Supermicro 440LX Manual de usuario

SUPER

440LX Chipset

AMI BIOS

REFERENCE MANUAL

Revision 1.1

The information in this User’s Manual has been carefully reviewed and is believed to be

accurate. The vendor assumes no responsibility for any inaccuracies that may be

contained in this document, makes no commitment to update or to keep current the

information in this manual, or to notify any person or organization of the updates.

The manufacturer reserves the right to make changes to the product described in this

manual at any time and without notice. This product, including software, if any, and

documentation may not, in whole or in part, be copied, photocopied, reproduced, translated

or reduced to any medium or machine without prior written consent.

IN NO EVENT WILL THE MANUFACTURER BE LIABLE FOR DIRECT, INDIRECT,

SPECIAL, INCIDENTAL, OR CONSEQUENTIAL DAMAGES ARISING FROM THE USE OR

INABILITY TO USE THIS PRODUCT OR DOCUMENTATION, EVEN IF ADVISED OF THE

POSSIBILITY OF SUCH DAMAGES. IN PARTICULAR, THE VENDOR SHALL NOT HAVE

LIABILITY FOR ANY HARDWARE, SOFTWARE, OR DATA STORED OR USED WITH THE

PRODUCT, INCLUDING THE COSTS OF THE REPAIRING, REPLACING, OR

RECOVERING SUCH HARDWARE, SOFTWARE, OR DATA.

Printed in the United States of America.

Unless you request and receive written permission from the manufacturer, you may not

copy any part of this document.

All products and company names mentioned are trademarks or registered trademarks of

their respective holders.

Do not upgrade the BIOS unless you are notified to do so. Please call technical

support first before upgrading the boot-block BIOS.

SUPER BBS # (408) 895-2022 (24 hours)

Baud Rate: 1200-14400 bps, Data Bits: 8, Stop Bit: 1, Parity: None

Table of Contents

Chapter 1: AMI BIOS

1-1 Introduction

System BIOS ....................................................................................... 1-1

Configuration Data............................................................................. 1-1

How Data Is Configured................................................................... 1-1

POST Memory Test ............................................................................ 1-1

1-2 BIOS Features...................................................................................... 1-2

BIOS Configuration Summary Screen ........................................... 1-3

AMIBIOS Setup ..................................................................................... 1-3

Chapter 2: Running Setup

2-1 Setup

2-1-1 Standard Setup.................................................................. 2-1

2-1-2 Advanced Setup................................................................. 2-4

2-1-3 Chipset Setup .................................................................... 2-7

2-1-4 Power Management........................................................ 2-13

2-1-5 PCI/PnP Setup ................................................................. 2-15

2-1-6 Peripheral Setup ............................................................. 2-18

2-2 Security Setup

2-2-1 Supervisor/User................................................................ 2-20

2-2-2 Anti-Virus ........................................................................... 2-21

2-3 Utility Setup

2-3-1 Language........................................................................... 2-21

2-3-2 Detect IDE.......................................................................... 2-21

2-4 Default Setting

2-4-1 Optimal Default................................................................. 2-22

2-4-2 Fail-Safe Default............................................................... 2-22

BIOS User's Manual

iii

Table of Contents

Appendix A: BIOS Error Beep Codes...................... A-1

Appendix B: AMI BIOS POST Diagnostic Error

Messages........................................... B-1

PRINTED IN U.S.A.

Chapter 1: AMI BIOS

1-1

Chapter 1

AMI BIOS

1-1 Introduction

This chapter describes the AMIBIOS for the Intel 440FX/440LX

chipset which is designed for Intel Pentium® Pro 150/166/180/200

MHz and Pentium II 233/266/300 MHz processors. The AMI ROM

BIOS is stored in the Flash EEPROM and is easily upgraded

using a floppy disk-based program.

System BIOS

The BIOS is the basic input output system used in all IBM®PC,

XT™, AT®, and PS/2®compatible computers. The WinBIOS is a

high-quality example of a system BIOS.

