Targa VISIONARY LCD 19-1 Manual de usuario
19” LCD Display
TARGA VISIONARY
LCD 19-1
User Guide
ENGLISH
1
Table of Content
Trademark And Disclaimer................................................................................ 2
Getting Started .................................................................................................... 3
Packing Contents.............................................................................................................. 3
Precautions........................................................................................................................ 3
Quick Installation............................................................................................................. 4
Installation Of Wall Mount (Optional)........................................................................... 6
Using the LCD Display ....................................................................................... 7
Setting the Timing Mode ................................................................................................. 7
Adjusting the Screen Image ............................................................................................ 7
On Screen Display (OSD) Operation.............................................................................. 9
Below tips may help you optimize your display: ......................................................... 10
Main Menu Controls...................................................................................................... 11
Other Information............................................................................................. 14
Specifications .................................................................................................................. 14
Trouble Shooting ............................................................................................................ 15
Appendix ............................................................................................................ 16
Safety Guidelines ............................................................................................................ 16
Compliance Information for U.S.A. ............................................................................. 17
CE Conformity for Europe............................................................................................ 17
TCO 99, Environmental requirements ...................... Fehler! Textmarke nicht definiert.
ENGLISH
2
Trademark and Disclaimer
Microsoft, Windows operating systems, and the Windows logo are registered
trademarks of Microsoft Corporation.
Macintosh and Power Macintosh are registered trademarks of Apple Computer,
Inc.
VESA is a registered trademark of the Video Electronics Standards Association.
DPMS and DDC are trademarks of VESA.
ENERGY STAR® is a registered trademark of the U.S. Environmental
Protection Agency (EPA).
Disclaimer: The manufacturer shall not be liable for technical or editorial errors
or omissions contained herein; nor for incidental or consequential resulting from
furnishing this material, or the performance or use of this product.
In the interest of continuing product improvement, the manufacturer reserves the
right to change product specifications without notice. Information in this
document may change without notice.
No part of this document may be copied, reproduced, or transmitted by any
means, for any purpose without prior written permission from the manufacturer.
ENGLISH
3
Getting Started
Thank you for purchasing this 19” LCD display.
Packing Contents
Your LCD display package should contain the below items:
•The LCD Display
•The Foot-stand
•Power Cord
•Video Signal Cable
•Audio Cable (Optional)
•DVI Cable (Optional)
Note: You should keep the original factory carton and packing materials in
case you need to ship unit back for servicing.
Precautions
•Sit at least 18” from the LCD display.
•Avoid touching the screen. Skin oils are difficult to remove.
•Never remove the rear cover. The LCD display contains high-voltage parts.
You may be seriously injured if you touch them.
•Avoid exposing the LCD display to direct sunlight or any heat source. Orient
the LCD display away from direct sunlight to reduce glare.
•Always handle the LCD display with care when moving it.
•Place the LCD display in a well-ventilated area. Do not place anything on the
LCD display that prevents heat dissipation.
•Ensure the area around the LCD display is clean and free of moisture.
•Do not place heavy objects on the LCD display, video cable, or power cord.
•If smoke, abnormal noise, or strange odor is present, immediately switch the
LCD display off and call the local dealer. It is dangerous to continue using
the LCD display.
•Do not tilt the LCD display backward more than an angle of 17 degree from
its vertical upright position. Otherwise system may tip over.
•Do not rub or apply pressure to the LCD panel, as this may permanently
damage the screen.
•Do not allow the LCD display to rest on the LCD panel onto hard and un-
even surface.
ENGLISH
4
Quick Installation
•The display unit is shipped with
the hinge retracted into the display
unit. Use your bare hand to flip the
hinge open.
•Install the display unit onto the
foot-stand.
•Connect power cord. Connect the
other end of this power cord to an
electrical source.
•Connect video cable or the DVI
(optional) cable. Connect the other
end of this video/DVI cable to the
video-out or DVI-out connectors
on the back of a computer.
•Connect the audio (optional) cable.
Connect the other of this audio
cable to audio-out connector on the
back of a computer.
•Turn on the LCD display first
before turning on the computer.
•After the computer is turned on,
set timing mode (resolution and
refresh rate). Example: 1280 x
1024 @ 60 Hz.
The hinge is now retracted into the system unit. The hinge is now flipped open.
Note: If you need to retract the hinge back into the display unit, you need
to press the hinge lock first.
The hinge lock
ENGLISH
5
Install the display unit onto the foot-stand. Bottom view of the foot-stand: The three tenons
should be fully inserted into the three mortises.
Note: The “DVI-In” and “Audio-In” connectors are optional.
Powe
r
connector
Kensington
lock
A
udio-In
connector
VGA
connector
ENGLISH
6
Installation of Wall Mount (Optional)
This LCD display supports industry standard wall-mount kit. To wall-mount this
LCD display, you need to purchase a wall-mount kit from your local dealer.
Read the instructions from the wall-mount kit before proceeding as below:
•Lay the LCD display face-down on flat surface covered by a towel or
blankets.
•Remove the two screws.
•Detach the foot-stand from the display module.
•Attach the wall-mount bracket onto the back of the display module by means
of these four VESA holes.
•Follow instructions from the wall-mount kit to attach the wall-mount bracket
to the wall.
Remove the
two screws
Detach the hinge
and the foot-stand
The four
VESA holes
Hinge
Foot-stand
ENGLISH
7
Using the LCD Display
Setting the Timing Mode
Setting the timing mode is important for maximizing the quality of the screen
image and minimizing eyestrain. The timing mode consists of the resolution
(example 1280 x 1024) and refresh rate (or vertical frequency; example 60 Hz).
After setting the timing mode, use the OSD controls to adjust the screen image.
For the best picture quality, set your LCD display timing mode to:
VESA 1280 x 1024 @ 60Hz.
To set the timing mode:
•Set the resolution: Right-click on the windows desktop > Properties >
Settings >set the resolution.
•Set the refresh rate: See your graphic card’s user guide for instructions.
WA R N I N G : Do not set the graphics card in your computer to exceed the
maximum refresh rate of 85Hz / 1280 x 1024 @ 75Hz. Doing so
may result in permanent damage to your LCD display.
Adjusting the Screen Image
Use the buttons on the front control panel to display and adjust the On View
controls displayed on the screen. The OSD controls are explained on page-10 of
this document.
ENGLISH
8
Main Menu with OSD
Controls.
Front Control Panel
shown below in details.
Earphone out
Exits the control screen and
save adjustment.
Also a shortcut the auto
adjustment.
Volume control and audio mute
function.
Power On/Off
Power Light:
Green = On
Orange = Power Saving
Scrolls through menu options and
adjusts the display control.
Also a shortcut to display the
brightness adjustment control
screen.
Scrolls through menu
options and adjusts the
display control.
Also a shortcut to display the
contrast adjustment control
screen.
Display the
Main Menu
or enter the
setting.
Tabla de contenidos
Otros manuales de Monitor de Targa
