T&D TR-73U Manual de usuario
Users Manual
Thank you for purchasing our product.
Carefully read this instruction manual
before using this unit.
© Copyright T&D Corporation. All rights reserved.
2013.01 16504480003 5th Edition
TR-73U
(603) 746-5524
www.MicroDAQ.com
Distributed by MicroDAQ.com, Ltd.
i
Notices about this User's Manual
In order to properly use this product, please carefully read this manual before
using. T&D Corporation accepts no responsibility for any malfunction of and/
or trouble with this product or with your computer that is caused by the
improper handling of this product and will deem such trouble or malfunction
as falling outside the conditions for free repair outlined in the attached
warranty.
- All rights of this User's Manual belong to T&D Corporation. It is prohibited to
use, duplicate and/or arrange a part or whole of this User's Manual without
the permission of T&D Corporation.
- Microsoft® and Windows® are registered trademarks of Microsoft Corporation
USA and are binding in the USA and all other countries.
Windows Vista ™ is a registered trademark of Microsoft Corporation USA .
- Company names and product names are trademarks or registered
trademarks of each company.
- Specifications, design and other contents outlined in this manual are subject
to change without notice.
- On screen messages in this manual may vary slightly from the actual
messages.
- Please notify the shop where you purchased this product or T&D
Corporation of any mistakes, errors or unclear explanations in this manual.
T&D Corporation accepts no responsibility for any damage or loss of income
caused by the use of our product.
- This product has been designed for private or industrial use only. It is not for
use in situations where strict safety precautions are necessary such as in
connection with medical equipment, whether directly or indirectly.
- We are not responsible for any malfunction or trouble caused by the use of
our product or by any problem caused by the use of measurement results of
our unit. Please be fully aware of this before using our product.
- Some of our products, which come under the category of strategic goods in
foreign trade law, need the permission of the Japanese government to be
exported outside of Japan.
- Please read the warranty and provisions for free repair carefully.
Distributed by MicroDAQ.com, Ltd. www.MicroDAQ.com (603) 746-5524
ii
Compliance Information
Radio, EMC and Safety Regulations
This device complies with Part 15 of the Federal Communications Commission
(FCC) rules. Operation is subject to the following two conditions: (1)This
device may not cause harmful interference, and (2)this device must accept
any interference received, including interference that may cause undesired
operation.
FCC Statement
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user
will be required to correct the interference at his own expense.
Caution
Changes or modifications not expressly approved by the party responsible for
compliance could void the users authority to operate the equipment.
Distributed by MicroDAQ.com, Ltd. www.MicroDAQ.com (603) 746-5524
iii
Safety Precautions and Instructions
■To ensure safety obey all of the following warnings
The following items should be strictly obeyed for the safe usage of this unit,
and for protecting yourself and other people from bodily harm and/or damage
to property. Before using make sure to carefully read, understand and follow
the safety rules and precautions for our products as outlined below.
■Explanation of Symbols
Explanation of Warning Symbols
WARNING
These entries are actions that absolutely under no circumstance should
be taken. The taking of such an action may cause serious personal
physical damage or death.
CAUTION
These entries are actions that if taken may lead to physical injury or
damage to persons or things.
Explanation of Picture Symbols
Denotes an important warning or caution. Inside or near the symbol
may appear another symbol giving details.
（ EX: Be careful of electrocution）
Denotes a forbidden action. Inside or near the symbol may appear
another symbol giving details.
( EX: Do not use in wet areas.)
Denotes an action that you must take. Inside or near the symbol may
appear another symbol giving details.
( EX: Unplug power plug from outlet)
Distributed by MicroDAQ.com, Ltd. www.MicroDAQ.com (603) 746-5524
iv
WARNING
When installing and using this product, make sure to follow all warnings and
directions from your computer manufacturer.
Do not take apart, repair or modify the main unit.
Doing so may cause fire or electrocution.
If water or a foreign body enters into this unit, immediately remove the batteries
and stop using.
Continued use may cause fire or electrocution.
Do not use this unit in wet or humid places, such as a bathroom.
It may cause a fire or other trouble including malfunction.
Store main units, sensors, batteries and communication cables out of the reach
of children.
It is dangerous to touch or swallow batteries.
