Supermicro SUPER P6DGH Manual de usuario
SUPER P6DGH
USER’S AND BIOS
MANUAL
Revision 1.0
SUPER ®
The information in this User’s Manual has been carefully reviewed and is believed to be
accurate. The vendor assumes no responsibility for any inaccuracies that may be
contained in this document, makes no commitment to update or to keep current the
information in this manual, or to notify any person or organization of the updates.
SUPERMICRO COMPUTER reserves the right to make changes to the product described in
this manual at any time and without notice. This product, including software, if any, and
the documentation may not, in whole or in part, be copied, photocopied, reproduced,
translated or reduced to any medium or machine without prior written consent.
IN NO EVENT WILL SUPERMICRO COMPUTER BE LIABLE FOR DIRECT, INDIRECT,
SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES ARISING FROM THE USE OR
INABILITY TO USE THIS PRODUCT OR DOCUMENTATION, EVEN IF ADVISED OF THE
POSSIBILITY OF SUCH DAMAGES. IN PARTICULAR, THE VENDOR SHALL NOT HAVE
LIABILITY FOR ANY HARDWARE, SOFTWARE OR DATA STORED OR USED WITH THE
PRODUCT, INCLUDING THE COSTS OF REPAIRING, REPLACING, INTEGRATING,
INSTALLING OR RECOVERING SUCH HARDWARE, SOFTWARE OR DATA.
Unless you request and receive written permission from SUPERMICRO COMPUTER, you
may not copy any part of this document.
Information in this document is subject to change without notice. Other products and
companies referred to herein are trademarks or registered trademarks of their respective
companies or mark holders.
Copyright © 1998 by SUPERMICRO COMPUTER INC.
All rights reserved.
Printed in the United States of America.
iii
Preface
About This Manual
This manual is written for system houses, experienced PC techni-
cians and knowledgeable PC end users. It provides information for
the installation and use of the SUPER P6DGH motherboard. The
SUPER P6DGH supports Pentium II 233-450 MHz Slot 1 proces-
sors.
The Pentium II processor with Dual Independent Bus Architecture is
housed in a new packaging technology called the Single Edge Con-
tact Cartridge (S.E.C.C.). This new cartridge package and its asso-
ciated "Slot 1" infrastructure will provide the headroom for future
high-performance processors.
Manual Organization
Chapter 1, Introduction, describes the features, specifications and
performance of the SUPER P6DGH system board, provides detailed
information about the chipset, and offers warranty information.
Refer to Chapter 2, Installation, for instructions on how to install the
Pentium II processor, the retention mechanism and the heat sink
support. This chapter also provides you with instructions for han-
dling static-sensitive devices. Read this chapter when you want to
install or remove SIMM/DIMM memory modules and to mount the
system board in the chassis. Also refer to this chapter to connect
the floppy and hard disk drives, IDE interfaces, and the parallel and
serial ports as well as the cables for the power supply, the reset
cable, the Keylock/Power LED, the speaker and the keyboard.
Preface
If you encounter any problems, please see Chapter 3, Trouble-
shooting, which describes troubleshooting procedures for the video,
the memory and the setup configuration stored in memory. Instruc-
tions are also included for contacting a technical assistance sup-
port representative, returning merchandise for service and visiting
our website for BIOS upgrades.
iv
SUPER P6DGH User’s Manual
See Chapter 4 for configuration data and the AMIBIOS features.
Chapter 5 covers the WinBIOS setup options.