Configuration Data

AT-compatible systems, also called ISA (Industry Standard Archi-

tecture) must have a place to store system information when the

computer is turned off. The original IBM AT had 64 bytes of non-

volatile memory storage in CMOS RAM. All AT-compatible sys-

tems have at least 64 bytes of CMOS RAM, which is usually part

of the Real Time Clock. Many systems have 128 bytes of CMOS

RAM.

How Data Is Configured

AMIBIOS provides a Setup utility in ROM that is accessed by

pressing <Del> at the appropriate time during system boot. Setup

configures data in CMOS RAM.

POST Memory Test

Normally, the only visible POST routine is the memory test. The

screen that appears when the system is powered on is shown on

the next page.

An AMIBIOS Identification string is displayed at the left bottom

corner of the screen, below the copyright message.

BIOS User's Manual

1-2

Made in U.S.A. Mainboard Rev 1.3

BIOS Release 120497

xxxxx KB OK

Hit <DEL> if you want to run SETUP

XX-XXXX-XXXXXX-XXXXXXXX-XXXXXX-XXXX-X

1-2 BIOS Features

•supports Plug and Play V1.0A and DMI 2.0

•supports Intel PCI 2.1 (Peripheral Component Interconnect)

local bus specification

•supports EDO (Extended Data Out), ECC and FPM DRAM

•supports ECC (Error Checking and Correction)

•supports Flash ROM

AMIBIOS supports the LS120 drive made by Matsushita-Kotobuki

Electronics Industries Ltd. The LS120:

•can be used as a boot device

•is accessible as the next available floppy drive

AMIBIOS supports the National Semiconductor LM75 and LM78

data acquisition chips. When a failure occurs in a monitored

activity, AMIBIOS can sound an alarm and display a message.

The LM75 and LM78 chips monitor:

•CPU temperature

•additional temperature sensors

Chapter 1: AMI BIOS

1-3

•chassis intrusion detector input

•watchdog comparison of all monitored values

•POST code storage RAM

•ISA and I2C serial bus interfaces

•up to five positive voltage inputs

•up to two negative voltage inputs

•up to three fan speed monitoring inputs

BIOS Configuration Summary Screen

AMIBIOS displays a screen that looks similar to the following

when the POST routines complete successfully.

Main Processor : Pentium(tm) II Base Memory Size : 640 KB

Math Processor : Built-In Ext. Memory Size : 31744 KB

Floppy Drive A: : 1.2 MB, 5¼ Display Type : VGA/EGA

Floppy Drive B: : 1.44 MB, 3½ Serial Port(s) : 3F8,2F8

AMI-BIOS Date : 7/15/95 Parallel Port(s) : 378

Processor Clock : 200MHz Power Management : APM, SMI

AMIBIOS Setup

See the following page for examples of the AMIBIOS Setup

screen, featuring options and settings. Figure 1-1 shows the

Standard option highlighted. To highlight other options, use the

arrow keys, or use the tab key to move to other option boxes.

Figure 1-2 shows the settings for the Standard setup. Settings

can be viewed by highlighting a desired option and pressing

<Enter>. Use the arrow keys to choose a setting. Note: Optimal

settings for all options can be set automatically. Go to the

Optimal icon in the default box and press <Enter>. Use the

arrow keys to highlight yes, then press <Enter>.

BIOS User's Manual

1-4

Figure 1-1. Standard Option Highlighted

Figure 1-2. Settings for Standard Option

Chapter 2: Running Setup

2-1

Chapter 2

Running Setup*

*Optimal and Fail-Safe default settings are bolded in text unless

otherwise noted.

The WinBIOS Setup options described in this section are selected

by choosing the appropriate high-level icon from the Standard Setup

screen. All displayed icons are described in this section, although

the screen display is often all you need to understand how to set

the option.