If any smoke or strage smells are emitted from the unit, immediately remove
the batteries and stop using.
Continued use may cause fire or electrocution.
This device is designed to measure and record temperature and humidity. Do
not use it for any other purpose than to measure and record temperature and
humidity.
CAUTION
This unit is not water-resistant.
If the unit gets dirty, wipe it with a clean cloth and a mild detergent.
Do not expose the unit to harmful gases or chemicals. It may cause corrosion
and / or other danger to the unit and to people handling the unit.
Do not use batteries other than specifies. Doing so may cause fire or damage.
Battery terminals may provide insufficient contact due to age or vibration.
This may lead to data loss.
Condensation may occur if the units is moved from one environment to another
where the difference in temperature is great.
Use the unit in an environment where the ambient temperature is great.
Use the unit in an environment where the ambient temperature is from -10 to
60℃ and the humidity is 90%RH (no condensation) or less.
To prevent damage to the unit from static electricity, remove static electricity
from your body by touching metal aroung you (door knob, window frame)
before touching the unit.
Static electricity may cause not only damage to the unit, but may cause breaks
in or a loss of data.
Distributed by MicroDAQ.com, Ltd. www.MicroDAQ.com (603) 746-5524
v
If the unit will not be used for period of time, for safety reasons please remove
the battery.
If left in the unit, it may leak and lead to malfunctioning.
Please take extra caution when plugging in and pulling out the USB plug while
another USB device such as CD-RW/HDD is in operation.
It may cause problems to your CD-RW or other device.
We shall not guarantee the operation of our device if you have connected it to
your computer using a USB hub or a USB extension cable.
Batteries used under low pressure conditions may leak and cause a
malfunction.
Please do not insert your fingers or any foreign objects into any of the devices'
jacks.
Do not use any other batteries than those that are specified in this User's
Manual.
It may cause a fire or other trouble including malfunction.
Do not use or store the Thermo Recorder in any of the following places. Doing
so may cause electrocution, fire and / or other adverse effects to the device
and / or your computer.
-Areas exposed to direct sunlight
This will cause the inside of the device to become overheated and may cause
fire, deformation, and / or other damage including malfunction.
-Areas prone to strong magnetic fields
This may cause damage including malfunction.
-Areas exposed to water leakage
This may cause electrocution or other damage incluing malfunction.
-Areas exposed to excessive vibration
This may cause injury, malfunction, damage or loss of proper electrical contact.
-Areas near fire or exposed to excessive heat
This may cause damage including malfunction and deformation.
-Areas prone to smoke, duct and dirt
This may cause damage including malfunction.
Distributed by MicroDAQ.com, Ltd. www.MicroDAQ.com (603) 746-5524
vi
Cautions about using the Sensors
■Cautions about using the temperature/humidity sensor TR-3100
The sensor can measure temperature within the range of 0 to 50℃ and
humidity within the range of 10 to 95%RH.
Only use the sensor within these ranges.
If extremely severe temperature changes occur, the humidity measurements
may appear abnormal.
Once the sensor's temperature becomes stable, the measurements will return
to normal.
This sensor is not waterproof. Do not get wet.
When measuring with the temperature/humidity sensor in an environment of 0
to 50℃and less than 30%RH, the measurements may sometimes fluctuate.
This is not abnormal.
Distributed by MicroDAQ.com, Ltd. www.MicroDAQ.com (603) 746-5524
vii
Cautions about using the Sensors
[Handling the temperature/humidity sensor]
- The service life of humidity sensors can vary greatly depending on operating
environment.Periodic calibration may be required.
During use the temperature/humidity sensor will accumulate impurities (dirt)
on the surface of the sensor is being used in a bad environment (smoky or
dusty places) it may be necessary to change the sensor sooner.
- When the temperature/humidity sensor is not being used, please place it in
the attached vinyl bag with the drying agent included and store it in a cool
dark place with a temperature of between 5 to 25℃and a humidity of below
30%RH.
- Attached to the temperature/humidity sensor are two stickers: a wetness
detection sticker and a temperature detection sticker. If either of the stickers
shows abnormality, you should change the old sensor to a new one
immediately.
Wetness Detection Sticker Temperature Detection Sticker
-Wetness Detection Sticker
Informs you that the sensor has been wet.
