is
different from the German time.
zWhen the country time is faster than the German time for 1 hr, the zone should be set to +1. Then
the clock will automatically set 1 hour faster from the signal time received.
12/24 Hour Display mode:
yPress “ +12/24” button (B7) to select 12 or 24 hours mode.
Snooze Alarm Clock Function:
zPress “ MODE/SET” button (B1) to select to view:
Time Alarm Time1 (“ “ Shown on the LCD) Alarm Time 2 (“ “ Shown on the LCD)
zWhen viewing Alarm Time 1 or Alarm Time 2, hold “MODE/SET” button (B1) for 3 seconds to enter
that Alarm Time setting. Press “ +” (B7) or “-” (B11) buttons to adjust the alarm time.
zWhen viewing Alarm Time 1 or Alarm Time 2, press “AL ON/OFF” (B3) button to switch that alarm
on or off. If it is on, “ ” or “ ”shown on the LCD.
zPress “SNOOZE” (B2) button when alarming . The alarm will snooze for 5 minutes, then it alarms
again. This snooze function can be enabled for maximum 7 times.
zPress “MODE/SET” (B1) or “AL ON/OFF” (B3) button to stop the snooze alarm.
Low Batteries Indicator:
yLow battery icon “ “ appear at outdoor temperature row in particular channel indicating that
Thermal Sensor Unit of the channel is in low battery status. The batteries should be replaced..
Note:
zUse a pin to press the reset button (B13) if the Unit does not work properly.
zAvoid placing the clock near interference sources/metal frames such as computer or TV sets.
zThe clock loses its time information when the battery is removed.
zButtons will not function while scanning for DCF or thermo sensor’s signal unless they are well
received or stopped manually.
Otros manuales de Estación meteorológica de Technoline
Technoline
Technoline WS6447 Manual de usuario
Technoline
Technoline WS 9257-IT Manual de usuario
Technoline
Technoline WS 6830 Manual de usuario
Technoline
Technoline WS 6720 Manual de usuario
Technoline
Technoline WS1700 Manual de usuario
Technoline
Technoline WS 9900 Manual de usuario
Technoline
Technoline DCF-77 Manual de usuario
Technoline
Technoline WS6767 Manual de usuario
Technoline
Technoline WS 6730 Manual de usuario
Technoline
Technoline WS 9065 Manual de usuario
Technoline
Technoline WS 9170 Manual de usuario
Technoline
Technoline WS7039 Manual de usuario
Technoline
Technoline WS 6720 Manual de usuario
Technoline
Technoline WS 6710 Manual de usuario
Technoline
Technoline WT 245 Manual de usuario
Technoline
Technoline WS6620 Manual de usuario
Technoline
Technoline WT 221 Manual de usuario
Technoline
Technoline WS 6870 Manual de usuario
Technoline
Technoline WS 6760 Manual de usuario
Technoline
Technoline WS6850 Manual de usuario
Manuales populares de Estación meteorológica de otras marcas
National Geographic
National Geographic VA Colour RC Manual de usuario
Renkforce
Renkforce 1208067 Manual de usuario
Levenhuk
Levenhuk Discovery Report WA40 Manual de usuario
Instant Transmission
Instant Transmission MA 10410 Manual de usuario
Lutron Electronics
Lutron Electronics PHB-318 Manual de usuario
WAREMA
WAREMA EWFS Weather station eco Manual de usuario