Table of Contents
Table of Contents
Preface
About This Manual ..................................................................................... iii
Manual Organization .................................................................................. iii
Quick Reference Guide ............................................................................. ix
Chapter 1: Introduction
1-1 Overview........................................................................................... 1-1
SUPER P6DGH Image............................................................. 1-4
SUPER P6DGH Motherboard Layout ..................................... 1-5
SUPER P6DGH Features ........................................................ 1-6
1-2 PC Health Monitoring..................................................................... 1-8
1-3 ACPI/PC 98 Features................................................................... 1-11
1-4 Chipset Overview .......................................................................... 1-12
1-5 Wake-On-LAN................................................................................ 1-13
1-6 Power Supply ................................................................................ 1-13
1-7 Winbond Super I/O Controller...................................................... 1-14
1-8 AIC-7896 SCSI Controller ............................................................. 1-15
1-9 Warranty, Technical Support and Service ................................. 1-16
Parts.......................................................................................... 1-16
BIOS .......................................................................................... 1-16
Labor......................................................................................... 1-16
Returns..................................................................................... 1-16
Chapter 2: Installation
2-1 Pentium II Processor Installation................................................. 2-1
OEM Pentium II and Heat Sink Support ................................ 2-5
Removing the Pentium II Processor...................................... 2-7
2-2 Static-Sensitive Devices ................................................................ 2-8
Precautions................................................................................ 2-8
v
Unpacking .................................................................................. 2-8
2-3 Changing the CPU Speed............................................................. 2-8
2-4 Mounting the Motherboard in the Chassis ............................... 2-10
2-5 Connecting Cables and Jumpers .............................................. 2-10
Power Supply Connectors ..................................................... 2-11
PW_ON Connector................................................................... 2-13
Infrared Connector ................................................................... 2-13
Reset Header .......................................................................... 2-14
Keylock/Power LED Connector ............................................. 2-14
Hard Drive LED ....................................................................... 2-15
Speaker Connector................................................................. 2-15
AT Keyboard Connector ......................................................... 2-16
Universal Serial Bus ............................................................... 2-16
PS/2 Mouse Header ................................................................ 2-17
Serial Ports .............................................................................. 2-17
Power On/Off State ................................................................. 2-18
CMOS Clear ............................................................................. 2-18
Overheat LED .......................................................................... 2-19
Buzzer Overheat Notification ................................................. 2-19
Chassis Intrusion Connector................................................ 2-19
Wake-On-LAN .......................................................................... 2-20
Fan Connectors ...................................................................... 2-20
i960 Serial Port ....................................................................... 2-21
i960 Fail LED Indicator .......................................................... 2-21
i960 Initialization Modes ........................................................ 2-22
i960 Jumper Settings............................................................. 2-22
I2C Connector .......................................................................... 2-23
SLED (SCSI LED) Indicator................................................... 2-23
I2O Debug LED (Optional)...................................................... 2-24
AT/ATX Power Mode Jumper Settings ................................. 2-24
SCSI Termination Jumper Settings ..................................... 2-25
vi
SUPER P6DGH User’s Manual
Table of Contents
vii
SBLINK Connector .................................................................. 2-26
2-6 Installing/Removing SIMM/DIMM Modules................................. 2-27
SIMM/DIMM Module Installation............................................. 2-29
Removing DIMM Modules ...................................................... 2-29
Removing SIMM Modules....................................................... 2-29
2-7 Connecting Parallel, FDD and HDD .......................................... 2-30
Parallel Port Connector.......................................................... 2-31
Floppy Connector .................................................................... 2-32
IDE Interfaces.......................................................................... 2-33