Normal Abnormal
Under normal conditions, black dots
will appear on a white
Under abnormal conditions, it will
turn to red.
-Temperature Detection Sticker
Informs you that the sensor measured a temperature measurement over 60℃.
60
Normal
60
Abnormal
Under normal conditions, the
number 60 will lightly appear on a
pinkish white background.
Under abnormal conditions, the
number 60 will clearly appear on a
red background.
Distributed by MicroDAQ.com, Ltd. www.MicroDAQ.com (603) 746-5524
viii
Table of Contents
Notices about this User's Manual ...................................................................i
Compliance Information ................................................................................ii
Safety Precautions and Instructions ......................................................... iii
■To ensure safety obey all of the following warnings ..................................iii
■Explanation of Symbols ...........................................................................iii
About Thermo Recorder TR-73U .............................................................. 1
■Outline ..................................................................................................... 1
■Basic Functions ....................................................................................... 1
Package Contents ..................................................................................... 3
Before Using… .......................................................................................... 4
Part Names and Functions ....................................................................... 5
■Part Names and Functions ...................................................................... 5
■LCD Display ............................................................................................. 6
Installing the Battery ................................................................................. 7
Turning ON the Power ............................................................................... 8
Connecting the Sensors ............................................................................ 9
■Connect the Sensor ................................................................................. 9
Starting Recording from Main Unit Button .............................................. 10
■Start Recording ...................................................................................... 10
■Stop Recording ...................................................................................... 10
Setting Recording Interval from Main Unit Button ................................... 11
Changing the LCD Display Mode from Main Unit Button ........................ 12
Specifications .......................................................................................... 13
Optional Accessories .............................................................................. 14
Thermo Recorder TR-73U Warranty ......................................................... 15
Distributed by MicroDAQ.com, Ltd. www.MicroDAQ.com (603) 746-5524
1
About Thermo Recorder TR-73U
■Outline
TR-73U Thermo Recorder is a data logger capable of measuring,
displaying and recording temperature, humidity, and barometric
pressure data. TR-73U has a total of three channels: one
temperature, one humidity, and one barometric pressure channel.
The data recorded into the TR-73U units can then be downloaded
quickly via USB cable to your computer whereby with our exclusive
software you can easily process the data into graphs, tables, save to
files and/or print it out.
Moreover, it is possible to connect more than one unit at the same
time.
■Basic Functions
-Barometric Pressure Measuring Range：750 〜1100hPa
The TR-73U with the internal barometric pressure sensor can measure and record in a
range of 750 to 1100 hPa.
-Temperature Measuring Range：-40 〜110℃
The TR-73U with the sensor included in this package can measure and record in a range
of 0 to 50℃, but by purchasing one of our optional sensors it is possible to measure and
record in the wider range of -40 to 110℃.
Please take a look at our full range of optional sensors to find one to match your
application.
-Humidity Measuring Range：10 〜95%RH
The TR-73U with the sensor included in this package can simultaneously measure and
record temperature in a range of 0 to 50℃ and humidity in a range of 10 to 95% RH.
-Amount of Recorded Data：8000 readings x 3 channels
One channel can record and hold up to 8000 measurement readings.
At the longest recording interval of 60 minutes, recording can continue consecutively for
1 year.
-10 Months of Operation with just 1 AA Alkaline Battery
Our low energy consumption design gives you ten months of continuous operation with
only one AA alkaline battery.
This gives you the freedom to use the data loggers in places where they can be left
alone for long periods of time, such as, in transportation or warehouse.
Distributed by MicroDAQ.com, Ltd. www.MicroDAQ.com (603) 746-5524
Otros manuales para TR-73U
3
Tabla de contenidos
Otros manuales de Equipo de grabación de T&D
Manuales populares de Equipo de grabación de otras marcas
Strymon
Strymon NIGHTSKY Manual de usuario
Mitsubishi Electric
Mitsubishi Electric 16CH DIGITAL RECORDER DX-TL5000U Manual de usuario
Tews Technologies
Tews Technologies TPMC465 Manual de usuario
Honeywell
Honeywell Excel 50 Manual de usuario
SeaLevel
SeaLevel COMM+8.LPCI Manual de usuario
Arturia
Arturia AUDIOFUSE STUDIO Manual de usuario
