5
INSTRUCTIONS
1. Remove the equipment from the shipping carton carefully. Save the shipping
carton and all packing material until proper operation of the equipment is
confirmed. Immediately notify the carrier if there is any visible damage to the
carton or its contents. Failure to do so may limit your ability to obtain
compensation for damage.
NOTE: The inner chamber of your instrument has been treated with an oil-based
protectant. Please clean the chamber thoroughly with alcohol before filling to avoid
the contamination of paraffin.
2. Connect the power cable to the unit and into a properly grounded 120V outlet.
NOTE: If your unit was shipped outside of the U.S., check the label on the rear of
the instrument for the electrical requirements.
3. Switch the ON/OFF switch at the rear of the unit to the ON position.
4. Immediately upon turning the unit on, the SET TEMP and TIME/TEMP windows
will display 8888 for approximately 4 seconds. The unit will then display PASS or
FAIL in the TEMP/TIME window for 4 seconds. If PASS appears, 06:00 will
appear in the red LED window and flash until set, while the SET TEMP window will
display the factory preset temperature of 55°C.
NOTE: If FAIL appears in the TEMP/TIME window, the SET TEMP LED will be
blank and the beeper will continue to sound. Press any switch to discontinue the
beeping. Although the water bath may appear to function normally, the FAIL
message indicates that the software has found a problem with the unit, and the
unit should be returned for service. Phone our customer service department
immediately for further instructions.
5. Press the ON key to initiate the paraffin reservoir heaters. The small red LED
indicator will light up.
6. You may now set the clock by pressing the SET TIME FAST or SET TIME SLOW
keys. Press the TEMP key to the left of the TEMP/TIME display if you prefer
continuous monitoring of the bath temperature.
7. To increase or decrease the preset reservoir temperature, press and hold the
increment (up arrow) key or the decrement (down arrow) key until the desired
