3
Align the 6" mark on the tape to the pencil mark and center the
tape on the Pivot Bar leaving approximately a 1/4" on either side
to account for the movement of the Material Stop. Peel from
backing and apply (Fig. 8).
Trim excess tape with utility knife.
Repeat process for remaining Pivot Bar Assembly using the same
pieces of trim coil.
STEP 5: (OPTIONAL) CUT-OFF TAPE
Insert a 12"x12" piece of coil marked at 8" into the brake and
lock it lined up at the 8” mark. Cut the coil using the PRO Cut-Off,
discard cut piece.
Set the Material Stop at the 8" mark. The material stop should
hit the material. Draw a line down the coil and remove coil from
the brake. Using the Material Stop as a square edge, transfer
the measurement onto the exposed portion of the Pivot Bar
Assembly (Fig. 9).
Remove Material Stop from Pivot Bar.
Remove the Cut-Off Tape from backing and line up the 8" mark
on the tape to the pencil mark. The Cut-Off Tape will overlap the
Grey/White Measuring Tape by ~1/4" (Fig. 10).
Trim excess tape with utility knife.
Repeat process for remaining Pivot Bar Assembly.
USING THE S2X MATERIAL STOP GAUGE:
Use the Measurement mark on the S2X Gauge to measure any
piece wider than 6’’.
Use the Measurement -3" mark on the S2X Gauge to
measure any pieces narrower than 6’’ (deducting 3" from the
measurement indicated to get actual stop measurement.)
Fig. 9
Fig. 8
1/4"
1/4"
Fig. 10