2-1 Setup

2-1-1 Standard Setup

Pri Master

Pri Slave

Sec Master

Sec Slave

Choose these icons to configure the hard disk drive. When you

click on an icon, the following parameters are listed: Type, LBA/

Large Mode, Block Mode, 32Bit Mode, and PIO Mode. All param-

eters relate to IDE drives except Type.

If the hard disk drive to be configured is an IDE drive, select the

appropriate drive icon, choose the Type parameter and select

Auto. The BIOS will automatically detect the IDE drive parameters

and display them. Click on the OK button to accept these param-

eters.

Click on LBA/Large Mode and choose On to enable support for

IDE drives with capacities greater than 528MB. Click on Block

Mode and choose On to support IDE drives that use Block Mode.

Click on 32Bit Mode and click on On to support IDE drives that

permit 32-bit accesses.

To configure an old MFM hard disk drive, you must know the drive

parameters (number of heads, number of cylinders, number of

sectors, the starting write precompensation cylinder, and drive

capacity). Select the hard disk drive type (1-46). Refer to table

below.

Tabla de contenidos

Otros manuales de Placa madre de Supermicro

Supermicro

Supermicro H12DGO-6 Manual de usuario

Supermicro

Supermicro X9DRW-3F Manual de usuario

Supermicro

Supermicro X11DPU Manual de usuario

Supermicro

Supermicro X11SRM-F Manual de usuario

Supermicro

Supermicro X11 UP Manual de usuario

Supermicro

Supermicro X12 Series Guía rápida

Supermicro

Supermicro AOC-B25G-6X4D/X4D Manual de usuario

Supermicro

Supermicro X8DTU-LN4F+ Manual de usuario

Supermicro

Supermicro P4SCA Manual de usuario

Supermicro

Supermicro B1SD2-TF Manual de usuario

Supermicro

Supermicro X11SCQ-L Manual de usuario

Supermicro

Supermicro C7Z270-CG-L Manual de usuario

Supermicro

Supermicro H8DCR-3 Manual de usuario

Supermicro

Supermicro X10DRG-Q Manual de usuario

Supermicro

Supermicro X6DHR-8G2 Manual de usuario

Supermicro

Supermicro X7DB8 Plus Manual de usuario

Supermicro

Supermicro X6DH8-G2 Manual de usuario

Supermicro

Supermicro X10SRG-F Manual de usuario

Supermicro

Supermicro X10SDV Manual de usuario

Supermicro

Supermicro X10DSN-TS Manual de usuario

Supermicro

Supermicro X11DGO-T Manual de usuario

Supermicro

Supermicro X11SSQ Manual de usuario

Supermicro

Supermicro X11SDW-4C-TP13F Manual de usuario

Supermicro

Supermicro X12DPL-i6 Manual de usuario

Manuales populares de Placa madre de otras marcas

DFI

DFI SD170 Manual de usuario

ASROCK

ASROCK ROMED8-2T Manual de usuario

Asus

Asus P2L97A Manual de usuario

Winmate

Winmate IC70 Manual de usuario

Asus

Asus MES-B Manual de usuario

Grantech

Grantech SYS8F377VGGA-3OMN Manual de usuario

Telit Wireless Solutions

Telit Wireless Solutions SL869-3DR Manual de usuario

Gigabyte

Gigabyte GA-9IVDT Manual de usuario

Texas Instruments

Texas Instruments ADS8372EVM Manual de usuario

Commell

Commell MS-C73 Manual de usuario

IBT Technologies

IBT Technologies MB860 Manual de usuario

Nvidia

Nvidia TEGRA DG-04927-001_V01 Manual de usuario

Biostar

Biostar M7VIT Bravo Instrucciones de funcionamiento e instalación

Intel

Intel D33217CK Manual de usuario

Asus

Asus F1A55-M LX PLUS R2.0 Manual de usuario

EPC

EPC EPC9147C Manual de usuario

Asus

Asus EX-B760M-V5 D4 Manual de usuario

EPOX

EPOX MU-8KHA0010 Manual de usuario