Targus Wireless Keypad and Mouse Combo Manual de usuario
USER GUIDE
Wireless
Keypad and
Mouse Combo
PAKP003U v.2 / 410-0486-001C
30
Visit our Website at www.targus.com Features and
specifications subject to change without notice.
© 2006 Targus Group International, Inc. and Targus, Inc.
Introduction
Contents
System Requirements
Hardware
• PC with an Intel®Pentium®
processor or equivalent
• USB 1.1 interface
Operating System
TARGUS WIRELESS
KEYPAD AND MOUSE
COMBO
Congratulations on your purchase of the Targus wireless
keypad and mouse combo. This combo set offers wireless
freedom with 27 MHz wireless connection. Both keypad and
mouse feature an on/off switch and recharging capability for
effective power management.
• Windows®2000/XP
• Windows Vista™
In addition to this user’s guide, this package contains:
• Targus Wireless Keypad
• Targus Wireless Notebook Mouse
• USB receiver
• USB extention & charging cable
• 4 AAA rechargeable batteries (2 for mouse, 2 for keypad)
• Carrying pouch
1
Targus Wireless Keypad and Mouse Combo
Installing the Batteries
Optical Mouse
1
Removing the battery cover
2 Insert the supplied batteries , making sure that the
positive (+) and negative (-) ends of each battery match
the polarity indicators inside the battery housing.
3 Slide the battery cover back into position until it “clicks”
firmly into place.
4 Turn on the mouse by sliding the on/off switch on the
bottom of the mouse to the “on” position.
Battery cover
release button
Remove the battery cover from the top of the mouse by
pressing the battery cover release button and sliding the
cover backwards.
WARNINGS: You must use NiMH rechargeable batteries.
Avoid mixing new and used batteries in a device.
If the mouse is not in use, there is a clip located at the bottom of the
mouse for storing the USB receiver. Slide the USB receiver into the slot
as shown.
2
Targus Wireless Keypad and Mouse Combo
3 Turn on the keypad by sliding the Power switch on the
right side of the keypad to the “on” position.
on/off
switch
connect
button
NOTE: TO CONTINUOUSLY CHARGE THE BATTERIES VIA THE USB CHARGE CABLE,
YOUR COMPUTER MUST BE ON AND AWAKE . FOR BEST RESULTS , TURN OFF
YOUR COMPUTER ’S POWER MANAGEMENT / SLEEP MODE FEATURE WHILE
CHARGING THE MOUSE. FOR BEST RESULTS, YOU SHOULD CHARGE THE
BATTERIES VIA THE SUPPLIED USB CHARGE CABLE FOR AT LEAST 8 HOURS
BEFORE USING IT.
WARNING: YOU MUST USE NiMH RECHARGEABLE BATTERIES FOR THESE 2
DEVICES.
Wireless Keypad
1 Remove the battery cover located on the bottom of the
keypad.
2 Insert the supplied batteries , making sure that the
positive (+) and negative (-) ends of each battery match
the polarity indicators inside the battery housing.
NOTE: THE MOUSE AND KEYPAD CAN NOT BE CHARGED SIMULTANEOUSLY.
3
Operating Notes for Wireless Mice with
Recharging Feature via USB Cable
1. Charge the mouse for at least 8 hours before using it. And please
make sure only rechargeable batteries (the ones that come with your
product) are used.
2. Your computer needs to stay powered on for the mouse to charge.
Follow these steps to prevent your computer from going in to
Standby or Hibernate:
a) Click “Start”
b) Click “Control Panel”
c) Click “Performance and Maintenance” (Skip in Classic View)
d) Click “Power Options”
e) Make sure “System Standby:” and “System Hibernates:” under “Plugged
in” are set to “Never”
3. If you use your notebook computer’s LCD monitor, please do not
close the lid. (Please ignore this step if you use an external monitor
with your notebook lid closed.)
4. If your mouse does not respond after a period of inactivity, please
wake it up by pressing one of the buttons on the mouse or moving
the mouse around.
Targus Wireless Keypad and Mouse Combo
4
Targus Wireless Keypad and Mouse Combo
Recharge cable
connector
Notebook
Desktop
Wireless Keypad
Connect the USB charge cable into the keypad and plug the
other USB tip into an available USB port on your computer.
