TDK-Lambda PHV Series Guía del usuario

IEEE DIGITAL INTERFACE SETUP MANUAL FOR

PHV Series High Voltage

POWER SUPPLY

Document: 83550130 Rev A

TDK-LAMBDA AMERICAS

405 Essex Road, Neptune, NJ 07753

Tel: (732) 922-9300

Fax: (732) 922-9334

Web: www.us.tdk-lambda.com/hp

THIS PAGE LEFT INTENTIONALLY BLANK

83550130 Revision A

Table of Contents

1. Overview...................................................................................................................................3

1.1. Scope........................................................................................................................................3

1.2. ADDR LED................................................................................................................................3

1.3. Service Request (SRQ) LED.....................................................................................................3

2. Interface setup information........................................................................................................5

2.1. GPIB primary address (PA).......................................................................................................5

2.2. Other DIP switch settings..........................................................................................................5

83550130 Revision A

THIS PAGE LEFT INTENTIONALLY BLANK

83550130 Revision A

1. Overview

1.1. Scope

This manual applies to PHV series power supplies equipped with the IEEE digital interface

option. The manual describes setting the GPIB interface address only.

The IEEE interface programming commands can be found in the Digital Interface

Command Reference manual (document 83550100) downloadable from the PHV product

page: http://www.us.tdk-lambda.com/hp/product_html/PHVpower.htm.

The IEEE interface is located on the rear panel of the power supply. A sketch is shown

below.

IEEE Interface features

1- IEEE-488 interface connector

2- Configuration DIP switch (see section 2.1)

3- Interface Addressed LED (see section 1.2)

4- Service Request LED (see section 1.3

1.2. ADDR LED

This LED illuminates when the interface is either in listener addressed state or talker

addressed state.

1.3. Service Request (SRQ) LED

This LED illuminates when the interface asserts the SRQ line. After a serial poll the LED

extinguishes.

83550130 Revision A

THIS PAGE LEFT INTENTIONALLY BLANK

83550130 Revision A

2. Interface setup information

For normal operation, only the GPIB primary address should be adjusted using switches 1

through 5 if required. The other switches, 6 through 8 remain in the OFF position.

2.1. GPIB primary address (PA)

The GPIB primaryaddress (PA) enables identification of all units connected to an IEEE-488

bus system, and each unit connected to the bus must be assigned a unique PA.

The Host PC usually has PA=0 and the connected units usually have addresses from 4

upwards. Normally PHV power supplies arefactory configured with the PA set to 8.

The user can change the factory set PA via a DIP switch located on the IEEE-488 interface

converter on the rear panel of the unit (see the figure on page 3). It is not necessary to

open the power supply.

After changing a configuration switch, the power supply should be turned off for 5 seconds

and turned on again.

To change the GPIB PA, the user should only change switches 1 through 5. The unit is

factory set with switch 4 in the ON position and switches 1, 2, 3, and 5 are in the OFF

position (PA=8).

The switch settings follow the binary system:

Switch 1 has value 1

Switch 2 has value 2

Switch 3 has value 4

Switch 4 has value 8

Switch 5 has value 16

Example: To set the GPIB PA to 9, Switches 1 and 4 are ON, switches 2, 3, and 5 are

OFF. To set the GPIB PA to 20, Switches 3 and 5 are ON, switches 1, 2, and 4 are OFF.

2.2. Other DIP switch settings

DIP switches 6, 7, and 8 are special functions and are factory set to the OFF position and

the settings should not be changed. Contact the factory for further information.

Otros manuales para PHV Series

Tabla de contenidos

Otros manuales de Fuente de alimentación de TDK-Lambda

TDK-Lambda

TDK-Lambda GENESYS GEN 2400W Series Manual de usuario

TDK-Lambda

TDK-Lambda LZS-A1500-4 Manual de usuario

TDK-Lambda

TDK-Lambda Genesys Series Manual de usuario

TDK-Lambda

TDK-Lambda Z+ series Manual de usuario

TDK-Lambda

TDK-Lambda DBM20 Manual de usuario

TDK-Lambda

TDK-Lambda GH10-150 Guía de configuración

TDK-Lambda

TDK-Lambda FPS-T1U Manual de usuario

TDK-Lambda

TDK-Lambda DRJ15 Manual de usuario

TDK-Lambda

TDK-Lambda Alpha 1500 Manual de usuario

TDK-Lambda

TDK-Lambda LZS-A1000-2 Manual de usuario

TDK-Lambda

TDK-Lambda G10-500 Manual de usuario

TDK-Lambda

TDK-Lambda ZWP350-1000 Series Manual de usuario

TDK-Lambda

TDK-Lambda EZA2500 Series Guía de instalación

TDK-Lambda

TDK-Lambda IM-LZSA1000-2 Manual de usuario

TDK-Lambda

TDK-Lambda EZA2500 Series Guía de instalación

TDK-Lambda

TDK-Lambda CUS350M Series Manual de usuario

TDK-Lambda

TDK-Lambda LZS-A1500-3-001 Manual de usuario

TDK-Lambda

TDK-Lambda ELV12 Series Manual de usuario

TDK-Lambda

TDK-Lambda EZA2500FC Manual de usuario

TDK-Lambda

TDK-Lambda RWS 1500B Series Manual de usuario

TDK-Lambda

TDK-Lambda 802 Series Manual de usuario

TDK-Lambda

TDK-Lambda TPS4000 Series Manual de usuario

TDK-Lambda

TDK-Lambda SWS-L Series Manual de usuario

TDK-Lambda

TDK-Lambda SWS-L Series Manual de usuario

Manuales populares de Fuente de alimentación de otras marcas

Monacor

Monacor PS-12CCD Manual de usuario

VOLTIMA

VOLTIMA MagicBox 15 Manual de usuario

Agilent Technologies

Agilent Technologies 6032A Manual de usuario

Miller

Miller Auto Deltaweld 452 Manual de usuario

BCP

BCP PUOUBK Hoja de instrucciones

HC 2210 Manual de usuario

Puls

Puls CT5.241 Manual de usuario

OCZ

OCZ ZX1250W Manual de usuario

iseg

iseg ECH 238 Manual de usuario

Power

Power XXL A Series Manual de usuario

Agilent Technologies

Agilent Technologies 6631B Manual de usuario

Renogy

Renogy PHOENIX 300 Manual de usuario

HP 6200B Manual de servicio

Epson

Epson Stylus Scan 2500 Manual de funcionamiento

Pulsar

Pulsar GREEN POWER CCTV PoE POE044816 Manual de usuario

Puls

Puls MiniLine ML50.100 Manual de usuario

Puls

Puls AS-Interface SLA4.100 Manual de usuario

Kenwood

Kenwood PS-60 Manual de usuario