L200Y SLIDING GATE OPERATOR USER’S MANUAL
3
1.Important safety information
Carefully read and follow all safety precaution and warnings before attempting to install and use
this operator, incorrect installation can lead to severe injury.
The gate operator should be installed by a qualified technician; otherwise, serious personal
injury or property damage may occur.
The auto-reverse function must be checked during installation to ensure that the gate can
auto-reverse in the event of obstruction.
This auto-reverse function should be regularly inspected and adjusted, if necessary.
When opening or closing the gate, do not attempt to walk or drive through the gate.
Children should not be allowed to play near or operate automatic gates.
Install the gate operator on the inside of the property, DO NOT install it on the outside of the
property where the public has access to it.
Be careful when in close proximity to moving parts where hands or fingers could be
pinched.
Do not allow control devices to be placed so that a person can access them by reaching
through the gate.
In the event of power failure, an emergency release key allows you to operate the gate
manually.
The operator should be switched off before repairing it or opening its cover.
Please erase and reset the code after installing the operator.
2. Main features
The device is used to drive the sliding gate.
For your safety, the L200Y will stop and reverse if it was obstructed on closing and stop
when it was obstructed on opening.
Supports up to 100 remote controls.
Infrared terminal (N.C) is supplied to use.
Memory card can be unplugged.
Auto-close feature is available for this operator.
Pedestrian mode.
Manual key release design for emergency purposes.
3. Technical parameters
12m/min (19 teeth);14m/min (24 teeth,optional)
35N·m (It is adjustable by pressure screw.)
Remote control operating range
Environmental temperature