Connecting the Receiver
Plug the USB receiver into an available USB port on your
computer.
The “Lock LED” light turns on.
You are now ready to set the identification code to establish
Lock LED
Connect button
a communication link with the receiver.
Charging the Batteries
Connect the USB charge cable into the mouse and plug the
other USB tip into an available USB port on your computer.
Recharge cable
connector
Opitcal Mouse
Notebook
Desktop
5
Targus Wireless Keypad and Mouse Combo
Setting the Identification Code
After your computer detects the USB receiver you must set
the ID code between the receiver and the mouse as well as
between the receiver and the keypad BEFORE you can use
them. To do this, do the following:
NOTE: Make sure that your computer is turned on and
has detected the USB receiver before you set the ID
code.
Optical Mouse
1 Press and release the connect button on the receiver.
The Lock LED light turns off.
2 Press the setup key on the bottom of the mouse.
When the LED on the receiver is lit, the mouse is set up
with an ID and the receiver is locked.
You are now ready to use the mouse.
on/off switch
connect button
NOTE: The ID code between the receiver and the mouse
must be synchronized again if the batteries are
replaced. Please refer to “Setting the identification
code” for instructions.
6
Targus Wireless Keypad and Mouse Combo
Wireless Keypad
1 Press and release the connect button on the receiver again.
When the light emitter diode (LED) on the receiver is lit,
the keypad is set up with an ID and the receiver is
locked. You are now ready to use the keypad.
Using the Keypad
Activate Num Lock
Definition of the keys:
Deactivate Num Lock
Definition of the keys:
Num
Lock
/ * Bk Sp
7 8 9 -
4 5 6 +
1 2 3
Enter
0 00 .
Num
Lock
/ * Bk Sp
Home PgUp -
+
End PgDn
Enter
InsDel
Connect button
2 Press the connection button located on the back of the
keypad.
,
NOTE: The ID code between the receiver and the keypad
must be synchronize again if the batteries are replaced.
Please refer to “Setting the identification code” for
instructions.
7
Internet / Media Hot Keys
Switch between Internet mode and media mode by sliding the button
located at the top of the number pad.
Targus Wireless Keypad and Mouse Combo
BkSp
Num
Lock
7
Home
4
1
End
0
Ins
/*
8
5
2
00
,.
Del
Enter
9
PgUp
6
-
+
3
PgDn
Num lock / signal
LED indicator
Mode switch
Internet Mode / Media Mode
Media Mode
Key Function
Previous Track
Next Track
Play / Pause
Volume Down
Volume Up
Stop
Internet Mode
Key Function
Back
Forward
Home
Favorite
E-Mail
Refresh
8
•To power the mouse on and off, slide the on/off switch on the
bottom of the mouse to the desired position.
•To power the keypad on and off, slide the on/off switch
on the side of the keypad to the desired position.
• During the operation, the power saving feature allows the
mouse and keypad to go into “sleep mode” after 4 minutes of
inactivity. Click any mouse and keypad button to re-activate
the device.
• To save battery power, turn off the mouse and the keypad while
traveling or while not in use.
• The scroller wheel will glow when the power is low. To recharge
the mouse, plug in the USB Recharging Cable into the mouse
and plug the USB tip into the computer. The mouse is operational
while charging.
• The LED indicator will light when the power is low. To recharge
the keypad, plug in the USB Recharging Cable into the keypad,
and plug the USB tip into the computer. The keypad is
operational while charging.
Mouse and keypad Power
Management
Targus Wireless Keypad and Mouse Combo
9
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Accesorios de computadora de Targus
Targus
Targus 3-in-1 STYLUS Manual de usuario
Targus
Targus awe72eu Lap Manual de usuario
Targus
Targus LASER PEN Manual de usuario
Targus
Targus Privacy Screen Manual de usuario
Targus
Targus Wireless Keypad & Mini Optical Mouse Manual de usuario
Targus
Targus PAKP003U Manual de usuario
Targus
Targus Click N Type Manual de usuario
Targus
Targus AKM10US Manual de usuario
Targus
Targus NETBOOK COOLING CHILL MAT Manual de usuario
Targus
Targus BLUETOOTH KEYBOARD Manual de usuario