AGP Port Interface................................................................... 2-34
ULTRA II LVD SCSI Interfaces.............................................. 2-35
Wide SCSI Interface ............................................................... 2-36
Chapter 3: Troubleshooting
3-1 Troubleshooting Procedures ........................................................ 3-1
Before Power On....................................................................... 3-1
Troubleshooting Flowchart...................................................... 3-1
No Power .................................................................................... 3-2
No Video .................................................................................... 3-2
Memory Errors ........................................................................... 3-2
Losing the System's Setup Configuration ............................ 3-7
3-2 Technical Support Procedures ..................................................... 3-3
3-3 Frequently Asked Questions......................................................... 3-4
3-4 Returning Merchandise for Service.............................................. 3-7
Chapter 4: AMIBIOS
4-1 Introduction ...................................................................................... 4-1
4-2 BIOS Features ................................................................................. 4-2
BIOS Configuration Summary Screen ................................... 4-3
AMIBIOS Setup........................................................................... 4-3
SUPER P6DGH User's Manual
viii
Chapter 5: Running Setup
5-1 Setup................................................................................................. 5-1
Standard Setup ......................................................................... 5-1
Advanced Setup ........................................................................ 5-3
Chipset Setup............................................................................ 5-7
Power Management................................................................ 5-13
PCI/PnP Setup......................................................................... 5-15
Peripheral Setup ..................................................................... 5-18
5-2 Security Setup ............................................................................... 5-21
5-3 Utility Setup .................................................................................... 5-22
Anti-Virus .................................................................................. 5-22
Language................................................................................. 5-22
5-4 Default Settings............................................................................. 5-22
Optimal Default ....................................................................... 5-22
Fail-Safe Default ..................................................................... 5-22
Appendices:
Appendix A: BIOS Error Beep Codes and Messages........................ A-1
Appendix B: AMIBIOS Post Diagnostic Error Messages ................... B-1
ix
Quick Reference Guide
Quick Reference Guide
Jumper Function Page
BZ_ON Buzzer Enable/Disable 2-18
JA5, JA6, JA7 SCSI Terminations 2-24
JB1, JB2, JB3, JB4 CPU Speed Selection 2-8
JBT1 CMOS Clear 2-17
JP11 External Bus Speed 2-8
JP20 ATX Power On/Off State 2-17
JP911 i960 Jumper 2-21
JP915 i960 Initialization Mode 2-21
JP917 i960 Jumper 2-21
JP918 i960 Reset Mode 2-21
JP919 i960 Retry Mode 2-21
JP920 i960 Disable Mode 2-21
JP921 i960 BIST Mode 2-21
JP924 i960 Jumper 2-21
Connector Function Page
AGP AGP Port 2-33
ID4 i960 Fail LED 2-20
J15, J16 IDE Interfaces 2-32
J17, J18 USB 2-15
J19 Parallel Port 2-30
J22 Floppy Connector 2-31
J36 (PWR_SEC) Secondary ATX Pwr Connector 2-11
J74 AT Keyboard 2-15
J940 I2C Connector 2-22
J943 i960 Serial Port 2-20
JF1 Hard Drive LED 2-14
JF1 Keylock/Power LED 2-13
JF1 Speaker 2-14
x
SUPER P6DGH User's Manual
JF2 IR Connector 2-12
JF2 ATX PW_ON 2-12
JF2 Reset Header 2-13
JL1 Chassis Intrusion 2-18
JOH1 Overheat LED 2-18
JP20, JP21 COM 1, COM 2 2-16
JP25 PS/2 Mouse Header 2-16
JT1, JT2 CPU1, CPU2 Fans 2-19
JT3 Thermal/Overheat Fan 2-19
PW1 Main AT Power Connector 2-10
PW2 Main ATX Power Connector 2-11
PW5 Secondary AT Pwr Connector 2-10
WOL Wake-On-LAN 2-19
Connector Function Page
Tabla de contenidos
Otros manuales de Placa madre de Supermicro
Supermicro
Supermicro X11DPFR-S(N) Manual de usuario
Supermicro
Supermicro SUPERO X10DRW-i Manual de usuario
Supermicro
Supermicro X11SCZ-F/Q Manual de usuario
Supermicro
Supermicro X7DCL-3 Manual de usuario
Supermicro
Supermicro X5DPR-TG2 Plus Manual de usuario
Supermicro
Supermicro X6DHT-G Manual de usuario
Supermicro
Supermicro SUPERO X10DRU-i+ Manual de usuario
Supermicro
Supermicro Superserver Manual de usuario
Supermicro
Supermicro A1SQN Manual de usuario
Supermicro
Supermicro Supero X9SCL-F Manual de usuario
Supermicro
Supermicro P3TDE6 Manual de usuario
Supermicro
Supermicro Supero H8SME-F Manual de usuario
Supermicro
Supermicro PDSMi Plus Manual de usuario
Supermicro
Supermicro X12SCV-W Manual de usuario
Supermicro
Supermicro X11 Manual de usuario
Supermicro
Supermicro SUPER P4SAA Manual de usuario
Supermicro
Supermicro SUPER X5DPL-8GM Manual de usuario
Supermicro
Supermicro A2SDi-4C-HLN4F Manual de usuario
Supermicro
Supermicro H12DGO-6 Manual de usuario
Supermicro
Supermicro X10DAL-i Manual de usuario
Manuales populares de Placa madre de otras marcas
Telit Wireless Solutions
Telit Wireless Solutions SL869-3DR Manual de usuario
Gigabyte
Gigabyte GA-9IVDT Manual de usuario
Texas Instruments
Texas Instruments ADS8372EVM Manual de usuario
Commell
Commell MS-C73 Manual de usuario
IBT Technologies
IBT Technologies MB860 Manual de usuario
Nvidia
Nvidia TEGRA DG-04927-001_V01 Manual de usuario
