Retro mode
In this mode, information is displayed in a segmented font, as on the
prototype watch. By pressing K1 (or turning the clock, see “Settings”) the time
is displayed; if held for more than 2 seconds, seconds are displayed. By
pressing K4, the date and serial number of the day of the week are displayed
(1 – Monday, 7 – Sunday).
The time is set using buttons K2 (minutes) and K3 (hours). When you hold
down the corresponding button, the readings increase by 1 every 0.5 s.
Seconds are reset by pressing K5. Moreover, if at the time of zeroing the value
of seconds was from 41 to 59, the value of minutes will increase by 1.
Setting the date is done in the same way (K2 is the day of the week, K3 is the
date), but by holding down K4.
Advanced Mode
In this mode, information is displayed in a larger graphic font. By
pressing K1 (or turning the clock, see “Settings”) the time is displayed,
while the seconds are displayed immediately or by holding for more than 2
seconds, depending on the “SECONDS” setting. By pressing K4, the date
(day, month, year) and day of the week are displayed.
The time is set using buttons K2 (minutes) and K3 (hours). When you press
the corresponding button, the readings increase by 1, while when you hold
the button they will increase at a gradually increasing rate. By pressing K5,
the seconds are reset to zero in the same way as in retro mode.
Output of service information
To enter this mode, press K4 (date display), and without releasing it, press
K1. Information about the watch will appear on the display: product name,
software version, as well as the current power source voltage (for example,
2.98V). A dot appears on the bottom line every second. Exit from this mode
occurs automatically after 2 s plus the delay value set in the settings. In this
case, K1 disables the automatic output, and K4 performs a forced exit.
Replacing the battery
If the power supply voltage is less than 2.5 volts (see “Output of service
information”), it should be replaced. To do this, unscrew the cover retaining
ring counterclockwise, remove the cover, remove the electronic unit from the
case, push the old battery to the side, install the new one (“+” upwards,
towards the metal holder) and reassemble the watch in the reverse order. We
recommend having it replaced at a specialized workshop. Battery type –
CR2032.
Contents of delivery
Watch with installed battery and bracelet, instructions, gift case – 1 pc.
Specifications
- Weight, no more:125 g, of which watches no more than 50 g.
- Dimensions (excluding buttons and bracelet):35.4x39x11.3 mm.
- Width of the connecting link of the bracelet:20 mm.
- Case material: steel03Х17Н14М3.
- Water resistance (according to GOST29330-92): 3 atm
- Operating temperature range:1-50 °C.
- Display size:16.3x5.4 mm.
- Display operating time before loss50% brightness with continuous
flashing, no less than: 10,000 hours.
- Battery:CR2032.
- Approximate working hours
Duration of display operation per day and use of the rotation sensor,
years:
hours Vdependencies from
Display on Sensor disabled Sensor enabled
0 s per day 8 years 4 years
30 s per day 3 years 2 years
60 s per day 2 years 1.5 years
120 s per day 1 year 1 year
