Tandberg Data SUPERLOADER DLT MAGAZINE Manual de usuario

432555-01

Magazine

Quick Start Guide

SuperLoader™

For more information about Tandberg Data’s

quality products, visit www.tandberg.com

Tandberg Data publications can be requested from a Tandberg Data Sales Representative or ordered directly from

For the latest information about Super DLTtape™ and DLTtape™ products and accessories, visit the Tandberg Data

web site at www.tandberg.com or the Technical Support site at www.dlttape.com.

Tandberg Data reserves the right to make changes and improvements to its products, without incurring

any obligation to incorporate such changes or improvements in units previously sold or shipped.

Publication Number: 432555-01

Data ASA. The DLTtape logo and the Super DLTtape logo are trademarks of Quantum Corporation, registered

in the U.S.A. and other countries. DLTtape, Super DLTtape, SuperLoader, and the SuperLoader logo are

trademarks of Quantum Corporation. Products mentioned herein are for identification purposes only and may be

trademarks or registered trademarks of their respective companies. All other trademarks are the property of their

Tandberg Data.

respective owners.

On the Eject submenu, scroll to Right

Magazine or Left Magazine,

depending on which magazine you

want to eject and press Enter.

The magazine pops forward so that the

front of the magazine is no longer flush

with the front panel.

With one hand, grasp the magazine by

the handle and slide it forward to

remove. Place your other hand under

the magazine to support it and prevent

it from falling.

Note: If you need to remove the

magazine when the autoloader is

powered off, remove it manually.

On the front panel, scroll to

Commands and press Enter.

On the Commands submenu, scroll

to Eject and press Enter.

1Unpack the

magazine

This guide contains

a sequence of steps

recommended for

unpacking and

installing a magazine.

Place the carton on an ESD-safe work sur-

face.

Use a utility knife or scissors to cut the

packing tape along the length and ends

of the carton.

Fold open the box flaps.

Reach into the carton and lift out the

magazine and foam.

Remove the foam caps from each end of

the magazine.

Place the magazine on a flat surface and

rotate the assembly using the manual

indexing wheel.

When the carrier assemblies rotate freely,

the magazine is ready for use.

Remove a

magazine

Support here. Grasp here.

For additional information:

Refer to the enclosed CD-ROM,

or visit www.tandberg.com

Grasp the magazine by the handle with

one hand and support it underneath with

the other hand.

Slide the magazine into the magazine bay.

Make sure that you position the magazine

correctly; it should slide smoothly.

Caution

Insert the magazine slowly to avoid dam-

aging internal components or autoloader.

The magazine is correctly installed when

you feel it click into place and the front is

flush with the front panel.

Reinstall a

magazine

Section 3 explains

how to reinstall a

magazine.

To remove a magazine blank, pull

the magazine straight out.

To resinstall a magazine blank,

grasp the magazine blank by the

handle with one hand.

Slide the magazine blank into the

magazine bay until it stops.

Remove/reinstall

a magazine blank

Slide into magazine bay.

Change the

orientation

Unsnap the handle carefully, ensuring

you do not break the hinge.

Any magazine or magazine blank can be

configured to fit in the right or left

magazine bay.

6 7

Change the orientation of a

cartridge magazine

Remove the two screws that attach the

handle to the front of the magazine

blank.

2-cartridge opening on top

Rotate the handle 180 degrees so that

what was the top of the handle is now

the bottom. (Procedure continues.)

Right magazine handle

Left magazine handle

Pull out

Slide

Change the

orientation,

continued

Change the orientation of a

magazine blank

Remove the two screws that attach the

handle to the front of the magazine

blank.

Rotate the magazine 180 degrees so that

what was the front of the magazine is

now the back.

Snap the handle back on the front of the

magazine.

Install the two screws to attach the

handle securely to the magazine.

Unsnap the handle carefully, ensuring

that you do not break the hinge.

(Procedure continues.)

2 screws

Right magazine with handle and top side up

Left magazine with handle and top side up

Change the

orientation,

continued

Rotate the handle 180 degrees so that

what was the top of the handle is now

the bottom.

10 11

Snap the handle back on the front of the

magazine blank.

Install the two screws to attach the

handle securely to the magazine blank.

Left magazine handle

Right magazine handle

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Hardware de red de Tandberg Data

Tandberg Data

Tandberg Data MSERIES USER Manual de usuario

Tandberg Data

Tandberg Data SUPERLOADER DLT - Manual de usuario

Tandberg Data

Tandberg Data RDX QuikStor Manual de usuario

Tandberg Data

Tandberg Data SLR AUTOLOADER - SERVICE AND Manual de instalación y funcionamiento

Tandberg Data

Tandberg Data SLR7-140 PROGRAMMER Manual de usuario

Tandberg Data

Tandberg Data BARCODE READER Manual de usuario

Tandberg Data

Tandberg Data MSERIES FC USER Manual de usuario

Tandberg Data

Tandberg Data RDX QuikStation 4 Manual de usuario

Tandberg Data

Tandberg Data MSERIES RMC USER Manual de usuario

Tandberg Data

Tandberg Data Autoloader Tandberg LTO2 Manual de usuario

Tandberg Data

Tandberg Data SLR Manual de usuario

Tandberg Data

Tandberg Data MSERIES Manual de usuario

Tandberg Data

Tandberg Data StorageLoader Manual de usuario

Tandberg Data

Tandberg Data SUPERLOADER Manual de usuario

Tandberg Data

Tandberg Data RDX QuikStation 4 Instrucciones de funcionamiento y mantenimiento

Tandberg Data

Tandberg Data Magnum 224 Manual de usuario

Tandberg Data

Tandberg Data Tape Backup System DLT4000 Manual de usuario

Manuales populares de Hardware de red de otras marcas

Matrix Switch Corporation

Matrix Switch Corporation MSC-HD161DEL Manual de usuario

B&B Electronics

B&B Electronics ZXT9-IO-222R2 Manual de usuario

Yudor

Yudor YDS-16 Manual de usuario

D-Link

D-Link ShareCenter DNS-320L Manual de usuario

Samsung

Samsung ES1642dc Instrucciones de uso

Honeywell Home

Honeywell Home LTEM-PV Instrucciones de montaje

evertz

evertz 7700 Series Manual de usuario

D-Link

D-Link ShareCenter DNS-343 Manual de usuario

Asante

Asante AsanteBridge 1012 Manual de usuario

FireBrick

FireBrick FB2700 Manual de usuario

Audiovox Electronics

Audiovox Electronics ARWH2T Manual de usuario

ADC

ADC DSX-1 Manual

NetComm

NetComm NF2 Manual de usuario

Alcatel-Lucent

Alcatel-Lucent 5620 Manual de usuario

Dell EMC

Dell EMC XC6420 Series Manual de usuario

Lanner

Lanner NCA-1020A Manual de usuario

Allied Telesis

Allied Telesis AT-TN121-A Manual de usuario

Arista

Arista CCA-ETM-Q12 Manual de usuario